Morphy Richards Essentials 25018 Instructions Manual

Morphy Richards products are intended for household

use only. Morphy Richards has a policy of continuous

improvement in product quality and design. The

Company, therefore, reserves the right to change the

specification of its models at any time.

446/8001/48 Rev 1

Imported by : Morphy Richards Ltd, Talbot Road, Mexborough, S64 8AJ

Medical precautions

• This should not be used in the following cases:
tuberculosis, benign and malignant tumors,
hemmorages, inflammations of the skin, phlebitis
and thrombosis, open and fresh wounds, bruises,
broken skin or varicose veins or undetermined calf
pain.

• Consult your physician if you have any questions
regarding the use of the bath spa.

• Do not use on any part of the body that is
anesthetized.

• Do not use on any part of the body where surgery
has been performed.

• Do not use on any unexplained pain before
consulting a doctor.

• If you have any concerns regarding your health,
consult your doctor before using this product.

Wiring

Check that the voltage on the rating plate of the adaptor
plug corresponds with your house electricity supply
which must be A.C. (Alternating Current).
If the socket outlets in your home are not suitable for
this adaptor, then do not use at all.

Always use the adaptor plug supplied.

Maintenance

Keep the bathspa clean and clear of obstructions.
Check the outflow control frequently for potential
obstructions, including lint and hair, that could block air
or water flow. We recommend cleaning the bathspa
after each use with mild detergent or soap.

1 Unplug the unit and allow it to cool before cleaning.

Clean only with a soft, slightly damp sponge. Note:
Do not use abrasive cleaners, brushes, gasoline,
kerosene, glass/furniture polish or paint thinner to
clean.

2 Bathspa should also be disinfected regularly to

keep it bacteria free.

Do not attempt to repair the bathspa. There are no user
serviceable parts inside.

Bath spa

MODEL : 25018

Instructions

Two Year Guarantee

It is in your interest to retain the retailers receipt as proof
of purchase. Please quote the model number if the
product develops a fault. This number can be found on
the base of the product.

All Morphy Richards products are individually tested
before leaving the factory. In the unlikely event of any ap­pliance proving to be faulty within 28 days of purchase it
should be returned to the place of purchase for it to be
replaced.

If a fault develops after 28 days and within 24 months of
original purchase, you should contact the helpline number
quoting the model number of the product, or write to the
address below. Y ou will be asked to return the product (in
secure packaging) to the address below along with a copy
of proof of purchase.

The After Sales Division

Morphy Richards Ltd

Mexborough

South Yorkshire

England
S64 8AJ

Helpline (8:30-5:00 Mon-Thur/ 8:30-4:00 Fri)
UK (local rate) 08450 777700,
Republic of Ireland 1800 409119

Morphy Richards Website
www.morphyrichards.co.uk

Adaptor cord

Suction
cups

Jet stream/bubbles

Adaptor plug

Bath spa adaptor plug

Instructions for use
1 Place the bathspa in the tub by using the

installation instructions.

2 Insert the bathspa plug into the adaptor

(see figure 2).

3 Plug the adaptor into the mains outlet which must

be outside the bathroom. (see figure 3).

4 Fill the bathtub with water to the line indicated on

the unit.

5 Press the on button and set the control to the

desired setting (jet stream or bubbles).

CAUTION

If the bathspa falls into the tub during use do not panic.
Bathspa has been designed to withstand submersion
for short periods of time without danger. Remove the
unit from the tub immediately and press the off button.
Unplug the adaptor plug and hold the unit over the tub,
rotating gently to remove excess water from the
housing. When the water is completely emptied from
the unit, reinstall the bathspa and follow the operating
instructions.

4

1

2

3

5

Important safeguards

When using your bathspa, basic safety precautions
should always be followed.

Read all instructions carefully.

• Use the appliance for its intended use only.

• To protect against the risk of electric shock, always
unplug this appliance from the electrical outlet
immediately after using and before cleaning.

• Be sure that your household voltage corresponds
to the voltage marked on the appliance.

• Always unplug your appliance when it is not in use.

• It is recommended that this appliance should not
be used by children.

• Do not leave the appliance switched on whilst
unattended.

• Do not place or store the power pack where it can
fall or be pulled into a bath tub or sink. Do not place
in or drop into the water or other liquid. Store in a
dry place.

• Do not attempt to plug or unplug the unit while the
body is in water.

• Do not use attachments not recommended.

• Do not operate this appliance if it has a damaged
cord or plug, if it is not working properly, if it has
been damaged in any way return it to Morphy
Richards.

• Do not block the air openings of the appliance or
power pack or place on soft surface such as a bed
or couch, where the air openings may be blocked.
Keep air openings free of lint, hair, dust etc.

• Do not drop or insert any object into any opening.

• Do not use outdoors.

• To disconnect, turn all controls to the ‘off’ position
then remove the plug from the outlet.

• Ensure that your hands are dry when operating

the switch or removing the plug.

Cautions

• Do not cover the bath spa or power pack with any
material while it is in operation.

• Do not use if you have sensitive skin areas or poor
circulation.

• Do not use while sleeping or drowsy.

• Do not use bath spa for more than 20 minutes.

• Indoor use only, do not use on the walls of inflatable
tubs or pools.

Do not reach for the power supply while in the bath. Do
not disconnect the power until the unit is turned off. If
the unit has been immersed for more than 5 minutes,
remove the unit from the bath, press the off button,
disconnect the power cord from the adaptor plug, drain
the water from the unit and store in a dry place for at
least 24 hours before next use.

Figure 1

Figure 2

Figure 3

Figure 4

Thank you for buying your new Essentials bath spa
from Morphy Richards. Please read these instructions
carefully before use and keep in a safe place for future
reference.

Key features

1 On/off button

T o turn on the bathspa press the power button

2 Suction cups

Keeps bathspa securely mounted

3 Fill line

Fill the bathtub with water to this line

4 Dual jets

Jets adjust in several directions

5 Variable control

From power jet stream to gentle bubbles
No bubbles

Bubble relief

This bathspa turns your bathtub into a whirlpool by
adding bubbles or a stream action, helping you to relax
and renew.

Installation instructions
1 Ensure that the bathspa is off and the tub is empty.
2 Place the unit over the edge of the tub so the unit is

inside the tub and the arm is resting on the edge.
(see figure 1).

3 Dampen suction to improve the grip.
4 Secure suction cups.
5 Adjust the suction cups so that it sticks directly onto

the bath tub as water may spray if the bath spa is
not level when turned on.