Monster 190070 00, 190069 00 User Manual

Monster Cable Products Inc.

Wireless Ipod Audio System User guide

Setup Instructions:

The Monster model # 190070-00 Audio Bridge Transmitter is your own personal digital audio link between
your Apple Ipod and your Home stereo system when equipped with the Monster model # 190069-00
Audio Bridge Receiver.

1. Plug the DC plug of the AC adapter to the DC input jack of the Audio Bridge Receiver.

2. Connect the stereo audio output jack of the Audio Bridge Receiver to the audio line input of your home
entertainment system.

3. Plug the AC adapter to an AC outlet.

4. Plug the Audio Bridge Transmitter to the Apple Ipod.

5. Press the PLAY button on your Apple Ipod to initiate operation of the system.

6. Adjust the volume control of your home audio system to suit.

7. Note that an LED flashes on the transmitter unit while it is operating.
For best results, keep within 30 feet operating distance between transmitter and receiver.

* Apple Ipod is a registered Trademark of Apple Computer, Inc.

Additional information is available at www.monstercable.com.

Warranty does not include malfunction caused by accident, misuse , contac t with solvent chemicals or

malfunction caused by tampering or modification. Th is wa rranty excludes all incidental or consequentia l
damages. Some states do not allow the exclusion or limitation of consequential damages so the above
limitation may not apply to you.

For Warranty Service, the product must be returned at your expense to place of purchase. Return
policies may vary. If you cannot reasonably do this, please contact us stating the nature of the defect and
date of purchase. Include a copy of your sales slip or proof of purchase. Your repaired or replacement
equipment will be returned to you at our expense. This warranty gives you specific rights: you may also
have other legal rights which vary from state to state.

FCC Notice: This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, includin g interference that may cause undesired operation. The installer of this radio

equipment must ensure that the antenna is located or pointed such that it does not emit RF field in excess
of Health Canada limits for the general population; consult Safety Code 6, obtainable from Health
Canada’s website www.hc-sc.gc.ca/ Caution: changes or modifications not expressly approved by Monster

Cable Products Inc. may void the users authority to operate this device.
Note: This equipment has been tested and found to co mply with the limits for a class B digital device

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protec tion against
harmful interference in a resident ial installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by tuning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

 Reorient or relocate the receiving antenna
 Increase the separation between the equipment and receiver
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
 Consult the dealer or an experienced radio/TV technician for help.

Monster Cable Products, Inc.
455 Valley Drive Brisbane, CA 94005
Phone [phone]

Audio Bridge Receiver FCC ID: RJE190069-00 IC: 5153A-19006900
Audio Bridge Transmitter FCC ID: RJE190070-00 IC: 5153A-19007000