LP45546
XD Lift
for Lawn and Garden Tractors and EZtrak™ Mowers
Instructions for Assembly and Operation
Ver. 010213
Introduction
This manual contains assembly, parts, operating, maintenance, adjustment and safety instructions for your lawn and garden tractor and EZtrak™ mower lift.
BEFORE USING YOUR LIFT, CAREFULLY READ THIS MANUAL IN ITS ENTIRETY.
By following these operating, maintenance and safety instructions, you will prolong the life of your lift and promote safe operation.
If additional information is needed, or should you require a trained service mechanic, contact your authorized John Deere Dealer or call 1-877-575-3173.
All lift parts are thoroughly tested and inspected before leaving the factory to ensure that they comply with all relevant safety standards.
NOTE: Please save this manual for future reference.
NOTE: Location of unit Serial Number.
Need Assistance?
Please DO NOT return this product to the store.
Our Customer Service Department is ready to help!
1-877-575-3173
Submit your questions online at:
www.theMoJack.com
Patent pending.
2
Warnings and Safety Instructions
Read and understand all safety and operating instructions before using the mower lift.
Never allow anyone unfamiliar with the safety or operating instructions to use the lift.
Follow all safety and servicing instructions provided by the lawn mower’s manufacturer before using the lift.
Do not modify the lift in any way. Any modifications will void any and all warranties and could compromise your personal safety.
When using the lift, keep ALL bystanders at a safe distance away from the mower lift.
The lift must be used on a solid level surface.
Only lift the FRONT end on the mower.
Do not lift the front end and back end of the mower at the same time.
Only use the lift for mowers that are less than 500lbs (226 kg) front end weight and properly fits in the provided wheel pads. (ie. 10” to 17” diameter and within outside wheel measurements of 31.5” to 62.5”).
Always stop engine and remove key before beginning any work on the mower.
Always place mower in neutral or disengage the hydraulic drive by following the mower owner’s manual.
Never operate the engine while using the mower lift.
Do not exceed the lifting capacity of 500 lbs. (226 kg) front end weight. If you have a question regarding weight of your machine, please contact the manufacturer at 1-877-575-3173 or a local John Deere Dealer.
If the lift Tower is leaning while lifting or lowering the mower, this indicates an overload condition.
REMOVE THE MOWER IMMEDIATELY.
Tower must be secured in place with the Tower Clevis Pin before using the lift.
Carrier Locking Handle must be locked into Tower before starting any service on mower.
Do not remove safety warnings or decals from lift.
Before each use, always check for any worn, loose or damaged parts on the lift. If any damaged parts are present, do not use the lift and consult a John Deere Dealer or distributor.
Do not climb on mower while it is lifted, being lifted or being lowered.
No one should be on the mower while it is lifted, being lifted or being lowered.
After the mower is raised to a working height, always place wheel chocks (not included) behind the back tires of the mower.
Wheel Pads must be equal distance from the Lift Arm to maintain proper balance.
Always secure front mower tires with enclosed safety straps.
Remove all mower attachments before using the lift. Remove all front mower attachments (ballast, bumper or brush guard) that interferes with handle before using the lift.
Some mowers which are equipped with a fuel tank vent may spill fuel when lifted. If this happens, run fuel level down in the tank to prevent spilling.
Always use proper personal protection equipment.
Failure to follow these warnings may result in property damage and serious bodily injury or death.
IMPORTANT: The mower lift is intended for use with mowers only. Do not exceed 500 lbs. (226 kg) front end weight. It should never be used to service other types of machinery unless there is an approved accessory fitted for the type of machinery. Please consult your local John Deere Dealer or distributor.
3
Warnings and Safety Decals
CAUTION: Avoid injury!
This symbol and text highlight potential hazards or death to the operator or bystanders that may occur if the hazards or procedures are ignored.
NOTE: There can be additional safety information contained on parts and components sourced from suppliers that is not reproduced in this instruction manual.
4
Warranty and Returns
LIMITED WARRANTY
For two years for residential use and one year for commercial use MoJack warrants the product against failure due to defect in material or workmanship when product is used properly. MoJack will replace any defective part at no cost. This warranty does not cover any product that has been altered or adjusted, or any product that has been misused or abused. THIS IS THE CUSTOMER’S SOLE AND EXCLUSIVE REMEDY. MOJACK DISCLAIMS ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. MOJACK SHALL NOT BE LIABLE FOR ANY INCIDENTIAL OR CONSEQUENTIAL DAMAGES. SOME STATES OR PROVINCES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF THE IMPLIED WARRANTIES OR THE REMEDIES FOR BREACH OF THE IMPLIED WARRANTIES, SO THESE EXCLUSIONS MAY NOT APPLY TO YOU. THIS LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE OR PROVINCE TO PROVINCE.
What does this warranty cover?
This warranty covers against a failure due to a defect in material or workmanship within two years of purchase for residential use and within one year of purchase for commercial use.
What does this warranty NOT cover?
This warranty does not cover any jack which has been altered or adjusted in any way from its original model. It will not cover any jack which has been damaged due to misuse, abuse, accident or negligence. This warranty does not cover incidental or consequential damages.
What is the period of coverage?
Two-year warranty for residential use, one-year for commercial use from date of purchase for the original owner.
What will MoJack do to correct problems?
We will replace any defective part (within the coverage period) at no charge.
How can I get service?
In order to be eligible for service under this warranty you MUST register your jack within thirty (30) days of purchasing.
You must keep your receipt as proof of date of sale. You can register your new jack on our website at www.themojack.com or by calling our toll-free number 1-877-575-3173.
How do I contact MoJack about a warranty issue?
You can contact us from our website at www.themojack.com or by calling our toll-free number 1-877-575-3173.
Do I have other rights under State Law?
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
What is the return policy?
Within thirty (30) days of the date that you receive your jack. Please contact MoJack for return policies and procedures at our toll-free number 1-877-575-3173 or by email at info@themojack.com.
How do I make a return?
Contact us within the return period. We will issue you a Return Merchandise Authorization (RMA) to place on the outside of the box. All merchandise must be shipped back in its original packaging. We will make arrangements for the jack to be picked up by a national carrier.
In what form will I receive my refund?
This is at our discretion. If receiving a refund, please allow four weeks for the credit to process to your account. Return service fees will be deducted from the amount of the refund.
Are shipping charges refundable?
No.
Does MoJack have a return service fee policy?
Yes. Returns and refunds impose an extra workload on our parts. Rather than pass this cost on to the customer through higher product prices, we are consistent with others within our industry by requiring nominal service fees in the event of returns. The service fee is 20%.
How do I contact MoJack?
You can call our toll-free number 1-877-575-3173 or by email at info@themojack.com.
5
Parts List
Item |
|
|
|
|
|
No. |
Qty. |
Description |
|
|
|
1 |
1 |
Tower |
|
|
|
2 |
1 |
Lift Arm |
|
|
|
3 |
1 |
Base |
|
|
|
4 |
2 |
Wheel |
|
|
|
5 |
2 |
Wheel Pads |
|
|
|
Item
No. Qty. Description
62 Lift Arm Inserts
71 Grip Handle
81 Crank Handle
92 Support Rod
10 |
2 |
Safety Strap |
8
7
Carrier
6 2
6
1
10
10
5
5
4
4
9
9
3
6
Hardware List
Item
No. Qty. Description
111 Cap Screw M12-1.75 X 80
122 Cap Screw M12-1.75 X 65
132 Carriage Bolt M8-1.25 X 20
143 Nylock Nut – M12-1.75
152 Nylock Nut – M8-1.25
164 Push Pin
171 Clevis Pin
183 Large Hair Pin
14 Nylock Nut – |
15 Nylock Nut – |
M12-1.75 |
M8-1.25 |
17 Clevis Pin
11Cap Screw M12-1.75 X 80
12Cap Screw M12-1.75 X 65
13 Carriage Bolt M8-1.25 X 20
Tools Needed for Assembly
19mm Wrench (2) |
17mm Wrench (1) |
13mm Wrench (1) |
7
Assembly Instructions
STEP 1
Remove jack from package.
Inventory items to be certain all parts and hardware
are present. If you have any questions regarding assembly, please call manufacturerat 1-877-575-3173 or
email at parts@themojack.com.
STEP 2 |
|
|
|
|
|
|
|
|
Assemble the Wheel 4 |
to the Base 3 |
|
|
|
|
Cap Screw 12 |
||
by inserting Cap Screw |
12 and Nylock Nut and |
14 |
|
|
|
|
|
|
tighten. Repeat with second Wheel. |
|
|
|
|
|
|
||
|
|
|
|
|
|
|||
Note: Do not over tighten Nylock Nut to allow |
|
|
|
|
|
|
||
the wheels to roll easily. |
|
|
|
|
|
|
||
|
|
Base 3 |
|
|
|
Nylock Nut 14 |
||
|
|
|
|
|
|
|||
|
|
|
|
|
|
|
Wheel 4 |
|
|
|
|
|
|
|
|
|
|
STEP 3 |
|
|
|
|
|
|
11 Cap Screw |
|
Attach the Tower 1 to the Base 3 using |
Tower |
1 |
|
|
|
|
||
|
|
|
|
|||||
|
|
|
|
|
|
|||
Cap Screw 11 and Nylock Nut 14 as shown. |
|
|
|
|
|
|
||
Note: Do not over tighten Nylock Nut to allow |
Nylock Nut 14 |
|
|
|
||||
the unit to fold and unfold easily. |
|
|
|
Base 3
8