Midmark 280, 680 Parts Manual

FOR USE BY MIDMARK TRAINED TECHNICIANS ONLY
Model Numbers:
Service and
Par ts Manual
SF-1874 Part No. 004-0497-00 Rev. (6/16/16)
280 / 680 Series Chairs & Seating
281 680
Serial Number Prefixes:
V, VAE (280 Series) V, VAA (680 Series)
FOR USE BY MIDMARK TRAINED TECHNICIANS ONLY
Table Of Contents
GENERAL INFORMATION
Symbols ....................................iii
Ordering Parts ......................... iii
Serial Number Location .......... iii
Specifications ........................... iv
Warranty Information............... v
TROUBLESHOOTING
not available
TESTING & REPAIR
not available
ACCESS PROCEDURES
not available
WIRING DIAGRAMS
not available
EXPLODED VIEWS / PARTS LISTS
281 Blood Drawing Chair:
Chair Assembly ............................
E-2
Rotating Arm Assembly ...............
E-3
Drawer Rotating Arm Assembly ....
E-4
Drawer Assembly .........................
E-5
680 Side Chair ......................... E-6
Section E
General Information
Section A
Section B
Section C
Section D
Section E
Rev. 10/20/15
iii
© Midmark Corporation 2006 SF-1874
General Information
Symbols
Caution
Indicates a potentially hazardous situation which could result in injury if not avoided.
Equipment Alert
Indicates a potentially hazardous situation which could result in equipment damage if not avoided.
Note
Amplifies a procedure, practice, or condition.
Indicates that the component the check mark appears beside should be tested before replacing it. In Section A, test the components in the order indicated. (ex.
1st
then,
2nd
)
Refer to Section B for component testing procedures.
These symbols are used throughout this manual to represent the operational status of table functions and components.
Indicates the function / component is working properly. No action required.
Indicates the function / component is working, but a problem exists.
Indicates the function / component is not working at all.




Ordering Parts
The following information is required when or dering parts:
Serial number & model number
Part number for desired part.
[Refer to Exploded Views / Parts Lists section]
Non-warranty parts orders may be faxed to Midmark using the Fax Order Form in the back of this manual.
For warranty parts orders, call Midmark's Technical Service Department with the required information.
Hours: 8:00 am until 5:00 pm EST [Monday - Friday] Phone: 1-(800)-Midmark
Model / Serial Number Location
Serial / Model
Number
General Information
Rev 10/8/12
iv
© Midmark Corporation 2006 SF-1874
General Information
Specifications
(*) Height is based on leveling screws adjusted in middle of adjustment range.
Rev. 10/12
281
680
Cleaning
• Clean upholstery with diluted bleach solution. Ratio: 10:1 (water:bleach)
• Clean the chair as necessary, wiping the painted metal and plastic surfaces with a clean, soft cloth, and mild cleaner. Periodic applications of common fur niture wax will ease cleaning and maintain the finished luster of the chair .
Specification 68
0
281
Seat Cushion Thickness:
2 in. (5.1 cm) 2 in. (5.1 cm)
Back Cushion Dimension:
18 in. W x 13.5 in. H
(45.7 x 34.3 cm)
20 in. W x 16.5 in. H
(51 x 42 cm)
Drawer Size:
n/a
8.5 x 15.25 x 4.5 in. (22 x 39 x 12 cm)
Seat Cushion Dimension:
18 in. W x 19.5 in. D
(45.7 x 49.5 cm)
20 in. W x 16.5 in. D
(51 x 42 cm)
Arm Height Adjustment:
n/a 5 in. (12.7 cm)
Drawer Height (from floor) :
n/a
28 to 33 in.
(71 to 84 cm)
Seat Width:
19.5 in. (49.5 cm)
Arm Swing Radius:
n/a 13.5 in. (34.3 cm)
Chair Depth:
22 in. (55.9 cm) 24 in. (61 cm)
Seat Height:
17 in (43.2 cm)* 20.5 in. (52 cm)
Chair Width (w/ drawer) :
n/a 42.5 in. (108 cm)
Inside Arm Width:
17.5 in. (44.5 cm) 21 in. (53.3 cm)
Chair Width (w/o arms) :
20.5 in. (52.1 cm) n/a
Chair Width (w/ arms) :
23.5 in. (59.7 cm) 30.5 in. (77.5 cm)
Weight Capacity:
400 lbs (181 kg) 400 lbs (181 kg)
Chair Height (*):
33.5 in. (85.1 cm) 33.5 in. (85.1 cm)
v
© Midmark Corporation 2006 SF-1874
General Information
Warranty Information
SCOPE OF WARRANTY
Midmark Corporation (“Midmark”) warrants to the original purchaser its new Alternate Care products and components (except for components not warranted under “Exclusions”) manufactured by Midmark to be free from defects in material and workmanship under normal use and service. Midmark’s obligation under this warranty is limited to the repair or replacement, at Midmark’s option, of the parts or the products the defects of which are reported to Midmark within the applicable warranty period and which, upon examination by Midmark, prove to be defective.
APPLICABLE WARRANTY PERIOD
The applicable warranty period, measured from the date of delivery to the original user, shall be one (1) year for all warranted products and components.
EXCLUSIONS
This warranty does not cover and Midmark shall not be liable for the following: (1) repairs and replacements because of misuse, abuse, negligence, alteration, accident, freight damage, or tampering; (2) products which are not installed, used, and properly cleaned as required in the Midmark “Installation” and or “Installation / Operation Manual for this appli cable product. (3) products considered to be of a consumable nature; (4) accessories or parts not manufactured by Midmark; (5) charges by anyone for adjustments, repairs, replacement parts, installation, or other work performed upon or in connection with such products which is not expressly authorized in writing in advance by Midmark.
EXCLUSIVE REMEDY
Midmark’s only obligation under this warranty is the repair or replacement of defective parts. Midmark shall not be liable for any direct, special, indirect, incidental, exemplary, or consequential damages or delay, including, but not limited to, damages for loss of profits or loss of use.
NO AUTHORIZATION
No person or firm is authorized to create for Midmark any other obligation or liability in connection with the products.
THIS WARRANTY IS MIDMARK’S ONLY WARRANTY AND IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. MIDMARK MAKES NO IMPLIED WARRANTIES OF ANY KIND INCLUDING ANY WARRANTIES OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE. THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT OF DEFECTIVE PARTS.
SF-1487 REV. A1
Additional Information
Failure to follow the guidelines listed below will void the warranty and/or render the table unsafe for use.
If a malfunction is detected, do not use the table until
necessary repairs are made.
Do not attempt to disassemble table, replace
components, or perform adjustments unless you are a Midmark authorized service technician.
Do not use another manufacturer's parts to replace
malfunctioning components. Use only Midmark replacement parts
Loading...
+ 11 hidden pages