Morphy Richards NO MODEL NO NUMBER, IBION, Ion iron Instructions Manual

Your two year guarantee

It is important to retain the retailers receipt
as proof of purchase. Staple your receipt to
this back cover for future reference.

Please quote the following information if
the product develops a fault. These numbers
can be found on the base of the product.

Model no. Serial no.

All Morphy Richards products are
individually tested before leaving the factory.
In the unlikely event of any appliance proving
to be faulty within 28 days of purchase it
should be returned to the place of purchase
for it to be replaced.

If the fault develops after 28 days and
within 24 months of original purchase, you
should contact the Helpline number quoting
Model number and Serial number on the
product, or write to Morphy Richards at the
address shown. You will be asked to return
the product (in secure, adequate packaging)
to the address below along with a copy of
proof of purchase.

Subject to the exclusions set out below
(see Exclusions) the faulty appliance will then
be repaired or replaced and dispatched
usually within 7 working days of receipt.

If for any reason this item is replaced
during the 2 year guarantee period, the
guarantee on the new item will be calculated
from original purchase date. Therefore it is
vital to retain your original till receipt or
invoice to indicate the date of initial
purchase.

To qualify for the 2 year guarantee the
appliance must have been used according to
the manufacturers instructions. For example
kettles should have been regularly descaled.

EXCLUSIONS

Morphy Richards shall not be liable to
replace or repair the goods under the terms
of the guarantee where:

1 The fault has been caused or is

attributable to accidental use, misuse,

negligent use or used contrary to the

manufacturers recommendations or where

the fault has been caused by power

surges or damage caused in transit.
2 The appliance has been used on a voltage

supply other than that stamped on the

products.
3 Repairs have been attempted by persons

other than our service staff (or authorised

dealer).
4 Where the appliance has been used for

hire purposes or non domestic use.
5 Morphy Richards are not liable to carry

out any type of servicing work, under the

guarantee.
6 Plastic filters for all Morphy Richards

kettles and coffee makers are not covered

by the guarantee.

This guarantee does not confer any rights
other than those expressly set out above and
does not cover any claims for consequential
loss or damage. This guarantee is offered as
an additional benefit and does not affect your
statutory rights as a consumer.

•This guarantee is valid in the UK and
Ireland only.

Morphy Richards products are intended for
household use only.

Morphy Richards has a policy of continuous
improvement in product quality and design.
The company, therefore reserves the right
to change the specification of its models at
any time.

The After Sales Division
Registered address
Morphy Richards Ltd, Mexborough
South Yorkshire, England, S64 8AJ

Helpline (office hours)
UK 0870 060 2615
Republic of Ireland 1800 409119

441/3752/53 Rev 3

Ion iron

steam/spray/shot

Please read and keep these instructions

www.morphyrichards.co.uk

getting the best from your
new iron...

• Safety first

Caution must be used when handling this appliance as it does get
very hot. Always switch off the unit and allow to cool before
cleaning or storing.

• Jet cleaning

Your iron will give the best ironing results and will last longer if you
apply jet cleaning after each period of ironing.

Job: Ion 441375253 Rev 3 -- Color: Composite -- Signature 1, Sheet 1, Front -- Plate 1

Important safety
instructions

The use of any electrical appliance
requires the following common sense safety
rules.

Primarily there is danger of injury or
death and secondly the danger of damage
to the appliance. These are indicated in the
text by the following two conventions:

WARNING: Danger to the person!

IMPORTANT: Damage to the appliance! In
addition we offer the following safety advice.

Location

• Do not use outdoors.

Children

• Children do not understand the dangers

associated with operating electrical

appliances. Never allow children to use

this appliance.

• Close supervision is necessary when any

appliance is used near children.

Personal safety

• Burns can occur from touching hot metal

parts, hot water or steam. Use caution

when you turn a steam iron upside

down, there may be hot water in the

water tank.

• Do not use the vertical steam feature on

clothes that are being worn.

• Do not leave the iron unattended whilst

plugged in or on an ironing board. Never

allow the mains lead to over hang the

work surface.

• The socket should always be off before

plugging or unplugging from the socket.

Never yank the cord to disconnect from

the socket, instead, grasp plug and pull

to disconnect.

• Do not allow the cord to touch hot

surfaces. Let the iron cool completely

before putting away. Loop cord loosely

around the iron before storing.

Other safety considerations

• Use the iron only for its intended use.

•To protect against the risk of electric
shock do not put the appliance in water
or in any other liquid.

• Always disconnect the iron from the
electrical socket when filling with water
or emptying, and when not in use.

• Do not operate the iron with a damaged
cord or if the iron has been dropped or
damaged. To avoid the risk of electric
shock, do not disassemble the iron, but
telephone Morphy Richards for advice.
Incorrect reassembly can cause a risk of
electric shock when the iron is used.

Anti-scale models only

•Keep the anti-scale sachet out of reach
of children.

•Wipe up spilt anti-scale granules
immediately.

• If the granules come into accidental
contact with the eyes, flush them with
water for at least 15 minutes and remove
all particles. Consult a physician if
irritation persists.

• If the granules come into contact with
the skin, remove particles and wash with
water.

• Do not remove the anti-scale cartridge
from the iron, unless the tank is empty.

• When filling ensure that the iron is
disconnected from the electrical socket,
and that the cartridge is inserted
correctly.

Special instructions

• If your iron does not work, check the
following points:
Has the temperature control been set to
the required temperature? Is the plug in
its socket? Is the plug itself or the socket
faulty? (Check by plugging in another
appliance).

2

7

Emptying and storing

When you have
finished ironing,
unplug your iron.
Ensure that the
variable steam
control is set at the

‘’ position, lift up
the fill cap and empty
any remaining water
out of the filling hole.

Do not store in the box, but in an upright
position, so that any drops of water
remaining cannot leak out and discolour the
soleplate.

Important: The
flex can be damaged
if wound too tightly
around the iron after
use. Make a loose
loop with the flex and
wrap it around the
iron. The iron must
be cool before
winding the flex and storing on its heel.

Maintenance

Jet cleaning

Your iron has a built in cleaning system
designed to keep the water valve, steam
chamber and steam vents clear of lint and
loose mineral deposits. The ‘jet clean’ should
be operated after each period of ironing.

To operate, ensure that there is little water
in the tank, place the iron on its heel and turn
the temperature control dial to the maximum
setting. Wait for the temperature indicator
light to go out, then unplug the iron and hold
it about 6’’ (150mm) above the sink in the
ironing position. Press the shot of steam
button about 10 times in succession.

After this cleaning operation, empty out
any remaining water.

To clean a stainless steel
or anodised soleplate
(certain models only)

To keep the soleplate of your iron clean
and free of limescale, we recommend that
you use one of the gentle chrome, silver or
stainless steel cleaners that are generally
available. Always follow the manufacturers
instructions. To clean off melted man-made
fibres set the iron at 3 dot position and pass
it over a clean piece of cotton which will draw
the deposit off the surface.

To clean a coated soleplate
(certain models only)

In the unlikely event of any man-made
fibre fusing to the soleplate, set the iron at
the 3 dot position and pass it over a clean
piece of cotton which will draw the deposit
off the surface.

Do not use scouring powder or solution as
this could cause damage to the coating.

To clean the exterior

Allow the iron to cool and wipe over with a
damp cloth and mild detergent, then wipe
with a dry cloth.

Helpline

If you have any difficulty with your
appliance, do not hesitate to call us.

We are more likely able to help than the
store from where you bought it.

Please have the following information
ready to enable our staff to deal with your
query quickly.

• Name of the product

• Model number as shown on the underside

of the appliance.

Job: Ion 441375253 Rev 3 -- Color: Composite -- Signature 1, Sheet 1, Back -- Plate 2