Combined Effects Pedal
Precautions
Power Supply
Use the correct AC outlet to connect the power adapter. Use a power transformer with a negative external voltage
of 9V (± 10%) ≥300mA, otherwise it will cause equipment damage, fire or other problems. When unused or thunderstorms please unplug
the power supply.
Connections
Before connecting the device or disconnecting it, be sure to turn off the power and other equipment, which will help to avoid malfunction and damage to other equipment. Also, make sure that all cables and power cords are disconnected before moving the unit.
Place the place
To prevent deformation, discoloration, and other serious damage, avoid the following:
Direct sunlight |
Near heat source |
Magnetic field |
High temperature and humidity |
Dusty or unclean place |
Humidity is large |
Strongly vibrating or shakin |
|
Electrical interference
When using the unit, the radio and the TV may cause interference. Use the unit away from the radio and the TV.
Clean
Please use a dry, soft cloth to clean the unit. If necessary, wipe with a slightly moist cloth. Do not use rough clean powder, alcohol, paint thinner, wax, solvent, detergent and chemical agents such as impregnated wipes.
Operating
Do not use brutal forces to use switches and control elements.
Do not allow paper, metal, and other objects to fall into the machine. Be careful not to fall, do not subject it to shock and excessive pressure.
FCC certification
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
that may cause undesired operation.
Main Features
6 effects pedals built into 1 simple unit. Boost, Overdrive, Distortion, modulation, Delay, Reverb
Full featured controls for each effect
Built in precision guitar tuner
Tap tempo synchronization
Integrated effects loop for connecting external pedals or 4 cable method connection with an amplifier
Stereo outputs
Dedicated direct output with speaker simulation for connection to a mixing desk, computer or headphones
Includes a carry case for easy transportation
Pedal Layout
DISPLAY SCREEN
TAP Footswitch
Footswitch 1 - 5
TAP: Press several times for tap tempo. Hold for Tuner
Footswitch 1: REVERB on/off in LIVE mode. Preset 1 in PRESET mode Footswitch 2: DELAY on/off in LIVE mode. Preset 2 in PRESET mode Footswitch 3: MOD on/off in LIVE mode. Preset 3 in PRESET mode Footswitch 4: DIST on/off in LIVE mode. Preset 4 in PRESET mode Footswitch 5: DRIVE on/off in LIVE mode. Preset 5 in PRESET mode
DISPLAY SCREEN: Displays the current operation mode of red truck. Displays the tuner when activated
Operation Modes
Redtruck has two different operation modes. LIVE MODE and PRESET MODE
To change operation mode, simultaneously press and release TAP + Footswitch 1
Live Mode
In this mode Redtruck operates like a traditional pedalboard. Each footswitch will switch it’s respective effects module on and off.
The DISPLAY SCREEN will display <L> when in Live Mode
Preset Mode
In this mode Redtruck operates like a pedalboard loop switcher. Each footswitch will recall a preset combination of which effect modules are on/off.
The DISPLAY SCREEN will display <P> when in Preset Mode
To create a preset:
1.Ensure Redtruck is in LIVE MODE
2.Activate the effect modules you want to use in your preset
3.Press and hold the corresponding footswitch where you wish to save the preset for use in Preset mode
4.The Footswitch light will flash 5 times to confirm that the preset has been saved to this footswitch
5.After you have saved your presets, put the Redtruck into PRESET MODE and press any footswitch from 1-5 to recall it’s preset.
Note: Effect parameters can not be stored to the presets. Only the on/off state of each effect module will be stored.