Midmark Ritter 95 User Manual

English
Español
Français

Assembly Instructions

A) Lay table top assembly upholstered side
down on a clean surface.

B) Secure leg assemblies with carriage bolts &
nuts.

Note: Do not tighten nuts at this time.

C) Secure cross brace with drywall screws.
D) Tighten nuts securing leg assemblies.
E) Install four leveling screws.
F) Install paper roll brackets & dowel rod as
shown.

Note: There are pre-drilled holes at one end. Install roll
brackets as shown to allow notch access for paper roll refills.

95 Treatment Table

User’s Guide

Cross Brace

(068-0320-00-377)

Table Top Assembly

(Standard: 028-0641-00-xxx*)

(Cal 133: 028-0641-01-xxx*)

*Replace -xxx w/code

from Color Chart

Leveling Screw

4 pcs.

(016-1080-00)

Leg Assembly

2 pcs.

(029-3885-00-377)

Screw (#8 x 3/4”)- 8 pcs.

(040-0008-46)

Washer- 8 pcs. (045-0001-00)

Notch

Pre-drilled Holes

Current Color Options

http://www.midmark.com/technical-library/colors/
medical-animal-health-colors/upholstery-colors

Paper Roll Bracket- 2 pcs.
(053-1577-00-271)

Drywall Screw (#6 x 1 1/4”)

2 pcs.

Dowel Rod (055-0005-00)

Notch

Access

Nut (1/4”-20) - 12 pcs.

Carriage Bolt (1/4”-20 x 3 1/2”)

12 pcs.

Parts Bag (029-3913-00) contains the following parts:

Leveling Feet (4pcs) Carriage Bolts (12 pcs)
Drywall Screws (2 pcs) Nuts (12 pcs)
Screws (8 pcs) Washers (8 pcs)

TP212 20-42-FO-00023 Rev A1 C2169

003-1649-99 Rev. AA1 (12/5/16)

Rev. AA1 (12/5/16)

WARNING

To avoid injury, do not put head or
extremities under the paper tear strap.

To install paper tear strap

Slide strap over table as shown.

Paper Tear Strap (029-0452-02)

To level the table.

Adjust four leveling feet as necessary.

Maximum Patient Weight

Max. Patient Weight...350 lbs (158.8 kg)

Leveling

Feet

MA742900i

Cleaning

Periodically inspect the following:

• All fasteners must be present and secure.

• All mechanical functions should operate properly.

Cleaning

Upholstery

Wash your upholstery weekly with a mild liquid soap and water mix­ture, rinse with clear water and dry completely to remove disinfection
cleaner build-up.

Disinfect your upholstery with a solution of standard bleach and water
mixed 1 in 10 (10%) or chlorine based cleaners. Follow this with a
clear water rinse and thorough drying of material. See current CDC
Guideline for Disinfection & Sterilization in Healthcare Facilities.

To minimize damage caused by disinfectant cleaner residue build-up,
do not allow disinfectants to pool on the upholstery surface. Once the
approved contact time has been obtained, remove and dry excess
liquid remaining on the surface.

Detailed care and maintenance instructions are included with your
product. This information is also available on www.midmark.com in
the Technical library under the User Information tab for your product.

Painted Metal / Plastic Surfaces
Clean the painted metal and plastic surfaces weekly using a clean
soft cloth, and mild cleaner. Periodic applications of common furni-

ture wax will ease cleaning, and maintain the nished luster of the

surfaces.

Ordering Repair Parts

To order repair parts, contact your Midmark dealer.
To contact Midmark directly:

1-800-Midmark (1-800-643-6275)
8:00 am until 5:00 pm Mon-Fri (EST)

003-1649-99

English

Warranty

SCOPE OF WARRANTY Midmark Corporation (“Midmark”) warrants to the original retail
purchaser that it will, at Midmark’s option, repair or replace components of the domestic
and international medical products manufactured by Midmark (except for components not
warranted under “Exclusions”) that are defective in material or workmanship under normal
use and service. The sole remedy under this limited warranty is the repair or replacement,
at Midmark’s option, of the applicable components. This limited warranty shall only apply
to defects that are reported to Midmark within the applicable warranty period and which
are determined to exist upon examination by Midmark,. This warranty extends only to the
original retail purchaser of a product and is not transferable or assignable. Replacement
components or products may be used and/or refurbished components or products, pro-

vided they are of like quality and specications as new components or products.

Midmark warrants to the original retail purchaser that during the applicable warranty period
it will repair or replace software contained within the products manufactured by Midmark
(except for those not warranted under “Exclusions”) if: (1) the media on which the software
is furnished exhibits defects in material or workmanship under normal use; or (2) the

software does not substantially conform to its published specications.

APPLICABLE WARRANTY PERIOD The applicable warranty period, measured from the
date of invoice to the original retail purchaser of the product and shall be one (1) year for
all warranted products and components.

OBTAINING WARRANTY SERVICE Warranty service must be obtained through either
Midmark or an authorized dealer in the Midmark product line for which warranty service
is requested. Midmark may be contacted for warranty service inquiries or issues via email
at www.midmark.com; by phone at 1-800-MIDMARK or by mail to Midmark Corporation,
60 Vista Drive, Versailles, Ohio 45380. It is the retail purchaser’s obligation to arrange
for delivery of a product to Midmark or one of its authorized dealers for warranty service,
which delivery shall be at retail purchaser’s expense. It is also the retail purchaser’s
obligation to comply with the warranty service instructions provided either by Midmark or
its authorized dealer. The retail purchaser must provide Midmark with completed warranty

registration information within thirty (30) days after purchase in order to obtain the benets

of this limited warranty.
EXCLUSIONS: This limited warranty does not cover and Midmark shall not be liable for

the following:
(1) Defects, damage or other conditions caused, in whole or in part, by misuse, abuse,
negligence, alteration, accident, freight damage, negligent storage, tampering or failure to
seek and obtain repair or replacement in a timely manner;
(2) Products which are not installed, used, and properly cleaned and maintained as
required or recommended in the Midmark “Installation” and/or “Installation/Operation
Manual” for the applicable product, including the specied structural and operational envi­ronmental conditions and electrical requirements;
(3) Products considered to be of a consumable or sterile nature;
(4) Accessories or parts not manufactured by Midmark;
(5) Charges by anyone for adjustments, repairs, replacement parts, installation or other
work performed upon or in connection with such products which are not expressly autho­rized in writing in advance by Midmark;
(6) Costs and expenses of routine maintenance and cleaning; and
(7) Representations and warranties made by any person or entity other than Midmark.
(8) Matching of color, grain or texture except to commercially acceptable standards;

(9) Changes in color caused by natural or articial light;

(10) Custom manufactured products;

(11) Alterations or modications to the product by any person or entity other than Midmark;

and
(12) Products that would otherwise by covered under this limited warranty, but are ac­quired: (i) from a person or entity that is not Midmark or one of its authorized dealers; or (ii)
from a Midmark dealer that is not authorized to sell the product at issue in the geographic
territory where the purchaser is located, or is not authorized to sell the product at issue
within the medical market.

SOFTWARE; WITH RESPECT TO SOFTWARE THAT IS A PRODUCT OR COMPONENT
THEREOF, MIDMARK DOES NOT WARRANT THAT THE SOFTWARE: (1) IS ERROR
FREE; (2) CAN BE USED WITHOUT PROBLEMS OR INTERRUPTIONS; OR (3) IS
FREE FROM VULNERABILITY TO INTRUSION OR ATTACK BY VIRUSES OR OTHER
METHODS.

EXCLUSIVE REMEDY; CONSEQUENTIAL DAMAGES DISCLAIMER MIDMARK’S
ONLY OBLIGATION UNDER THIS LIMITED WARRANTY IS THE REPAIR OR RE­PLACEMENT OF DEFECTIVE PARTS. MIDMARK SHALL NOT BE LIABLE FOR AND
HEREBY DISCLAIMS ANY DIRECT, SPECIAL, INDIRECT, INCIDENTAL, EXEMPLARY
OR CONSEQUENTIAL DAMAGES OR DELAYS, INCLUDING, BUT NOT LIMITED TO,
DAMAGES FOR LOSS OF PROFITS OR INCOME, LOSS OF USE, LOSS OF DATA,
DOWNTIME, COVER AND EMPLOYEE OR INDEPENDENT CONTRACTOR WAGES,
PAYMENTS AND BENEFITS. THIS DISCLAIMER SHALL SURVIVE ANY FAILURE OR
ASSERTED FAILURE OF THE ESSENTIAL PURPOSE OF THIS LIMITED WARRANTY
OR ITS REMEDIES SPECIFIED HEREIN. WARRANTY DISCLAIMER THIS WARRANTY
IS MIDMARK’S ONLY WARRANTY AND IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED. MIDMARK MAKES NO IMPLIED WARRANTIES OF ANY KIND
INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE. THIS WARRANTY IS LIMITED TO THE REPAIR OR RE­PLACEMENT OF DEFECTIVE PARTS.

STATUTE OF LIMITATIONS No action may be brought against Midmark for breach of this
limited warranty, an implied warranty, if any, or for any other claim arising out of or relating
to the products, more than ninety (90) days following expiration of the limited warranty
period.6.5

NO AUTHORIZATION No person or rm is authorized to create or approve for Midmark

any other obligation or liability in connection with the products.

- 2

TP202 20-42-FO-00014 Rev A1 C2169

© Midmark Corporation - 2017

English
Español
Français

Instrucciones de montaje

A) Coloque la parte superior de la camilla (con

la parte acolchada hacia abajo) sobre una
superficie limpia.

B) Acople las patas con los pernos de cabeza

redondeada y las tuercas

Nota: No apriete las tuercas completamente por ahora.

C) Atornille la barra transversal con tornillos

para planchas de yeso.
D) Apriete las tuercas que sujetan las patas.
E) Coloque los cuatro tornillos niveladores.
F) Instale los soportes para el rollo de papel y

el pasador, tal como se indica.

Nota: Hay orificios preperforados en uno de los extremos.
Coloque los soportes del rollo tal como se indica de forma
que la muesca sea accesible cuando deban colocarse los
recambios de papel.

Camilla de tratamiento 95

Guía del usuario

Tornillos niveladores

(4 uds.)

Barra transversal

(068-0320-00-377)

Estructura superior de la camilla

(Estándar: 028-0641-00-xxx*)

(Cal 133: 028-0641-01-xxx*)
*Sustituya -xxx por el código

de la tabla de colores

(016-1080-00)

Estructuras de

patas (2 uds.)

(029-3885-00-377)

Tornillo (#8 x 3/4 in)- 8 uds.

(040-0008-46)

Tornillos para planchas de

yeso (#6 x 1 1/4 in) (2 uds.)

Arandelas (8 uds.)
(045-0001-00)

Ranura

Soportes para rollo de papel (2 uds.)
(053-1577-00-271)

Pasador (055-0005-00)

Acceso a la

muesca

Oricios
preperforados

Opciones de colores actuales

http://www.midmark.com/technical-library/colors/
medical-animal-health-colors/upholstery-colors

Tuercas (1/4 in-20)
(12 uds.)

Pernos de cabeza redondeada

(1/4 in-20 x 3 1/2 in) (12 uds.)

La bolsa de piezas (029-3913-00) contiene lo siguiente:

Pies de nivelación (4 uds.)
Tornillos para

placas de yeso (2 uds.)

Tornillos (8 uds.)

TP212 20-42-FO-00023 Rev A1 C2169

Pernos de cabeza

redondeada (12 uds.)
Tuercas (12 uds.)
Arandelas (8 uds.)

003-1649-99 Rev. AA1 (12/5/16)