Milwaukee 58-03-0020 User Manual

BLOCK NO. 22-56-0470

__d

GREEN I YELLOW

CORD JACKET PLACEMENT: 3mm CLAMP WITH WIRES

ORIENTED AS SHOWN

DO NOT PINCH

WIRES BETWEEN WIRE TRAP AND MOTOR INSULATOR. /

BLUE (CORD)

GREEN I YELLOW @ (CORD$

BLACK (FIELD)

SEE REVERSE SIDE

FOR PRCD AND

SWITCH BOX

PARTS LIST & WIRING

NOTE:

All leads must be held to f 3 mm. Ail field leads to be measured from and perpendicular to laminations.

All lead lengths are before stripping.

TERMINAL DESCRIPTION

CO& Part No.

23-74-0841

Qnty.

SONNECTOR DESCRIPTION

Dlwg. 1

1 and 2 End Wire Preparation

For -4 Models 0th

Fig. Part Number

Description

No. Req.

1 22-68-0200 Switch Boot 1

2 23-66-1430 Switch 1

23-94-991s

3 4 22-36-0150 Breaker 1 5 22-68-0210 Breaker Boot 1 6 22-33-030s Suppressor 1 7 22-74-0050 Delay Circuit (CLD) 1 a 22-12-0200 Enclosure 1 9 06-82-7299 Screw 4

IO 31-17-0155 Clamp 2 11 44-76-0140 Strain Relief 1 12 22-64-407s Cord Set (220 V) 1 13 1 22-68-0190 1 Cover 1 1 14 1 12-98-3070 1 Instruction Plate 1 1 15 22-64-4085 Cord Set (Tool) 1 16 06-82-7326 Screw 4 17 22-56-0480 Terminal Block I

Connector Lead I

I I

5 1 Red 1 1.5mm 1 108 1 Strip 5mm For

Strip 6mm (Other End)

Strip 6mm Strip 6mm

As Received As Received Strip 6mm

Strip 6mm

NOTE:

All lengths must be held to *3mm. AU field leads to be measured from and perpendicular to laminations. All lead lengths are before stripping.

NOTE:

Cover should mate flush

with enclosure before

driving the 4 cover screws.

A gap indicates a misplaced

wire or component.

Tighten breaker boot after installing cover.

Tl (One End)