Page 1
Goblin 1400W wet & dry cleaner
Please read and keep these instructions
getting the best from
your new wet & dry
cleaner...
If your cleaner isn’t performing as
well as it should, please check
• Dustbags
If using the product with a dustbag fitted it is important to
replace them, otherwise the performance of the cleaner will
be impaired
• Filters
It is important that the cartridge and foam filters are cleaned
regularly or replaced to allow air through the appliance
• Blockages
Check the nozzle, tubes and hose for blockages
Page 2
Important safety
instructions
The use of any electrical appliance
requires the following of common sense
safety rules.
Primarily there is danger of personal
injury and secondly danger of damage to the
appliance and property. These are indicated
in the instructions text by the following two
conventions:
WARNING: Danger of personal injury
IMPORTANT: Damage to the appliance
In addition we offer the following
essential safety advice.
Location
• Do not use or keep this product outside
when it is raining.
• Do not store the appliance near hot
ovens or heating appliances.
Mains lead
• Do not allow the mains lead to become
strained or run this appliance over it.
• If the electrical cable becomes damaged
the complete cable assembly must be
replaced. Do not attempt this task
yourself, contact Goblin using the
helpline number.
Children
•Children do not understand the dangers
associated with operating electrical
appliances. Never allow children to use
this appliance.
Dangerous substances
• Never use the appliance to vacuum hot
ashes, broken glass, sharp objects or
liquids.
• Never use in the presence of explosive
liquids or vapours.
• Never pick up inflammable or poisonous
liquids such as petrol, copier toner, or
other volatile substances.
• Never pick up acids, asbestos or
asbestos dust.
• Never use in the presence of explosive
liquids or vapours.
• Never pick up hot or glowing ash, hot
cigarette ends, hot coals or any other
similar items.
Other safety considerations
• Always disconnect the appliance from the
mains supply after use or prior to the
motor housing being removed.
• The appliance should never be left
running unsupervised.
• Never modify the cleaner in any way.
• Repairs to electrical appliances are only
to be undertaken by trained personnel.
Unprofessional repairs can be dangerous
for users.
• Repairs should only be carried out by
authorised service agents.
• Use only genuine Aquavac/Goblin spare
parts and accessories
Electrical
requirements
When using this appliance outdoors it
should be additionally protected by a RCCB
(Residual Current Circuit Breaker).
Please check that the supply voltage
details given on the rating plate (located on
the side of the motor housing inside the
tank) are in accordance with your electricity
supply.
If the socket outlets in your home are not
suitable for the plug supplied with this
appliance, the plug should be removed and
the appropriate one fitted.
WARNING: The plug removed from
the mains lead, if severed, must be
destroyed as a plug with bared flexible
cord is hazardous if engaged into a live
socket outlet.
Should the fuse in the 13 amp plug
require replacement, a BS1362 13 amp fuse
must be fitted.
Page 3
A
„
Ê
Á
·
‹
‰
›
‚
Â
‡
⁄
¤ fl
Features
⁄ Motor housing
¤ Power switch
‹ Tank latches
› Hose end
fi Carrying handle
fl Extension tubes
‡ Floor nozzle
· Exhaust filter holder
‚ Removable inner tank
„ Main tank
‰ Castors
 Hose
Ê Upholstery nozzle
Á Crevice tool
Ë Cartridge filter
È Foam filter
Í Foam filter holder
Î Cardboard collar
Ï Cable storage hook
fi
Accessories you should have
• Hose
• 2 x extension tubes
• Floor nozzle
• Upholstery nozzle
• Crevice tool
• 4 x castors
• Hose end
• Inner tank
• Foam filter
• 1 x paper bag
• 1 x cartridge filter
Note: some accessories
may be packed inside the
cleaner
È
Í
Ë
Page 4
Introduction
Your new machine is a tough, powerful
and extremely versatile Wet & Dry vacuum
cleaner. In addition to normal household
cleaning it can be used for:
• Liquids: spills and leaks, blocked sinks
and soakaways, floods, ponds and
cleaning out chest freezers after
defrosting.
• Bulky waste: sawdust, wood shavings,
plaster, sand, grinding dust, nails, screws,
broken glass; soil in the potting shed.
How does your wet
& dry work?
A heavy duty motor is located on top of
the waste tank. The powerful vacuum lifts
dirt and liquids through the hose which settle
in the bottom of the tank. This arrangement
protects the motor from liquids. A float shutoff valve cuts off the suction when the waste
tank gets full of liquid.
A long-life cartridge filter is used when
picking up dry waste to prevent fine particles
being blown back out again. Paper bags can
also be used for easier disposal.
Your wet & dry may sound louder than
smaller conventional cleaners. This is normal
for a heavy duty motor, designed to provide
power and long life.
Assembly
Release the tank latches and lift off the
motor housing G. Check for any accessories
packed inside the tank. Turn the tank upside
down and press the castors into holes C.
Do not use excess force. Refit the motor
housing ensuring that the switches are
positioned above the inlet A. If the motor
housing is fitted in any other position the
latches will not lock. Press the middle and
not the bottom of the latch to lock.
Accessories
Assemble hose, extension tubes and
nozzles as required as shown A. Insert the
hose end into the tank inlet and twist to
secure. Use any number of extension tubes
to suit the cleaning task. When fitting one
section to the next, push together and then
twist to lock them together.
IMPORTANT: Do not press down when
cleaning - let the powerful suction do the
work.
WARNING: Always switch off and
remove the plug from the wall socket
before working on the cleaner, eg when
emptying the tank or changing the
filters.
C
B
·
Page 5
Power control
This is a simple rocker switch:
On
Off
Cartridge filter
Your cleaner features a removable
heavy duty cartridge filter. Designed to
withstand the impact of large debris and
liquids, proper maintenance will give it a
much extended life. The filter has a locking
key to hold the cartridge filter in place simply position the filter and turn the locking
key clockwise or anti-clockwise to fit or
remove DË.
Dry usage
The cartridge filter must always be fitted
when not picking up liquids. Failure to do so
may cause damage by allowing dust and
larger particles into the motor (and
invalidation of the guarantee).
To clean the filter, remove it and brush
the grooves with a soft brush, ensuring you
don’t damage the surface.
If you need to pick up very fine dust (eg
cement, plaster, ash), we recommend you
use a paper bag. Always remove the inner
tank when using a paper bag.
Wet usage
When picking up liquids (eg when
emptying a blocked sink), leave the cartridge
filter in place. Clean it under gently running
water, allowing it to dry naturally before
refitting.
If frequent wet usage is expected we
recommend that you use the foam filter
which is specifically designed for wet usage.
Remove the cartridge filter and slide the
foam tube over the float basket then secure
with the holder turning the holder a
1
/4turn to
lock it into place DÈ.
Float shut-off
When the waste tank is full of liquid the
float shut-off valve E, automatically cuts off
the suction which is indicated by a higher
pitched noise from the motor. If this occurs:
1 Turn the motor OFF.
2 Switch off and disconnect electrical
supply by removing the plug from the
wallsocket.
3 Raise hose to drain liquid back into the
tank.
4 To minimise any back-flow of liquid keep
hose in raised position until emptied.
IMPORTANT: Do not attempt to remove
the float as this is important to safe use.
If the cleaner overturns during use turn
the motor off, return to upright and wait until
the float falls free.
The valve will operate whether the filter is
fitted or not.
D
ËÈ
Í
E
È
Í
Page 6
Exhaust filter
In addition to the cartridge filter your
cleaner also has a filter fitted to the exhaust.
This is housed at the rear of the motor
housing.
To access the filter remove the holder by
inserting your fingers into the bottom of it
and pulling B. The filter can then be
removed and cleaned by either gently
tapping or rinsing in water. Once dry, fit the
filter into the holder. Replace the holder by
first locating the bottom into position B, and
then pushing the top firmly until it clicks into
position. Ensure that the exhaust filter flap
has been fitted securely otherwise it may
come off during use.
Blower
Your cleaner may also be used to blow
debris instead of vacuuming. To use the
blower facility remove the exhaust filter
holder as described under ‘Exhaust filter’.
Insert the hose end into the semi-circular
location at the back of the cleaner. The hole
in the hose end must be pointing to the right.
Twist to secure F.
Emptying
Switch off and unplug the cleaner from
the mains supply. Unclip and remove the
motor housing G. Remove internal waste
tank empty, replace and refit motor housing.
F
G
H
Î
„
Page 7
Dust collection
bags
When collecting dry material, your
cleaner can be used with or without a paper
dust collection bag. However, they make for
easier collection and disposal of dry material
and should be fitted as shown in H. Always
remove the inner tank before fitting the bag.
With the hose end removed, slide the
cardboard collar on the collection bag into
the slots inside the main tank and locate the
bag around the inside of the tank. Bend the
top of the cardboard collar back along the
crease to allow easy fitment of the motor
housing. Refit the hose end and then the
motor housing. Note, there is no need to
remove the cartridge filter. Replacement
bags are available.
IMPORTANT: Do not use a bag for
picking up nails, broken glass or other sharp
objects as these may cause it to tear. Do not
use a bag for wet pick up.
Cable storage
When not in use, the cable can be stored
by wrapping it around the section above the
exhaust filter flap and the cable storage hook
at the back of the cleaner J.
Cleaning
If the cleaner has been used for wet pickup. The cleaner/filter must be thoroughly
dried before storage.
Helpline
If you have any difficulty with your
appliance, do not hesitate to call us. We’re
more likely able to help than the store from
where you bought it.
Please have the following information
ready to enable our staff to deal with your
query quickly:
• Name of the product
• Model number as shown on the
underside of the motor-housing.
J
Ï
Page 8
8760970 Rev 2 06/02
The After Sales Division,
Goblin, Mexborough,
South Yorkshire, England, S64 8AJ
Helpline (office hours)
UK 0870 0602605
Republic of Ireland 1800 409119
Goblin products are intended for
household use only
Goblin has a policy of continuous
improvement in product quality and
design. The Company, therefore,
reserves the right to change the
specification of its models at any time.
For additional information on Goblin products www.morphyrichards.co.uk
Your two-year
guarantee
• It is important to retain the retailers
receipt as proof of purchase. Staple
your receipt to this back cover for future
reference.
Please quote the following information if
the product develops a fault. These numbers
can be found on the base of the product.
Model no. Serial no.
All Goblin products are individually tested
before leaving the factory. In the unlikely
event of any appliance proving to be faulty
within 28 days of purchase it should be
returned to the place of purchase for it to be
replaced.
If the fault develops after 28 days and
within 24 months of original purchase, you
should take the appliance to your nearest
service agent. A list containing details of
your nearest service agent is included with
your appliance but please contact the
helpline quoting model number and serial
number should you require further
assistance. Repair or replacement of the
product is subject to the exclusions set out
below (1-6).
If you suspect a fault, follow the simple
checks detailed below before returning the
appliance or calling the helpline.
• Check the dust bag and filters for
blockages.
• Check the hose and tubes for blockages.
• Check the plug is firmly in the socket and
the supply is switched on.
•Make sure the socket is working by trying
another appliance.
If for any reason this item is replaced
during the two-year guarantee period, the
guarantee on the new item will be calculated
from original purchase date. Therefore it is
vital to retain your original receipt or invoice
to indicate the date of initial purchase.
To qualify for the two-year guarantee the
appliance must have been used according to
the manufacturers instructions.
Goblin shall not be liable to replace or repair
the goods under the terms of the Guarantee
where:
1 The fault has been caused or is attributable
to accidental use, misuse, negligent use or
used contrary to the manufacturers
recommendations or where the fault has
been caused by power surges or damage
caused in transit.
2 The appliance has been used on a voltage
supply other than that stamped on the
products.
3 Repairs have been attempted by persons
other than our service staff (or authorised
dealer).
4 Where the appliance has been used for hire
purposes or non-domestic use.
5 The guarantee excludes consumables such
as bags and filters.
6 Goblin are not liable to carry out any type of
servicing work, under the guarantee.
This guarantee does not confer any rights
other than those expressly set out above
and does not cover any claims for
consequential loss or damage. This
guarantee is offered as an additional benefit
and does not affect your statutory rights as a
consumer.
• This guarantee is valid in the UK and
Ireland only.
Loading...