Mossloo XJ0820 User Manual

High Sierra Kodika IPX7
Outdoor Speaker

Instruction Manual

XJ0820(8053-08)

4.

3.

2.

1.

1.

Micro-USB Input

2.

Vol +/Next Track

3.

Power ON/OFF

4.

Vol-/Previous Track

5.

Bluetooth LED indicator

6.

Red LED

7.

Green LED

8.

Wireless charging receiver

What’s included:

1 x Bluetooth Speaker (8053-08)
1 x USB to Micro-USB Charging Cable
1 x Instruction Manual

•

Playing time: up to12hrs at max volume

•

Charging time: up to 8hrs

•

Pairing Name: "High Sierra IPX7"

•

Capacity: 5000mAh

•

Micro-USB Input: DC 5V/1000mA

•

Wireless Charging Input: 5V/1A(5W)

7.

6.

5.

Instructions:

Be sure to fully charge the speaker before
using for the first time.

1.

Charging the Speaker

•

Connect the provided charging cable to a
power source and to the Micro USB port 1

8.

on the speaker. or To wirelessly charge
the speaker, place the wireless charging
input surface(8) onto a wireless charging
pad.

•

Red LED light when charging the speaker
and light turn to Green when the speaker
is fully charged,Red/Green LED will turn off
once speaker unplugged or remove it from
a wireless charging pad.

Remove the USB cable from your mobile

•
device when it is fully charged.

®

Setup:2.

Bluetooth

Press and hold Speaker ON/OFF Button(3)

•
to turn ON the speaker, Bluetooth LED
indicator(5) will flash BLUE.
Turn on the Bluetooth function on

•
mobile device, Select “High Sierra IPX7
pairing name. LED will turn solid BLUE if
successfully paired.

Speaker will automatically pair if the mobile

•

device has been paired before.

Press and hold Speaker ON/OFF Button(3)

•
to turn off the device

Using the Speaker

3.

When receiving a phone call, press ON/OFF

•
button to answer and again to hang up.
Double press to redial the last call.

•

“Vol+/Next track”:

•

Long press - next track.
Short press - increase volume.
“Vol-/Previous track”:

•

Long press - previous track
Short press - reduce volume

.

SAFETY PRECAUTIONS:

WARNING-When using this product, basic

•
precautions should always be followed:
Read all the instructions before use.

1.
Never store or use this product in

2.
temperatures below 32°F(0°C) or above
115°F(45°C).
Do not overcharge Phone. Unit may get

3.
hot with excessive use. Remove Phone
when it is fully charged. Never charge for
more than 7 hours at a time.
The unit’s full performance is achieved

4.
only after 2 or 3 completed charge and
discharge cycles.
To reduce the risk of injury, close

5.
supervision is necessary when the product
is used near children.
Do not expose the device to moisture.

6.
Do not use the device in excess of its

7.
output rating. Overload outputs above

8.

Do not use the device if damaged or

9.

explosion or risk of injury.

10.

Do not disassemble the device. For

professional. Incorrect reassembly may

11.

or temperatures above 104°F may cause
explosion.

12.
use only identical replacement parts to
ensure product safety
Attachments on the back of your phone

13.
can impede the effectiveness of the
wireless charger, and lead to overheating.
Please remove attachments from the phone
before charging on this device.

FCC WARNING
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Any changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.However, there is
no guarantee that interference will not occur in a
particular installation.If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and
receiver.

-- Connect the equipment into an outlet on a circuit
different
from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV
technician for help.
To maintain compliance with FCC’s RF Exposure
guidelines,
This equipment should be installed and operated with
minimum 20cm distance between the radiator your body:
Use only the supplied antenna

MADE IN CHINA