MINN KOTA i-Pilot Link Installation Manual
InstallatIon GuIde
2 3
minnkotamotors.com
minnkotamotors.com
INSTALLATION GuIde
PARTS LIST VIEW TERROVA & RIPTIDE ST
ITEM #PART
NUMBER DESCRIPTION QTY
TERROVA
1 2990280 HEAD ASSY,TERROVA, IP2 1
2 2994180 REMOTE ASSY, i-PILOT LINK 1
3 2370712 BATTERY, LIPO PACK 1
4 2374637 O-RING, BATTERY SEAL 1
5 2376421 DOOR, BATTERY 1
6 2383442 SCREW-3MM X .5 PPH MACHINE 4
7 2994907 BAG ASSY, i-PILOT LINK,TRRV 1
8 2372100 SCREW-#8-18 X 5/8 THD* (SS 4
9 2370817 LANYARD,RMT w/CARABINER 1
10 2224704 INSERT-PLUG, BLK, i-PILOT LINK 1
11 2376312 TIE WRAP,BLACK,UV RESIST.NYLON 5
12 2994909 BAG ASSY, i-PILOT LINK, POWER 1
13 2373241 CABLE, USB REMOTE CHARGER 1
14 2375900 ADAPTER, USB POWER PORT 1
15 2377156 MANUAL-CD, i-PILOT LINK 1
16 2377155 MANUAL QCK REF, i-PILOT LINK 1
17 2320203 CAP-DUST,CONNECTOR,FEMALE 1
18 490389-1 CABLE, ETH (M12-M-M12-F, 30’ 1
RIPTIDE ST
1 2990281 HEAD ASSY, ST, IP2 1
2 2994180 REMOTE ASSY, i-PILOT LINK 1
3 2370712 BATTERY, LIPO PACK 1
4 2374637 O-RING, BATTERY SEAL 1
5 2376421 DOOR, BATTERY 1
6 2383442 SCREW-3MM X .5 PPH MACHINE 4
7 2994907 BAG ASSY, i-PILOT LINK,TRRV 1
8 2372100 SCREW-#8-18 X 5/8 THD* (SS 4
9 2370817 LANYARD,RMT w/CARABINER 1
10 2224704 INSERT-PLUG, BLK, i-PILOT LINK 1
11 2376312 TIE WRAP,BLACK,UV RESIST.NYLON 5
12 2994909 BAG ASSY, i-PILOT LINK, POWER 1
13 2373241 CABLE, USB REMOTE CHARGER 1
14 2375900 ADAPTER, USB POWER PORT 1
15 2377156 MANUAL-CD, i-PILOT LINK 1
16 2377155 MANUAL QCK REF, i-PILOT LINK 1
17 2320203 CAP-DUST,CONNECTOR,FEMALE 1
18 490389-1 CABLE, ETH (M12-M-M12-F, 30’ 1
4 5
minnkotamotors.com
minnkotamotors.com
INSTALLATION GuIde
PARTS LIST VIEW POWERDRIVE V2 & RIPTIDE SP
ITEM #PART
NUMBER DESCRIPTION QTY
POWERDRIVE V2
1 2990282 HEAD ASSY, V2, IP2 1
2 2994180 REMOTE ASSY, i-PILOT LINK 1
3 2370712 BATTERY, LIPO PACK 1
4 2374637 O-RING, BATTERY SEAL 1
5 2376421 DOOR, BATTERY 1
6 2383442 SCREW-3MM X .5 PPH MACHINE 4
7 2994908 BAG ASSY, i-PILOT LINK, V2 1
8 2372100 SCREW-#8-18 X 5/8 THD* (SS 4
9 2370817 LANYARD,RMT w/CARABINER 1
10 2376716 PLUG, STRAIN RELIEF V2/SP 1
11 2332104 SCREW-1/4-20 X 5/8 S/S 2
12 2376312 TIE WRAP,BLACK,UV RESIST.NYLON 5
13 2375403 HEATSHRK .375X2 ADHV LINED 4
14 2994909 BAG ASSY, i-PILOT LINK, POWER 1
15 2373241 CABLE, USB REMOTE CHARGER 1
16 2375900 ADAPTER, USB POWER PORT 1
17 2377156 MANUAL-CD, i-PILOT LINK 1
18 2377155 MANUAL QCK REF, i-PILOT LINK 1
19 490389-1 CABLE, ETH (M12-M-M12-F, 30’ 1
RIPTIDE SP
1 2990283 HEAD ASSY, SP, IP2 1
2 2994180 REMOTE ASSY, i-PILOT LINK 1
3 2370712 BATTERY, LIPO PACK 1
4 2374637 O-RING, BATTERY SEAL 1
5 2376421 DOOR, BATTERY 1
6 2383442 SCREW-3MM X .5 PPH MACHINE 4
7 2994908 BAG ASSY, i-PILOT LINK, V2 1
8 2372100 SCREW-#8-18 X 5/8 THD* (SS 4
9 2370817 LANYARD,RMT w/CARABINER 1
10 2376716 PLUG, STRAIN RELIEF V2/SP 1
11 2332104 SCREW-1/4-20 X 5/8 S/S 2
12 2376312 TIE WRAP,BLACK,UV RESIST.NYLON 5
13 2375403 HEATSHRK .375X2 ADHV LINED 4
14 2994909 BAG ASSY, i-PILOT LINK,POWER 1
15 2373241 CABLE, USB REMOTE CHARGER 1
16 2375900 ADAPTER, USB POWER PORT 1
17 2377156 MANUAL-CD, i-PILOT LINK 1
18 2377155 MANUAL QCK REF, i-PILOT LINK 1
19 490389-1 CABLE, ETH (M12-M-M12-F, 30’ 1
6 7
minnkotamotors.com
minnkotamotors.com
INSTALLATION GuIde
PREPARING FOR INSTALLATION
Preparing for Installation
Tools you will need during installation
Terrova and Riptide ST
-Phillips screwdriver
PowerDrive V2
-Phillips screwdriver
-Needle-nose pliers
-Utility knife
-Heat gun or other heat source for installing heat shrink
Riptide SP
-Phillips screwdriver
-Needle-nose pliers
-Utility knife
-Heat gun or other heat source for installing heat shrink
To help with future service work or ordering replacement parts, please refer to the information box in the Notes section located on the back pages of this manual.
Before installing i-Pilot Link on your motor, make sure the trolling motor is properly
installed on y
our boat. Find a clean and dry location for performing the installation.
Most importantly, disconnect all power to the trolling motor before installation. Not only
will this pr
otect you but also the sensitive electronics you are about to install.
Read through the entire installation process before performing the installation.
If you need help or need further instruction on installing i-Pilot Link, please call Minn Kota
technical ser
vice at 1-800-227-6433 to talk to a customer service representative.
Humminbird Fishnder
Depending on your Humminbird model and system conguration, you may need to purchase additional cables, as shown below.
Visit our website at humminbird.com or call
the Customer Resource Center at 1-800-633-1468.
• 700 Series with Ethernet: To connect the Ethernet cable to the control head, you
will need to purchase the Ethernet Adapter Cable (AS EC QDE).
• Extension Cables are available for the Ethernet Cable if you need to extend the
connection longer than the 30 feet provided. See humminbird.com for details.
For PowerDrive V2 and Riptide SP trolling motors go
to page 12.
i-Pilot Link Installation on
Terrova and Riptide ST
Trolling Motors
* i-Pilot Link will override all CoPilot
functionality. CoPilot remotes will not
function with i-Pilot Link.
*
The Terrova foot pedal is fully functional and
supported when i-Pilot Link is installed
correctly.
1. Disconnect all power to the trolling
motor.
2. Remove control box cover screws and
cover using Phillips screwdriver.
(Figure 1)
3.
If the trolling motor has the AutoPilot
feature, unplug the AutoPilot control
board and remove it from the control
box. (Figures 2 and 3)
4. Remove grommet by pulling back on coil
cord strain relief and pushing down on
grommet. (Figure 4)
INSTALLATION OF I-PILOT LINK CONTROLLER
FIGURE 4
Grommet
FIGURE 1
FIGURE 2
FIGURE 3
The i-Pilot installation will require permanently removing the motor control box
cover. This cover includes information about your motor that may be needed
for future service work or when ordering replacement parts. Please note the
information from your motor in the space provided below.
Motor model (circle one) Terrova, Riptide ST, PowerDrive V2 or Riptide SP
Auto Pilot (Yes or No) ________________________________
Motor thust (55lb, 70lb, etc) ____________________________
Loading...