Monument 217A12, 217D12, 217B12, 217C12, 217E12 Owner's Manual

OWNER’S MANUAL

& INSTALLATION INSTRUCTIONS

www.getmonument.com

MODEL 217 (217A12 / 217B12 / 217C12 / 217D12 / 217E12)

MONUMENT PHOTO MANAGEMENT DEVICE

217-US-ENG-REV01

WARRANTY

FULL 1-YEAR WARRANTY

If this product fails due to a defect in material or workmanship within one year from
the date of purchase, Monument Labs will at its option repair or replace it free of
charge. Shipping costs are not covered.

WARRANTY RESTRICTIONS

There are no customer-serviceable parts inside this device. Do not attempt to repair
this unit yourself. Doing so may void the warranty and can cause damage to the device
or personal injury to yourself.

This warranty applies only while this product is in use in the United States. This war­ranty gives you specific legal rights, and you may also have other rights depending on
your state of residence. For additional Monument Labs warranty information, please
visit our web site at www.getmonument.com/warranty.

Keep these instructions and your sales receipt for future reference.

Copyright © 2016 Monument Labs, Inc.
www.getmonument.com

605 N. Michigan Ave., 4th Floor
Chicago, IL 60611

ELECTRICAL REQUIREMENTS

In the United States, a 115 V, 60 Hz AC-only electrical supply is required. The included
power supply can operate between 100-240 V AC, and provides 5 V DC power to the device
with sufficient power to simultaneously operate two USB-based external portable drives
(not included). The power provided for each drive is limited to 500 mA. If your external port­able drive requires more power, you will need to externally power it per its manufacturer’s
instructions and recommendations.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed
to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or
transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF
exposure compliance.

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.

To maintain compliance with the RF exposure guidelines, place the unit at least 20cm from nearby persons.
Mise en garde: Pour assurer la conformité aux directives relatives à l’exposition aux fréquences radio, le jouet doit êtreplacé à au moins 20cm des
personnes à proximité.

FCC NOTICE (USA)

IC NOTICE (CANADA)

SAFETY REQUIREMENTS

IMPORTANT SAFETY INSTRUCTIONS

1. Do not immerse the device in water or other liquids.

2. Do not use the device near water or in damp locations such as near bathtubs or a wet

basement.

3. Do not use the device if the power supply has been damaged.

4. Do not use a power supply other than the one provided by Monument Labs.

5. Do not insert foreign objects into the device.

6. Do not use the device if it malfunctions or has been damaged. Return the device to

the manufacturer for examination, electrical, or mechanical repairs. See WARRANTY
section.

7. Do not block air vents, or place the device on a soft surface such as a bed or a sofa as
this can block vent openings. Do not place objects on top of the device as this can also
block vent openings.

8. Do not store external portable drives in the drive storage bay if any of the drives are
externally-powered or damaged.

WARNING: