Miele DA6480 User Manual

Product Dimensions Downdraft Ventilation DA6480 DA6490
E
Page 1 of 7
Shown with interior-mounted DAG 500 vent motor
Location Codes
E - 120 Volt – 15 Amp 3 wire power supply Hard wire connection to terminal
All electrical work should be performed by a qualified electrician in strict accordance with national regulations and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. Ensure that power to the appliance is off while installation or repair work is performed. The ventilation system may only be used with Miele DAG 500 or DAG 1000 blowers.
Drawing is not to scale - Specification Sheets OJS 032111
Downdraft Ventilation DA6480 DA6490 Cabinet Preparation
Page 2 of 7
D - Feed the power cord and control cable when using an external blower downwards or to the rear.
A-Cooktop overhang B-Minimum Width
DA6480: 28” (711 mm) DA6490: 34” (864 mm)
Exhaust air ducting using the DAG 500 internal blower, installed on the front of the appliance [vent duct 6” Ø (150 mm): A- to the left or right, B­downwards, C- to the rear. E- Using the DAG 1000 external blower, install exhaust ducting to the rear [vent duct 10” Ø (254 mm) Ensure clearances for front install.
Drawing is not to scale - Specification Sheets OJS 032111
Product Dimensions Downdraft Ventilation
Page 3 of 7
DA6480 DA6490 Clearance Dimensions
Drawing is not to scale - Specification Sheets OJS 032111
Loading...
+ 4 hidden pages