Midmark M11-042, M9-042, M9D-042, M9-043, M9-040 User Manual
...
Thermal Printer
midmark.com
M9/M11 Thermal Printer Installation (9A599001)
Applies to Models:
M9 (-040 /-041 / -042 /-043)
M9D (-042)
M11 (-040 /-041/ -042/-043)
Special Tools:
none
Language of origin: English
Cover
Printer
Harness
WARNING
Disconnect all electrical power to the unit before removing
any of the unit’s covers or making any repairs to prevent
possibility of electrical shock. Failure to comply with these instructions
could result in serious personal injury.
Step 1: Remove Cover
A) Unplug sterilizer power cord.
B) Using a flat-bladed screwdriver, pry cover up from the front
edge, then remove.
C) Locate printer harness, remove tape securing wires to the
bottom of the printer cavity.
© 2019 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
1
Style G
TP201 20-42-FO-00013 Rev A1 C2169
003-2924-00 Rev. AA5 (9/25/19)
Step 2: Attach Wires/Remove Film
A) Position the printer upside down with the the long hook and loop strip
facing you.
B) Take the black/red harness, position the white wire connection tabs
downward and connect to the left side of the printer.
C) Take the green/white/black harness, position the white wire connection
tabs downward and connect to the right hand side of the printer.
D) Peel off the clear film of the long hook and loop strip to expose sticky
side of the hook and loop.
Note: Push connectors into place firmly almost flush with the printer.
Printer
Clear Film
(Hook and Loop)
Harness
Align Back
Edge
Printer
Harness
Clear Film
(Hook and Loop)
Step 3: Install Printer
A) To align the printer correctly in the printer cavity, tilt up the front edge of the
printer, position the back edge of the printer on the top back edge of the
printer cavity.
B) Keep the back edge of the printer in position and remove the clear film
from the two small hook and loop sections on the front of the printer.
C) Pivot the front edge of the printer down into position in the printer cavity.
Press firmly into place.
Equipment Alert
Position printer harness into printer cavity making sure it is not pinched or
kinked by the printer
2
.
003-2924-00
Loading...