Monarch Renegade 9491 User Manual
USING THE 9491™ BOOT KIT
The Monarch® Renegade® 4 printer’s boot protects it if you accidentally
drop it, hit it against something, or jar it in some other manner. Following
is an illustration of the boot on the printer.
Contents of the Boot Kit
The boot kit comes with:
♦ the boot.
♦ two knobs.
♦ two white spacers to use with the knobs.
♦ two black spacers and two screws (industrial version printer only).
TC9491BT Rev. AC 11/00 ©1999 Monarch Marking Systems All Rights Reserved.
Putting the Boot on the Printer
Spacer
To put the boot on the printer:
1. Industrial Version Only. Remove the cable from the side of the
printer. Save the cable’s screws for when you want to use the
printer without the boot.
2. Unscrew the screw assemblies at the top of the printer (either
shoulder strap is optional), and take them off. Save them for when
you want to use the printer without the boot.
3. Pull on the boot and fit it around the printer.
4. With Shoulder Strap Only. For both sides of the printer, put
together the knob assembly and screw it into the threaded insert.
Do not over-tighten the assembly.
White
Using the Old Strap Using the New Strap
2 Using the 9491 Boot Kit
Loading...