2 & 4 slice coolwall toaster
Two year guarantee
This guarantee is valid in the UK and Ireland
only. It is in your interest to retain the retailers receipt
as proof of purchase. Please quote the following
information if the product develops a fault. These
numbers can be found on the base of the product.
Model No. Serial No.
All Morphy Richards products are individually tested
before leaving the factory. In the unlikely event of any
appliance proving to be faulty within 28 days of
purchase it should be returned to the place of purchase
for it to be replaced.
If the fault develops after 28 days and within 24
months of original purchase, you should contact the
Helpline number quoting Model number and Serial
number on the product, or write to the address below.
You will be asked to return the product (in secure,
adequate packaging) to the address below along with a
copy of proof of purchase. Subject to the exclusions
set out below (see ‘Exclusions’) the faulty appliance will
then be repaired or replaced and dispatched usually
within 7 working days of receipt.
If for any reason this item is replaced during the 2
year guarantee period, the guarantee on the new item
will be calculated from original purchase date. Therefore
it is vital to retain your original till receipt or invoice to
indicate the date of initial purchase.
To qualify for the 2 year guarantee the appliance
must have been used according to the
The After Sales Division, Morphy Richards Ltd, Mexborough, South Yorkshire, England, S64 8AJ Helpline (office
hours ): UK (local rate) 08450 777700, Republic of Ireland 1800 409119
Morphy Richards Website : www.morphyrichards.co.uk
manufacturers instructions. For example the crumb
tray should be emptied regularly as recommended by
the instructions.
EXCLUSIONS
Morphy Richards shall not be liable to replace
or repair the goods under the terms of the
Guarantee where:
1 The fault has been caused or is attributable to
accidental use, misuse, negligent use or used
contrary to the manufacturers recommendations
or where the fault has been caused by power
surges or damage caused in transit.
2 The appliance has been used on a voltage
supply other than that stamped on the
products.
3 Repairs have been attempted by persons other
than our service staff (or authorised dealer).
4 Where the appliance has been used for hire
purposes or non-domestic use.
5 Morphy Richards are not liable to carry out any
type of servicing work, under the guarantee.
This guarantee does not confer any rights other
than those expressly set out above and does not cover
any claims for consequential loss or damage. This
guarantee is offered as an additional benefit and does
not affect your statutory rights as a consumer.
Important Safeguards
○○○○○○○○○○○○○○○○○○○○○
When using electrical appliances,
basic safety precautions should always
be followed, including the following:
1 Read all the instructions.
2 Do not touch hot surfaces. Use
handles or knobs.
3 To protect against fire and risk of
electrical shock do not immerse cord,
plug or toaster itself in water or other
liquid.
4 Ensure that this appliance is situated
out of reach of children.
NEVER allow a child to use this
product.
5 Unplug from the socket when not in
use and before cleaning. Allow to
cool before putting on or taking off
parts.
6 Do not operate any appliance with a
damaged plug, or after an appliance
ha s malfunctioned, or has been
dropped or damaged in any way.
Contact Morphy Richards for advice
on examination, repair or electrical
or mechanical adjustment.
This appliance contains no user
serviceable parts.
7 The use of attachments or tools not
recommended or sold by Morphy
Richards may cause fire, electric
shock or injury.
8 Do not use outdoors.
9 Do not let the mains lead overhang
the edge of the table or worktop, or
touch hot surfaces.
10DO NOT PLACE THE APPLIANCE
ON OR NEAR A HOT GAS OR
ELECTRIC HOB, OR IN A HEATED
OVEN.
11 Do not attempt to move the appliance
whilst hot.
12When unplugging turn any control to
off, then remove plug from wall socket.
13Do not use appliance for other than
intended use.
14Preheating of this appliance is not
required.
15DO NOT TOUCH THE METAL TOP OF
THE TOASTER DURING OR AFTER
USE AS THIS GETS VERY HOT .
16ENSURE THAT SUFFICIENT SP ACE
IS LEFT ABOVE AND AROUND ALL
SIDES OF YOUR TOASTER TO
ALLOW AIR TO CIRCULA TE. PLACE
THE TOASTER ON A HEA T
RESIST ANT SURFACE. DO W A TCH
YOUR TOASTER DURING USE. A
FIRE MAY OCCUR IF T OASTERS ARE
COVERED OR TOUCHING
FLAMMABLE MA TERIAL, INCLUDING
CURT AINS, DRAPERIES, WALLS
ETC, WHEN IN OPERATION.
17Do not use underneath cupboards.
18Oversize foods, metal foil packages, or
utensils must not be inserted into a
toaster, as they may involve a risk of
fire or electric shock.
19Do not attempt to dislodge food when
toaster is plugged in and never
introduce cooking utensils into the
slots.
20Do not place bread or other items on
top of the bread slots as this will
damage your toaster and creates a
fire hazard.
If your toaster does not work, check the
following points:
21 Has the toaster been set correctly - is
the plug in its socket and the switch in
the ‘on’ position?
22Is the plug itself or the socket faulty -
check this by plugging in another
appliance.
23Does the fuse need replacing - if you
have fitted your own plug, are the
internal plug connections secure and
correctly made?
24Do not lift or move the toaster by
inserting fingers in bread slots.
SAVE THESE INSTRUCTIONS
2
Electrical Requirements
○○○○○○○○○○○○○○○○○○○○○○
Instructions for use
○○○○○○○○○○○○○○○○○○○○○
Check that the voltage on the rating plate of
your appliance corresponds with your house
electricity supply which must be A.C.
(Alternating Current).
If the socket outlets in your home are not
suitable for the plug supplied with this appliance the plug should be removed and the
appropriate one fitted.
IMPORT ANT : THE PLUG REMOVED
FROM THE MAINS LEAD, IF SEVERED, MUST BE
DESTROYED AS A PLUG WITH BARED
FLEXIBLE CORD IS HAZARDOUS IF ENGAGED
INTO A LIVE SOCKET OUTLET .
If you use a 13 amp BS1363 plug, a 13 amp
BS1362 fuse must be fitted.
WARNING : THIS APPLIANCE MUST BE
EARTHED.
Features of your toaster
○○○○○○○○○○○○○○○○○○○○○○○○
Removable crumb tray
Electronic variable browning control
Cord storage
Cancel button
Bread carriage lever/high lift feature
Bread slots
Bun warmer (certain models only)
Please read before use, taking careful
note of points 1 and 2.
1 Use your toaster once without bread. This
will pre-heat the new elements and burn
off any dust which may have accumulated
during storage.
2 Select the desired level of browning on the
browning control
marked 1 to 8. The
setting required will
vary according to the
moisture content and
thickness of bread.
For best results ensure that the bread
slices are of even thickness, freshness
and size. Remember that stale bread
toasts more rapidly than fresh and thin
bread toasts quicker than thick. See
additional points for more information.
3 After selecting the desired level, place
your bread in the slots and depress the
bread carriage lever downwards until it
locks.
Note: The bread carriage lever will not
stay down unless the toaster is plugged in
and the wall switch is on.
4 After the set degree of browness
has been reached the bread will pop-up
automatically ready for removal from the
slots.The bread carriage lever will have
returned to its upper position and the
heating element will have switched off,
ready for the next toasting.
• In the case of frozen bread you should set
the browning level one number higher than
you would normally select for fresh bread.
• If the first slices are not dark enough turn
the browning control to a higher setting.
• If the bread in your toaster becomes
jammed disconnect your toaster at
the socket, allow it to cool, then
remove the bread.
• When not in use, switch your toaster off at
the mains and remove the plug from the
socket. DO NOT WRAP THE CABLE
AROUND THE MAIN BODY OF THE
APPLIANCE DURING OR AFTER USE. THE
CABLE STORAGE AREA UNDERNEA TH
THE TOASTER SHOULD BE USED.
3
Using the cancel setting
If you wish to interrupt the toasting
process, press the cancel button.
Using the high lift release
If small bread is toasted, this may be
removed more easily by lifting the bread
carriage lever.
Using the bun warmer
○○○○○○○○○○○○○○○○○○○○○
Clip the bun rack onto the top of the toaster,
ensuring it is securely placed. Set the
browning control to between 1 and 3. Depress
the bread carriage lever until it holds down.
Wait for the
toaster to
switch off
automatically or
press the cancel
button to switch
the toaster off
before removing
the buns. Take care not to touch the metal of
the bun rack this will be hot.
Additional points
○○○○○○○○○○○○○○○○○○○○○○○
• In order to achieve uniform browning, we
recommend you wait a minimum of 30
seconds between each toasting, so that the
control can automatically be reset.
• If toasting in one slot only, you may need to
adjust the browning control to a slightly
lower setting.
• Note you will also notice a slight
variation in toast colour on one side of a
single slice.
• Stale bread toasts more rapidly than fresh
bread. Therefore, the browning control
should be set at a lower setting than usual.
• All sorts of bread can be used as well as
teacakes, small rolls etc. Slices should not
however be so thick as to cause burning or
jamming within the bread slots.
• When toasting 2 slices or more it is
recommended they are of equal size and
freshness.
• Allow the toaster to cool fully before putting
away.
Cleaning and Maintenance
○○○○○○○○○○○○○○○○○○○○○
1 After use and before cleaning, switch off
at the mains, remove the plug from the wall
socket and wait for the toaster to cool.
2 Wipe the outside of the toaster with a damp
cloth only and dry with another cloth or
tissue.
• NEVER use metal polish or coarse scouring
agents and never immerse your toaster in
any sort of liquid.
• NEVER use any pointed or sharp articles
for cleaning the inside, otherwise the
heating element will be damaged.
• NEVER use a brush or push your fingers or
metal objects down the slots.
Crumb tray
○○○○○○○○○○○○○○○○○○○○○
Crumbs will accumulate in the crumb tray
and could catch fire if not emptied periodically.
When the toaster has cooled down completely,
tap the sides of the case lightly to dislodge any
crumbs lodged in the toasting chamber and pull
out the crumb tray .
Empty the tray and
replace it.
Never operate the
toaster without
the crumb tray
fitted.
Morphy Richards has a policy of continuous improvement in product quality and design.
Morphy Richards products are intended for household use only.
The Company, therefore, reserves the right to change the specification of its models at any time.
Morphy Richards Limited, Mexborough,
444/8503/01 Rev 1
South Yorkshire, England, S64 8AJ
Loading...