MOVON MF360 User Manual

BT229 Bluetooth® Headset User’s Guide

Also in this package:

AC (indoor) power adapter

Questions? Problems? Get help on the web at www.uniden.com

or call our Customer Service line at 800-292-2294.

Extra ear cushion

Getting to Know the Headset

What the buttons do

Button Action

Quick Press (1 Beep) Last number redial Answer Call Close Call

Multifunction
(MFB)

Volume UP (+)

Volume DOWN (-)

2 seconds (2 Beeps) Initiate Voice Dialing Reject Call

4 Seconds (3 Beeps) Turn Headset OFF Turn Headset OFF Turn Headset OFF
Quick Press (1 Beep) Increase Volume Increase Volume Increase Volume
2 Seconds (2 Beeps) - - ­4 Seconds (3 Beeps) - - Hold/Resume Call
Quick Press (1 Beep) Decrease Volume Decrease Volume Decrease Volume
2 Seconds (2 Beeps) - - Microphone Mute
4 Seconds (3 Beeps) - - Close/Resume Call

Standby (No Calls Active) Incoming Call 1 Call Active

Note: The headset initiates the function only after the button is released.

* Specications and features are subject to change without notice.

2

HEADSET STATUS

Transfer Active Call to/
from Phone

What the LED colors mean

Color State Meaning

Red

Blue

Red & blue Alternating ash The headset is in pairing mode.

Steady The headset is currently charging. When the battery is fully charged, the LED turns o.
Flashing The headset is turned o. If the headset is also beeping, the battery is low.
Flashing The headset is turned on.
One ash
every 5 seconds
Two ash
every 5 seconds

The headset is in standby and not paired to a Bluetooth device.

The headset is currently paired to a Bluetooth device.

3

Setting Up Your Headset

Charge the battery

Before using your headset, charge the battery for at least 8 hours. Charging the battery
completely (and keeping it charged) will help you get the longest possible talk and standby
time out of the battery.

Connect the adapter to the Power connector on the top of the headset, then plug it into
any standard 120 V AC (regular indoor) AC outlet.

Make sure that your headset is fully charged before you start using it. When your headset is
charged, the red light is solid.

When the battery needs to be recharged, you will hear warning beeps every 20 seconds
and see the red light (depending on your headset status).

Use ONLY the AC adapter supplied with the headset! Using any other adapter could
damage your headset, create a re hazard, or cause a risk of electric shock!

4

Pair the headset to your Bluetooth phone

Pairing is like “introducing” two Bluetooth devices and giving them permission to connect
to each other. If you want to use the headset with more than one phone, you need to pair
it with each phone separately. Once you pair a phone to the headset, the two devices can
connect automatically whenever they can detect each other.

Before you can use your headset, you must pair it with a Bluetooth-enabled device (such as
Bluetooth mobile phone).

1: Make sure the headset is powered o and the power adapter is not connected (you
can’t use the headset while it’s charging).
2: Press and hold MFB until the LED ashes alternating red and blue (approximately 6

seconds), then release. The headset is in pairing mode and should be visible to other
Bluetooth devices.

3: Set your Bluetooth phone into discover mode. (Check the manual that came with your

phone for instructions.)

4: When your phone asks if you want to pair with the headset, conrm this by pressing “yes”

or “ok”.

5: When the phone asks for a passkey or PIN, enter 0000 (4 zeros).

5