Specifications and Main Features
- Designation: OM-186
- Electric Power Consumption: 445 VAC, 2 A at 60 Hz
- Touch Sense Output Rating: 170 VDC, 5 mA
- Power Cord Length: 10 ft aka 2.5 m
- Scale: Length lies at 15-1/2 in (394 mm) and Height at 4-1/2 in (114 mm)
- Mass: 7 kg aka 15-1/2 lb
- Duty Cycle: 800 A AL 100%
Attributes:
- A touch Sensor which integrates touch with the welding wire and voltage sense leads.
- A robotic controller encompassing the contact signal processing.
- A mitt for sensing weld currents and active contactors during weld cycles.
- An optimizer which allows automatic welding processes to be safe and reliable.
Frequently Asked Questions
Q1: What are the requirements for input power for this device?
A1: Standard input power is around 445 VAC, 2 A with 60 Hz.
Q2: Would you happen to know the devices weight?
A2: It is approximately 15 kg or 15 ½.
Q3: When the device is operating within a welding cycle, how is the sensor able to function?
A3: The sensor gets signals from the controller which makes it begin the touch sensing phase - which also allows the device to mash the contactor during the welding phase.
Q4: What are the total dimensions of the device?
A4: The total dimensions are measured at a length of 15-1/2 inches alongside a height of 4-1/2 inches.
Q5: Explain what occurs with the device if no weld current is detected?
A5: The device is programmed to deenergize the contactor to ensure safety during the operation in the event that no weld current is detected.
User Manual
Loading...