Mopar 2005-2009 Chrysler 300C Installation Instructions Manual
Audio System Upgrade Package
2005-2009 Chrysler 300C
Installation Instructions
TOOLS REQUIRED:
*Phillips Screwdriver *10mm Nut Driver *10mm Socket *Ratchet *Three Inch Putty Knife
*Panel Removal Tool *10mm Wrench
1EA. SUBWOOFER ASSEMBLY P/N 05290522AB
1EA. 100 WATT AMP ASSEMBLY P/N 05290521AA
1EA. WIRE HARNESS P/N RBI05300CSUB
1EA. M6 BOLT P/N RFM6
1EA. BODY CLIP P/N 06508613AA
1EA. INSTRUCTIONS P/N RBI05MAGSUB
6EA. WIRE TIES P/N RFZIP6
4EA. #8 SHEET METAL SCREWS P/N RFS2
CONTENTS:
77KICK02 9/22/2008 Page 1 of 7
© 2007, Chrysler, LLC. Mopar is a registered trademark of Chrysler, LLC. All rights reserved.
Audio System Upgrade Package
2005-2009 Chrysler 300C
Installation Instructions
1. Remove the lower rear seat cushion by pulling up on the front edge.
2. Fold rear seat backs into the down position.
3. Remove the 10mm bolt securing the side portions of the seat. Fig. 1
4. Release the spring clip on the back of the side cushion. Insert a putty knife behind the side cushion
and push down firmly while pulling forward on the cushion. Fig. 2
Fig. 2
Fig. 1
Fig. 2
5. To remove the rear package tray, first remove the plastic retainer in the center. Remove the
package tray by pulling it away from the rear glass. Fig. 3
6. If the car is equipped with a eight speaker Boston Acoustics® system find the subwoofer mounted in
the rear deck and remove the four screws securing it in place. Save the screws for reinstallation
later.
7. If the car is not equipped with the Boston Acoustics® system the hole will be covered by a self-
adhesive sound damping material. Remove the damping material and save for reinstallation later.
Fig. 4
Fig. 3 Fig. 4
77KICK02 9/22/2008 Page 2 of 7
© 2007, Chrysler, LLC. Mopar is a registered trademark of Chrysler, LLC. All rights reserved.
Audio System Upgrade Package
2005-2009 Chrysler 300C
Installation Instructions
8. Install the amplifier assembly in the hole in the rear deck. Fig. 5
9. Secure the amplifier assembly using the previously removed screws. Screws (#8 sheet metal) are
provided for cars not equipped with the factory subwoofer. Fig. 6
Fig. 5 Fig. 6
10. Replace the sound damping material (if so equipped) over the amplifier assembly. Fig. 7
11. Remove the six plastic retainers securing the large panel directly below the package tray and
remove the panel from the trunk. Fig. 8
Fig. 7
Fig. 8
77KICK02 9/22/2008 Page 3 of 7
© 2007, Chrysler, LLC. Mopar is a registered trademark of Chrysler, LLC. All rights reserved.
Loading...