Mountain Off Road BLTJ97SBK User Manual

MOUNTAIN OFF ROAD ENTERPRISES, LLC.

P.O. BOX 690, DELTA, COLORADO 81416

970-625-0500 970-625-3747 Fax

E-mail: [e-mail]

www.mountainoffroad.com

INSTRUCTIONS for M.O.R.E.™ BLTJ97SBK

Quantity: Description: PN#: Location
1 Raised Pillow Mount Bracket #BLTJ97PBB Steering Pillow Block, Figure 1

The factory steering guide bracket needs to be raised when installing a 1” Body lift . M.O.R.E.™ Has a new

raised bracket that will do just this. The guide bracket is located in the engine compartment, between the
steering column and the steering box. Remove the bolt that attaches the upper u-joint to the intermediate
shaft, See Figure 2. Remove the bolts that attach the OEM bracket to the frame and steering shaft bearing
and remove the bracket. Bolt the M.O.R.E.™ Raised bracket to the frame re-using the factory bolts. Re-
attach the steering shaft pillow block to the new bracket using the factory nuts. See figures 3 & 4. Reattach
the steering shafts that were separated using the factory bolt. GO JEEPIN!

Figure 1 Figure 2

Figure 3

Figure 4

Page 1 of 2

TERMS-POLICIES:

FIT and TOLERANCES: These Motor Mounts are the results of countless hours of research, testing, fitting and refining.

Jeep® frames have a wide tolerance on bolt hole centers from frame to frame. This is why M.O.R.E.™ has installed “slots” in
which to mount them. In addition to the factory tolerances, most people install other then factory equipment such as suspen­sion lift kits, skid plates, different transfer cases etc. M.O.R.E.™ has done the best job we can to insure that our parts fit with
all of the possibilities. However, you may find it necessary to grind, elongate, bend, or force these parts to fit on your rig.
Please use common sense when installing these parts and let us know how we can improve them.

DAMAGE CLAIMS: All orders are carefully packed, however, mishandling by the carrier can result in damage. The carrier has
the responsibility for the shipment from the time it leaves our warehouse until it is delivered to you. All claims for lost or dam­aged goods should be reported to the carrier, not to M.O.R.E.™ LLC.

RETURNS: No returns will be accepted without prior permission from M.O.R.E.™ LLC. After you receive a Return Goods Au-
thorization (RGA) number, merchandise must be returned prepaid and insured. A claim must be made with in 30 days from
receipt of merchandise. The original invoice or a copy with the RGA number written on must accompany all returns. A 20%
restocking fee will be charged on all parts returned for credit or refund unless merchandise is proven to be defective or was
shipped wrong by M.O.R.E.™ LLC. No merchandise will be issued credit or refund if it has been installed, modified, used in
any way or is in unsalable condition.

WARRANTY: All merchandise is warranted to be free from defects in materials and workmanship prior to installation. Any
alteration or improper use will void this warranty. Because all parts we sell are intended for use in heavy-duty applications it is
not possible to warrantee or guarantee the performance of any items. M.O.R.E.™ LLC. products and the products manufac­tured by others, which we sell may be subject to an infinite variety of conditions due to the manner in which they are used,
serviced and/or installed. Purchasers and users of such products rely upon their own judgment as to the suitable use selec­tion, service and installation of such products.

PRODUCT DISCLAIMER: Modification of your vehicle to enhance performance with parts sold by M.O.R.E.™ LLC. may cre-
ate a dangerous condition which could cause serious bodily injury, and the buyer hereby expressly assumes all risks associ­ated with any such modifications. All parts sold by M.O.R.E.™ LLC. are for racing or off road use only. Mountain Off Road
Enterprises LLC. will not accept responsibility for personal injury or property damage arising from the failure of any parts
manufactured or sold by M.O.R.E.™ LLC.

Specifications are subject to change without notice.

Jeep®, AMC®, CJ®, YJ®, TJ®, LJ®, Wrangler®, are registered trademarks of DaimlerChrysler. M.O.R.E.™ is not affiliated

with DaimlerChrysler.

M.0.R.E™, BombProof™, S.R.S.™, SlipLoc™, DoubleJointed™, RockProof™, are trademarks used by Mountain Off
Road Enterprises, LLC. These instructions and the M.O.R.E.™ logo are copyright©, 1999-2009.

Page 2 of 2