Mossloo MSL W26Q User Manual

Wireless Chargind Pad
with stand

Instruction Manual

MSL-W26Q (SM-2818)

12

4

Features:

1.

Charging Pad Surface

2.

LED Indicator

3.

Micro-USB Input Port

4. Stand

What’s included:

1 x Wireless Charging Pad
1 x USB to Micro-USB Cable
1 x Instruction Manual

Input power: 5V/1.5A

•
Output power: 5V/1A

•

INSTRUCTIONS:

1.

Charging Mobile Devices:

a.

Ensure that your phone or tablet supports
wireless charging. It will be listed in the

the last page of this manual).

b.

Connect the wireless charging pad to a
USB adapter with the provided cable. Once
connected LED Indicator will glow RED.

c.

Place the enabled device on the surface
of the wireless charging pad on the Stand.
The LED will turn GREEN to indicate that
the phone is charging.

*

Note: To charge devices, use only the
accessory cable or the cable included with
your own device by the manufacturer.

SAFETY PRECAUTIONS:

Read all the instructions before using the
product.

Do not use on an aircraft or in a hospital.

1.
To reduce the risk of injury, close

3

2.
supervision is necessary when the product
is used near children.
Do not expose the device to any moisture.

3.
Do not use the device in excess of its

4.
output rating. Overloaded outputs above

Do not use the device if damaged or

5.

8.
repair person using only identical
replacement parts. This will ensure that
the safety of the product is maintained.
This device is not a toy.

9.
Do not overcharge Phone. Unit may get

10.
hot with excessive use. Remove Phone
when it is fully charged. Never charge for
more than 7 hours at a time.

.

11

Attachments on the back of your phone
can impede the effectiveness of the
wireless charger, and lead to overheating.
Please remove attachments from the phone
before charging on this device.

***KEEP OUT OF REACH OF CHILDREN***

FCC WARNING

This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
inaccordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception,which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following
measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment
should be installed and operated with minimum 20cm distance between the
radiator your body: Use only the supplied antenna

exhibit unpredictable behavior resulting in

Do not disassemble the device. Take it to

6.

or repair is required. Incorrect reassembly

7.
excessive temperature. Exposure to
extreme heat may cause explosion.

MADE IN CHINA