Midea MFC-150A15 Owner's Manual

OWNER’S MANUAL

Ceiling Fan

MODEL: MFC-150A15

READ AND SAVE THESE INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

Version 1.0 2015

Attention: Pictures in the IM are for reference only.

INSTALLATION INSTRUCTIONS-CEILING FAN

NOTICE:

To ensure the success of this installation, be sure to read

the instructions and review the diagram thoroughly before

beginning.

GENERAL

After opening the box, you should find the following parts.

┄one fan motor
┄one down rod

┄one regulator
┄one set of blades

┄two ceiling canopies

Tools required

┄ pliers

┄standard screwdriver

SAFETY PRECAUTIONS

1. Installation by licensed electrician is strongly recommended.

2. Be sure electricity off at main switch before wiring.

3. All wiring must be in accordance with national and local electrical
codes and this fan must be grounded against possible shock.

4. When fan is mount

ed, blades must be at least 2.3m from floor.

5. Do not allow hands or other objects to contact rotating blades.

INSTALLATION INSTRUCTIONS

1. Before beginning, disconnect power by removing fuse or turning off
circuit breaker.

2. It is essential that the outlet box or structural member from which the fan
is to be suspended will safely support the fan. In view of the torque
and weight factors involved. Some outlet boxes will require additional
strengthening by securing more firmly to wood beams or steel supports.

3.Screw hook through center of outlet box into beam or roist.
Fix Fork Pipe to the moto

r shaft. Tighten the bolt and nut firmly.

Make sure the cotter pin is inserted and bent.

1

6.

Children should be supervised to ensure that they do not play with the
appliance.

7.

This appliance is not intended for use by person (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.)

8.

If the power supply cord is damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualified person in order to avoid a hazard.