Motorola 9501 User Manual

Reading Messages

When you receive a new message, use the 9501’s One-Button feature to read the entire message by repeatedly pressing Z.

Setting the Pager Alarm

1.From the main menu, press X or Y to move to H(settings).

2.Press Z and use X or Yto move to

(set alarm).

3.Press Zto enter “Settings” mode.

4.Press W or V to choose either “Enabled Daily”, “Enabled Onetime”, or “Disabled”.

5.Press Xor Yto move to the hour digit and press W or V to set the hour you want for the alarm.

6.Press Xor Yto move to each entry selection (minute, AM/PM, day, month, year) and press W or V to set each ﬁeld.

7.Press Zto save your settings.

t, Motorola are registered trademarks of Motorola, Inc.

Satellite Series 9501 Pager

Quick Reference Card

Main Menu Icons

G Message Envelope ? Message Envelope (5 unread) F Information Folder J Information Folder (unread) E Personal Folder I PhoneBook H Time Alert Settings

1 P ower On/Off

R Quiet Time Enabled T Audible Alert Enabled S Alarm Enabled 4 Home Time 5 T rav el Time

Control Buttons

XY Move Left/Right Z Select

WV Move Up/Down [ Escape

Pager Icons

/ Alarm Enabled 0 Alarm Disabled , Quiet Time

- Quiet Time Disabled

D View Message 3 Return to Previous Screen > Add to Folder 8 Add to PhoneBook = Receive PhoneBook O Battery Full Indicator N Battery 2/3 Full Indicator M Battery 1/3 Full Indicator L Battery Low Indicator 6C Signal Strength Strong 6B Signal Strength Moderate 6A Signal Strength Low 6 No Signal, Out of Range

2 Set to Vibrate

& Set Audible Alerts . Set Alarm % Set Alert to Silent * View Ne xt Message 9 Delete Message

\ Message Read

() Scroll Up and Down ] Truncated Message

Wearing Your Pager

Your 9501 pager comes with a multifunctional holster that orients the pager for the best possible performance. It is recommended that you place the pager in the holster (display side facing in) and wear it on your belt. The holster can also be used effectively off the body as a stand for your pager . To ensure optimum reception, extend the belt clip, stand it up on a desk or table, and point it toward the nearest window.

Note:

Improper positioning of the 9501 pager will impair message reception.

Checking Satellite Strength

Note:

Availability of the satellite feature described herein may vary, depending on the region of the world that you are in and the type of service provided.

It is possible that you may ha v e difﬁculty receiving messages in the interior of large urban buildings. When you arrive in an unfamiliar ofﬁce, hotel room, or meeting room,

you may want to chec k the pager’ s ability to receive messages in that location.To determine the likelihood of receiving messages in a given environment, perform the following steps:

1.Position the pager correctly .

2.Press and hold [for 2 seconds. The LED blinks yellow while the pager is looking for the nearest satellite.

3.It can take up to 26 seconds to locate the nearest satellite. Upon completion your pager alerts with a single chirp. The LED will be either green (in range), or red (out of range).

If you press any button during the test, the test will be cancelled.

4.When complete, remove the pager from the holster to view the display.

5.If your signal strength indicator shows you are out-of-range (antenna with no strength bars), or weak (antenna with 1 or 2 strength bars), move to an outer part of the building or room with a window , where you may obtain better reception results.