Filter rapide kettle
Please read and keep these instructions
getting the best from your
new kettle...
• Empty the water out of the kettle after first boiling
To clean away any deposits that are left in the kettle after the
manufacturing process.
• Filling your filter kettle
When filling your filter kettle the water must cover the element. The
minimum is 1 cup or 30cls.
Do not overfill past the maximum mark as the filtration will be
impaired. The water in your kettle should not touch the filter
cartridge.
• Safety first
Always pour water slowly and carefully to prevent the splashing of
scalding water.
• Cartridge
PLEASE NOTE: It is quite normal to see black particles in the
bottom of the cartridge pack and in the top compartment when in
use. Please be assured that these particles are not harmful to you
or your filter jug and you should not be concerned if you see any.
www.morphyrichards.co.uk
Important safety
instructions
The use of any electrical appliance
requires the following common sense safety
rules.
Primarily there is danger of injury or
death and secondly the danger of damage
to the appliance. These are indicated in the
text by the following two conventions:
WARNING: Danger to the person!
IMPORTANT: Damage to the appliance! In
addition we offer the following safety advice.
Location
• Always locate your kettle away from the
edge of the worktop.
• Ensure that the kettle is used on a firm,
flat surface.
• Do not use the kettle outdoors or in a
bathroom.
•WARNING: Do not place the kettle onto
a metal tray or metal surface whilst in
use.
Children
• Children do not understand the dangers
associated with operating electrical
appliances. Never allow children to use
this appliance.
•Teach children to be aware of dangers in
the kitchen, warn them of the dangers of
reaching up to areas where they cannot
see properly or should not be reaching.
Mains lead
• The mains lead should reach from the
socket to the base unit without straining
the connections. Reduce the length of
the lead by storing the excess in the
cord storage facility in the base unit.
• Do not let the mains lead hang over the
edge of the worktop where a child could
reach it.
• Do not let the lead run across an open
space e.g. between a low socket and
table.
• Do not let the lead run across a cooker
or toaster or other hot area which might
damage the cable.
• Do not place the kettle where the mains
lead could fall into a sink.
Your safety
• Always pour hot water slowly and
carefully without tipping the kettle too
fast to prevent splashing and spillage.
• Extreme caution must be used when
moving a kettle containing hot water.
• Do not touch hot surfaces, use handles
or knobs.
• Always close the lid securely, otherwise
the kettle may not switch off
automatically and may spit out boiling
water.
•Avoid contact with steam from the spout
when the water is boiling or just after it
has switched off.
•Take care if opening the lid for re-filling
when the kettle is hot.
• Do not fill above the MAX mark,
otherwise boiling water may be ejected
and filtration may be impaired.
• Do not hold the switch in the on position
or tamper with the switch to fix it in the
on position as this may cause damage to
the switch-off mechanism.
• Unplug from the outlet before cleaning.
• Allow to cool before putting on or taking
off parts and before cleaning.
Treating scalds
• Run cold water over the affected area
immediately. Do not stop to remove
clothing, get medical help quickly.
Other safety considerations
•To protect against fire, electric shock and
personal injury do not immerse cord,
plug or kettle in water or any other liquid.
• Do not operate any appliance with a
damaged cord or plug or after the
appliance malfunctions or has been
damaged in any manner. Ring the
helpline number for advice on
examination and repair.
2
• The use of attachments or tools not
recommended or sold by Morphy
Richards may cause fire, electric shock
or injury.
• Do not attempt to connect any other
appliance to the base unit or this
appliance to another base unit.
•Do not tamper with the connector in any
way.
•Do not use the kettle for any use other
than to boil water.
• Do not use outdoors.
• Do not place the kettle on or near a hot
gas or electric burner or in a heated
oven.
• The kettle must not be on the base unit
when being filled with water.
• The mains lead of the cordless base
cannot be repaired. If the mains lead is
damaged, the cordless base should be
discarded and replaced.
•Unplug from the outlet when not in use.
„
Â
Ë
‚
·
Á
Ê
⁄
¤
‹
‡
Electrical requirements
Check that the voltage on the rating
plate of your appliance corresponds with
your house electricity supply which must be
A.C. (Alternating current).
For appliances with fitted plug.
If the socket outlets in your home are not
suitable for the plug supplied with this
appliance the plug should be removed and
the appropriate one fitted.
IMPORTANT : THE PLUG REMOVED
FROM THE MAINS LEAD, IF SEVERED,
MUST BE DESTROYED AS A PLUG WITH A
BARED FLEXIBLE CORD IS HAZARDOUS
IF ENGAGED INTO A LIVE SOCKET
OUTLET.
Should the fuse in the 13 amp plug
require changing a 13 amp BS1362 fuse
must be fitted.
WARNING: THIS APPLIANCE MUST
BE EARTHED.
fl
‰
Features
⁄ Top compartment (cartridge holder)
¤ Cartridge
‹ Spout
› 360˚ connector
fi Cord storage
fl Cordless base unit
‡ Concealed element
· On off switch
‚ Lid handle
„ Lid
‰ Filling slider
 Electronic cartridge reminder
Ê Neon ‘on’ indicator
Á Easy release button
Ë Spout cover
›
fi
3
Using
2 Allow water to filter through system,
discard the water and repeat once more.
Filtering your water improves the taste
and appearance of beverages by reducing
limescale, lead, chlorine and other
impurities.
Before use
1 Remove cartridge from the packet and
soak in a bowl of water for 20 minutes.
2 Take the top compartment (the cartridge
holder) out of the kettle by pulling the
cartridge holder easy release button Á
forward and lift upwards.
3 Insert the cartridge into the top
compartment from the bottom and twist
clockwise to lock in place.
4 Replace the cartridge holder back into
the kettle and click into place.
The amount of water must cover the
kettle element. The minimum is 1 cup or
30 cls. Do not fill above the maximum
mark or filter performance will be
impaired. Always ensure the kettle is
emptied before refilling.
Electronic cartridge reminder
After changing the cartridge and for first
usage, the counter must be reset.
1 Hold the start button for 3 seconds
(100% will show on the display and the
outer ring will flash). The display will then
switch off due to its energy saving device
after 3 minutes.
2 You can check the progress of your
cartridge at any time by pressing the
start button for 1 second. The counter
will count down from 100% to 25%.
3 25% turns off when the cartridge needs
replacing. The outer ring of the display
will flash and continue to flash until the
cartridge has been changed.
Filling the kettle
1 Fill the kettle with tap water to the
maximum mark either by lifting up the lid
or by sliding the filler slider to one side
as shown.
4 Reset the reminder as per point 1.
4
Replacing electronic cartridge reminder
When the cartridge reminder is due for
renewal it can easily be removed.
1 Pull both tabs upwards and lift out the
cartridge reminder.
2 To refit your new cartridge reminder, slot
tabs into the lugs provided and click into
place.
• If you are using the kettle for the first
time, discard the water and repeat once
more.
•To re-boil, switch to ON again. If the
kettle has just switched off wait a minute
or so before switching it back on again.
• If you do not put in enough water, or
switch on the filter kettle when it is
empty, the safety cut-out will switch off
the power automatically. If this happens,
refill and wait a few minutes for the
element to cool, then use as normal.
5 Lift the filter kettle from the base unit by
the handle ensuring you hold the kettle
level.
Telephone our replacement parts
helpline for your new cartridge reminder.
Switching on
You do not need to wait until the water
has filtered through before boiling. Your
Morphy Richards filter kettle, will boil and
filter at the same time giving you boiled,
filtered water quickly.
• Boil only as much water as you need as
this saves electricity.
1 Place the filter kettle on the base unit,
ensuring the kettle locates on to the
360˚ connector.
• The 360˚ connector allows the kettle to
be located at any position, - ideal for left
and right handed users and convenient
positioning on worktop.
2 Plug in and switch on at the wall socket.
3 Switch the filter kettle on. The ‘power on’
neon, will light up.
4 When the water boils the filter kettle will
switch off automatically.
WARNING: Unless the cartridge holder
is fitted correctly, the filter kettle may not
operate correctly and the lid may not
close and lock securely.
5
When to change your cartridge
This depends on water quality and the
improvement required. We recommend that
you change your cartridge after 1 month.
The electronic reminder on your Morphy
Richards water filter system will remind you
when to change your cartridge.
Replacing your filter cartridge
1 Take the top compartment (the cartridge
holder) out of the kettle by pulling the
cartridge holder easy release button
forward and lift upwards.
2 Remove the old cartridge by rotating it
anti-clockwise to unlock it.
5 Replace the top compartment back into
the kettle and click into place.
6 Fill with tap water. Allow the water to filter
through the system. Discard the water
and repeat once more.
IMPORTANT : Only use Morphy Richards
cartridge filters. Telephone our
replacement parts helpline for
assistance.
3 Remove the new cartridge from the
packet and soak in a bowl of water for
20 minutes.
4 Insert the new cartridge into the top
compartment from the bottom and twist
clockwise to lock in place.
6
Cleaning
Helpline
WARNING: Always disconnect the plug
from the mains and allow the kettle to cool
before cleaning.
Wipe the outside with a damp cloth.
IMPORTANT: Do not use abrasive
cleaners on the kettle which may scratch
the surface.
If you have any difficulty with your
appliance, do not hesitate to call us. We’re
more likely to be able to help than the store
from where you bought it.
Please have the following information
ready to enable our staff to deal with your
query quickly:
• Name of the product
• Model number as shown on the
underside of the appliance.
7
Your two year guarantee
It is important to retain the retailers receipt
as proof of purchase. Staple your receipt to
this back cover for future reference.
Please quote the following information if
the product develops a fault. These numbers
can be found on the base of the product.
Model no. Serial no.
All Morphy Richards products are
individually tested before leaving the factory.
In the unlikely event of any appliance proving
to be faulty within 28 days of purchase it
should be returned to the place of purchase
for it to be replaced.
If the fault develops after 28 days and
within 24 months of original purchase, you
should contact the Helpline number quoting
Model number and Serial number on the
product, or write to Morphy Richards at the
address shown.
You will be asked to return the product (in
secure, adequate packaging) to the address
below along with a copy of proof of
purchase.
Subject to the exclusions set out below (see
Exclusions) the faulty appliance will then be
repaired or replaced and dispatched usually
within 7 working days of receipt.
If for any reason this item is replaced
during the 2 year guarantee period, the
guarantee on the new item will be calculated
from original purchase date. Therefore it is
vital to retain your original till receipt or
invoice to indicate the date of initial
purchase.
To qualify for the 2 year guarantee the
appliance must have been used according to
the manufacturers instructions. For example
kettles should have been regularly descaled.
EXCLUSIONS
Morphy Richards shall not be liable to
replace or repair the goods under the terms
of the guarantee where:
1 The fault has been caused or is
attributable to accidental use, misuse,
negligent use or used contrary to the
manufacturers recommendations or where
the fault has been caused by power
surges or damage caused in transit.
2 The appliance has been used on a voltage
supply other than that stamped on the
products.
3 Repairs have been attempted by persons
other than our service staff (or authorised
dealer).
4 Where the appliance has been used for
hire purposes or non domestic use.
5 Morphy Richards are not liable to carry
out any type of servicing work, under the
guarantee.
6 Plastic filters/cartridges for all Morphy
Richards filter jugs and kettles are not
covered by the guarantee.
This guarantee does not confer any rights
other than those expressly set out above and
does not cover any claims for consequential
loss or damage. This guarantee is offered as
an additional benefit and does not affect your
statutory rights as a consumer.
• This guarantee is valid in the UK and
Ireland only.
Morphy Richards products are intended for
household use only.
Morphy Richards has a policy of continuous
improvement in product quality and design.
The company, therefore reserves the right
to change the specification of its models at
any time.
Registered address
The After Sales Division
Morphy Richards Ltd, Mexborough
South Yorkshire, England, S64 8AJ
Helpline (office hours)
UK 0870 060 2611
Republic of Ireland 1800 409119
KT43550M UK Rev 2
Loading...