Morphy Richards BLENDER - MANUAL 3, BLENDER User Manual

Page 1
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
BlenderBlender
BlenderBlender
Blender
Please read and keep these instructions
www.morphyrichards.co.uk
getting the best from your new blender
The blender blades are very sharp, therefore handle with care when using and cleaning.
Quantities
Do not overfill the blender. Refer to the operating chart for quantities and operating times.
Ensure the blender lid is in place
When using the blender ensure the lid is in place before switching on and do not remove until the blades have stopped rotating.
BLENDER 13/8/02, 12:26 PM1
Page 2
2
Important safetyImportant safety
Important safetyImportant safety
Important safety
○○○○○○○○○○○○○○○○○○○○○
instructionsinstructions
instructionsinstructions
instructions
The use of any electrical appliance requires the following basic common sense safety rules.
Primarily there is danger of injury or death and secondly the danger of damage to the appliance. These are indicated in the text by the following two conventions:
WARNING: Danger to the person!
IMPORTANT: Damage to the appliance! In addition we offer the following safety advice.
○○○○○○○○○○○○○○○○○○○○○
LocationLocation
LocationLocation
Location
Remove all packaging and retain for
future reference.
Ensure the blender is used on a
firm, flat surface.
Do not use the blender outdoors
or in a bathroom.
Do not place the blender on a
highly polished wooden surface as damage may occur to the surface.
Do not place the blender on or
near hot surfaces such as a hot plate or radiant rings or near a naked flame.
Do not let the mains lead overhang the
edge of the table or work-top, or touch hot surfaces.
DO NOT PLACE THE APPLIANCE ON
OR A NEAR A HOT GAS OR ELECTRIC HOB, OR IN A HEATED OVEN.
○○○○○○○○○○○○○○○○○○○○○
ChildrenChildren
ChildrenChildren
Children
Children do not understand the
dangers associated with operating electrical appliances. Never allow children to use this appliance.
○○○○○○○○○○○○○○○○○○○○○
Personal safetyPersonal safety
Personal safetyPersonal safety
Personal safety
IMPORTANT: THE BLENDER BLADES
ARE VERY SHARP. Handle with care when using and cleaning.
Keep hands and utensils out of the
blender when it is switched on.
Allow hot liquids to cool before
blending, always ensure the lid is fitted correctly.
Avoid touching moving parts. Keep
hands, hair, clothing as well as spatulas and other utensils away from blender blades during operation, to prevent personal injury and/or damage to the appliance.
○○○○○○○○○○○○○○○○○○○○○
Other safety considerationsOther safety considerations
Other safety considerationsOther safety considerations
Other safety considerations
Disconnect the blender from the mains
supply when not in use, before taking off attachments, and before cleaning.
To protect against risk of electric shock
NEVER immerse the blender body in water or any other liquid and always ensure the electrical connections are kept dry.
Do not operate any appliance with a
damaged cord or plug or after the appliance malfunctions or has been damaged in any manner. Ring the helpline number for advice on examination and repair.
The use of attachments or tools not
recommended or sold by Morphy Richards may cause fire, electric shock or injury.
Do not use abrasive cleaners on the
outside of the blender, they may scratch the surface. Clean only with a soft damp cloth.
Do not use the blender for other than
its intended use.
BLENDER 13/8/02, 12:26 PM2
Page 3
3
Do not overfill the blender. This could cause damage to the motor. The 3A fuse will blow if the blender is over loaded. Replace fuse and do not exceed the maximum recommended volumes. Refer to the operating chart.
Do not blend for longer than the time
periods recommended in the operating chart.
When using the blender ensure
the lid is in place before switching on and do not remove the lid until the blade has stopped rotating.
○○○○○○○○○○○○○○○○○○○○○
Electrical requirementsElectrical requirements
Electrical requirementsElectrical requirements
Electrical requirements
Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A.C.(Alternating current).
If the socket outlets in your home are not suitable for the plug supplied with this appliance the plug should be removed and the appropriate one fitted.
IMP0RT ANT : THE PLUG REMOVED FROM THE MAINS LEAD, IF SEVERED, MUST BE DESTROYED AS A PLUG WITH A BARED FLEXIBLE CORD IS HAZARDOUS IF EN­GAGED INTO A LIVE SOCKET OUTLET.
Should the fuse in the 13 amp plug require replacement, a 3 amp BS1362 fuse must be fitted.
WARNING : THIS APPLIANCE MUST BE EARTHED.
○○○○○○○○○○○○○○○○○○○○○
Blender useBlender use
Blender useBlender use
Blender use
Use your blender for soups, sauces, drinks, pates, mayonnaise, dressings etc.
○○○○○○○○○○○○○○○○○○○○○
Features of your blenderFeatures of your blender
Features of your blenderFeatures of your blender
Features of your blender
Filler cap Lid Jug Blades Seal and blade assembly Jug base Blender base unit Control switch
BLENDER 13/8/02, 12:26 PM3
Page 4
4
○○○○○○○○○○○○○○○○○○○○○
Operating controlsOperating controls
Operating controlsOperating controls
Operating controls
The blender control switch has the following settings. Pulse, off, speed 1 and speed 2.
The speed can be adjusted whilst the blender is in use.
Using the pulse setting allows greater control over the texture of the food produced. It is only intended to be used for short ‘bursts’ of blending.
○○○○○○○○○○○○○○○○○○○○○
Operating the blenderOperating the blender
Operating the blenderOperating the blender
Operating the blender
Setting up
1 Ensure the blender base unit is unplugged
fromthe mains. 2 Place the blade assembly
into the centre of
the glass jug
and push into position.
3 Screw the jug base anti-clockwise onto the
glass jug
.
4 Place the blender jug
on to the base unit
and turn. Ensure that the jug is securely in
place.
5 Place the food in the blender. (Please see
page 5 for hints on blending food.)
6 Place the lid
onto the blender. Then put the
filler cap
into position.
7 Plug in the blender and turn the control switch
to either pulse, speed 1 or speed 2
depending on the desired consistency . Always operate the blender with the lid in place.
8 Never operate the blender with more than
1 litre (1
3
/4 pints) of liquid or when empty.
P
Off
Speed 1
Speed 2
BLENDER 13/8/02, 12:26 PM4
Page 5
5
DO NOT PROCESS FOR LONGER THAN RECOMMENDED TIME DO NOT EXCEED RECOMMEDED MAXIMUM VOLUMES
Blending/ liquidising
Soups, purees, drinks, milkshakes, batters
1.0 lt 1-2 + pulse
15 secs-1min Begin with low speed and
increase to high if required.
○○○○○○○○○○○○○○○○○○○○○
Operating chartOperating chart
Operating chartOperating chart
Operating chart
○○○○○○○○○○○○○○○○○○○○○
Hints and tipsHints and tips
Hints and tipsHints and tips
Hints and tips
Don’t put dry ingredients into the blender before switching on. If necessary , cut them into pieces; remove the filler cap; then, with the machine running drop the pieces through one by one.
When making mayonnaise, put all the ingredients, except the oil, into the blender. Then with the machine running, pour the oil slowly into the blender through the filler cap hole.
Thick mixtures, eg. pates and dips, may need
scrapping down with a spatula (ensure the
appliance is switched off first). If the mixture is difficult to process add more liquid.
When crushing ice, add 15ml (1tbsp) water to
6 ice cubes and operate the blender in short bursts using pulse setting.
When blending pour the liquids in first and then add the solid food. Begin blending at the lower speed and increase when needed.
IMPORTANT: T o ensure the long life of your blender never run it for longer than 60 seconds. Switch off as soon as you have reached the desired consistency.
The machine will not work if the blender is fitted incorrectly.
Don’t use the blender as a storage container. Keep it empty when not in use.
Never blend more than 1 litre (1 3/4 pints) ­less for frothy liquids such as milk shakes.
○○○○○○○○○○○○○○○○○○○○○
Cleaning and storageCleaning and storage
Cleaning and storageCleaning and storage
Cleaning and storage
BEFORE CLEANING, SWITCH OFF AND
UNPLUG THE MAINS LEAD.
After use, fill the blender with warm 1 litre (1
3
/
4
pints) water and run for 30 seconds on the pulse setting and repeat as necessary. Never use abrasives or cream cleaners. Clean the base unit with a damp cloth or kitchen paper roll.
NEVER IMMERSE THE BLENDER BASE
UNIT IN WATER.
To clean the jug 1 Unscrew the base of the jug. 2 Carefully remove the blade assembly from the
jug and wash.
3 Only the glass jug can be washed in a
dishwasher.
4 Reassemble the jug by carefully placing the
blades through the bottom of the jug and then screw the base of the jug on tightly .
○○○○○○○○○○○○○○○○○○○○○
HelplineHelpline
HelplineHelpline
Helpline
If you have any difficulty with your appliance, do not hesitate to call us. We’re more likely able to help than the store from where you bought it.
Please have the following information ready to enable our staff to deal with your query quickly.
Name of the product
Model number as shown on the
underside of the appliance.
Serial number as shown on underside
of the appliance.
BLENDER 13/8/02, 12:26 PM5
Page 6
Your two year
○○○○○○○○○○○○○○○○○○○○○○
guarantee
It is important to retain the retailers receipt as proof of purchase. Staple your
receipt to this back cover for future reference.
Please quote the following information if the product develops a fault. These numbers can be found on the base of the product.
Model No. Serial No.
All Morphy Richards products are individually tested before leaving the factory . In the unlikely event of any appliance proving to be faulty within 28 days of purchase it should be returned to the place of purchase for it to be replaced.
If the fault develops after 28 days and within 24 months of original purchase, you should contact the Helpline number quoting Model number and Serial number on the product, or write to Morphy Richards at the address shown. Y ou will be asked to return the product (in secure, adequate packaging) to the address below along with a copy of proof of purchase. Subject to the exclusions set out below (see ‘Exclusions’) the faulty appliance will then be repaired or replaced and dispatched usually within 7 working days of receipt.
If for any reason this item is replaced during the 2 year guarantee period, the guarantee on the new item will be calculated from original purchase date. Therefore it is vital to retain your original till receipt or invoice to indicate the date of initial purchase.
T o qualify for the 2 year guarantee the appliance must have been used according to the manu­facturers instructions. For example kettles should have been regularly descaled.
EXCLUSIONS
Morphy Richards shall not be liable to replace or repair the goods under the terms of the Guarantee where: 1 The fault has been caused or is attributable
to accidental use, misuse, negligent use or
used contrary to the manufacturers
recommendations or where the fault has
been caused by power surges or damage
caused in transit. 2 The appliance has been used on a voltage
supply other than that stamped on the
products. 3 Repairs have been attempted by persons
other than our service staff (or authorised
dealer). 4 Where the appliance has been used for hire
purposes or non-domestic use. 5 Morphy Richards are not liable to carry out
an y type of servicing work, under the
guarantee. 6 Plastic filters for all Morphy Richards kettles
and coffee makers are not covered by the
guarantee.
This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer.
This guarantee is valid in the UK and Ireland
only.
The After Sales Division, Morphy Richards Ltd, Mexborough, South Yorkshire, England, S64 8AJ
Helpline (office hours) UK 0870 060 2612 Republic of Ireland 1800 409119
Morphy Richards products are intended for household use only.
Morphy Richards has a policy of continuous improvement in product quality and design. The Company, therefore, reserves the right to change the specification of its models at any time.
444/8502/80 Rev 2
BLENDER 13/8/02, 12:26 PM6
Loading...