Motorola 92FT7000 User Manual

Applicant: Motorola, Inc. FCC ID:AZ492FT7000

VIII. Instruction Manual

1.) Quick Reference Card HDT 400 Series
2.) Safety Warnings - Handheld Data Terminal, HDT Family Safe and Efficient Operation of Motorola Two Way Radio Products
Exhibit 8
P
A
d
(see figure below)
No light - Not in use
Red light - Battery charging (8 hours for full
capacity)
Green light - Battery fully charged
HDT 401
Hand-held Data Terminal
with Local Area Network Radio Modem
And LASER Barcode Scanner
Quick Reference Card
Important Note
Battery is considered damaged when charging takes
more than 8 hours. Contact service to replace battery.
Office Dock
Data Communication With Host
(see figure above) Communication between the HDT 401 and the host
computer can be established when the HDT 401 rests in the Office Dock. When data flows from the HDT 401 to the host computer, the Data Out yellow LED lights.
When data flows from the host computer to the HDT 401, the Data In yellow LED lights.
HDT 401 Holster
Approved Accessories
FNN6001B: Battery – Lithium Ion 3.6V 1450mAH.
FLN9202A: Belt Holster – full size with pocket.
FLN9623A: Belt Holster – slipper.
FLN9438A: Stylus pen.
FKN4886A: Serial cable (1m) standard EIA
RS232 DB9.
FKN4871A: Serial cable (1m) coiled for Camero printer DIN8.
FKN4792A: Serial cable (20cm) DB25 with negative supply pin.
FKN4793A: Serial cable (1m) DB25 with power pins.
Keypad
Infrared communication
perture
!
C a u t i o n
Important Care Instructions: Use a soft damp cloth to clean the
infrared communication aperture and laser window.
BatteryPack
(Do not remove)
CAUTION
To avoid possible eye injury, do not stare
irectly at the laser beam of the scanner.
Screen
Laser Scanner
Indication Light
Buzzer
ower On/Off
Button
Switching On
Press the Power On/Off button for more than 2 seconds. The Power Indication Light will illuminate, indicating that the battery is O.K. and the device is operative.
Switching Off
Press the Power On/Off button for more than 2 seconds and release. The Power Indication Light will turn off.

Front Panel

J
J
A
c
J
The HDT 401 Keys are assigned to operate according to the specific usage of the device. However, the items shown below refer to basic operations available in all HDT 401 configurations.
Indication Light
(Operation is defined by configuration)
Screen
Navigation Keys
Screen Light
(When pressed with Shift key, contrast level increases cyclically).
IMPORTANT: To save battery power, use Screen Light only when needed.

Setting the Office Dock

Local Computer Control
A local computer configuration enables a cascade connection of up to 3 1 Office Dock units (155 HDT 401 devices) to one RS-485 port in the host computer. For connections, see figure below.
J4
J3
Remote Computer Control
A remote computer control configuration enables a cascade connection of up to 3 Office Dock units (15 HDT 401 devices) to the host computer. A Line Modem is used for communication with remote located host computer. For connections, see figure below.
C Power Outlet
J1
J2
2
1
RS-232
To
Phone
Line
Barcode Scanner
RS-485
ables
Keys (for left-hand
and right-hand users)
Space Key
(Operation is defined by configuration)
Host Computer
RS-485 to RS-232 Converter
Shift Key
4
J3
To more Office Dock Units
To Third Office Dock Unit
and Motorola are registered trademarks of Motorola Inc.
© Motorola Inc., 2000 68P02959C84-A
@6802959C84@
Line Modem
(28.8 or 33.6kb/s)
EME Warnings A5 landscapeHTD400 Page 1 Wednesday, October 11, 2000 5:33 PM
To assure optimal radio product performance and to make sure human expo-
HANDHELD DATA TERMINAL
HDT Family
Safe and Efficient Operation of Motorola Two Way Radio Products
RF OPERATIONAL CHARACTERISTICS
Your radio contains a transmitter which transmits using very short bursts of data;a receiver which receives radio frequency (RF); and an internal antenna.
EXPOSURE TO RADIO FREQUENCY ENERGY
Your Motorola radio product is designed to comply with the following national and international standards and guidelines regarding exposure of human be­ings to radio frequency electromagnetic energy:
United States Federal Communications Commission,
Code of Federal Regulations; 47 CFR part 2 sub-part J
American National Standards Institute (ANSI) / Institute of Electrical and Electronic Engineers (IEEE) C 95. 1-1992
Institute of Electrical and Electronic Engineers (IEEE),
C95.1-1999 Edition
National Council on Radiation Protection and Measurements (NCRP) of the United States,
Report 86, 1986
International Commission on Non-Ionizing Radiation Protection (ICNIRP (1998)
National Radiological Protection Board of the United Kingdom, (1995)
Ministry of Health (Canada) Safety Code 6. Limits of Human Exposure to Radiofrequency Electromagnetic Fields in the Frequency Range from 3 kHz to 300 GHz, 1999
Australian Communications Authority Radiocommunications (Electro­magnetic Radiation - Human Exposure) Standard 1999 (applicable to wireless phones only).
sure to radio frequency electromagnetic energy is within the guidelines set forth in the above standards, always adhere to the following procedures:
PORTABLE RADIO PRODUCT OPERATION & EME EXPOSURE
BODY-WORN OPERATION
To maintain compliance with FCC RF exposure guidelines, if you wear a radio product on your body when transmitting, always place the radio product in a Motorola supplied or approved clip, holder, holster, case, or body harness. Use of non-Motorola-approved accessories may exceed FCC RF exposure guidelines. If you do not use a body-worn accessory, and are not using the radio product held in the normal use position, ensure the radio product is at least one inch (2.5 cms) from your body when transmitting .
APPROVED ACCESSORIES
For a list of approved Motorola accessories, please contact the local autho­rized Motorola dealer.
ELECTROMAGNETIC INTERFERENCE / COMPATIBILITY
NOTE : Nearly every electronic device is susceptible to electromagnetic inter-
ference (EMI) if inadequately shielded, designed or otherwise configured for electromagnetic compatibility
FACILITIES
To avoid electromagnetic interference and/or compatibility conflicts, turn off your radio product in any facility where posted notices instruct you to do so. Hospitals or health care facilities may be using equipment that is sensitive to external RF energy .
AIRCRAFT
When instructed to do so, turn off your radio product when on board an air­craft. Any use of a radio product must be in accordance with airline regula­tions or airline crew instructions.
68P02960C25-O Safety Warnings
Please retain for future use
1.
1.
EME Warnings A5 landscapeHTD400 Page 2 Wednesday, October 11, 2000 5:33 PM
MEDICAL DEVICES Pacemakers
The Health Industry Manufacturers Association recommends that a minimum separation of 6 inches (15 centimeters) be maintained between a handheld wireless radio product and a pacemaker.These recommendations are con­sistent with the independent research by, and recommendations of, Wireless Technology Research.
Persons with pacemakers should:
ALWAYS keep the radio product more than six inches (15 centimeters) from their pacemaker when the radio product is turned ON .
2. Not to carry the radio product in the breast pocket.
3. Use the radio product away from the pacemaker to minimize the poten­tial for interference.
4. Turn the radio product OFF immediately if you have any reason to sus­pect that interference is taking place.
Hearing Aids
Some digital wireless radio products may interfere with some hearing aids. In the event of such interferences you may want to consult your hearing aid manufacturer to discuss alternatives.
Other Medical Devices
If you use any other personal medical device, consult the manufacturer of your device to determine if it is adequately shielded from RF energy.Your physician may be able to assist you in obtaining this information.
Safety and General
Use While Driving
Check the laws and regulations on the use of radio products in the area where you drive. Always obey them.
When using your radio product while driving, please:
Give full attention to driving and to the road.
2. Use hands-free operation, if available.
3. Pull off the road and park before making or answering a call if driving conditions so require.
!
!
W A R N I N G
Do not place a radio prod uct in the area over an air bag or in the air bag
deployment area. Air bags inflate with great force. If a portable radio product is placed in the air bag deployment area and the air bag inflates, the radio product may be propelled with great force and cause serious injury to occu­pants of the vehicle.
POTENTIALLY EXPLOSIVE ATMOSPHERES
Turn off your two way radio product prior to entering any area with a poten­tially explosive atmosphere, unless it is a radio product type especially qual­ified for use in such areas as “Intrinsically Safe” (for example, Factory Mutual, CSA, or UL Approved). Do not remove, install, or charge batteries in such areas. Sparks in a potentially explosive atmosphere can cause an explosion or fire resulting in bodily injury or even death.
NOTE: The areas with potentially explosive atmospheres referred to above include fueling
areas such as; below decks on boats, fuel or chemical transfer or storage facilities, areas where the air contains chemicals or particles such as grain, dust, or metal powders;and any other area where you would normally be advised to turn off your vehicle engine. Areas with potentially explosive atmospheres are often but not always posted.
BLASTING CAPS AND AREAS
To avoid possible interference with blasting operations, turn off your radio product when you are near electrical blasting caps, in a "blasting area", or in areas posted: "turn off two-way radio." Obey all signs and instructions.
!
C a u t i o n
All batteries can cause property damage and/or bodily injury such as burns if a conductive material such as jewelry, keys, or beaded chains touch exposed terminals. The conductive material may complete an electrical circuit (short circuit) and become quite hot. Exercise care in handling any charged battery, particularly when placing it inside a pocket, purse, or other container with metal objects.
OPERA TIONAL WARNINGS FOR VEHICLES WITH AIR BAG
OPERATIONAL CAUTIONS BATTERIES
Loading...