Page 1
Mi Vacuum Cleaner G10 Quick Start Guide
1. Do not vacuum liquids. Do not directly clean the
vacuum cleaner with water.
3. To prevent injury, do not touch rotating parts while
the vacuum cleaner is running.
2. Do not vacuum burning or smoking substances,
such as unextinguished cigarette butts, or hard or
sharp objects like nails.
4. Do not charge or store the vacuum cleaner near
heat sources or in humid areas, such as by a radiator
or in a kitchen or bathroom.
Page 2
How to Install
Installing the Accessories onto the Vacuum Cleaner
Note: Mini electric brush should not be used with the extension rod.
Insert until it clicks into place Insert until it clicks into place
Charging
Fully charge the vacuum cleaner before turning it on for the first time and
after each use. The total charging time is about 4 hours.
Charging the vacuum cleaner with the charger Charging the vacuum cleaner on the charging mount
1
1
Charging Port
Charging
Contacts × 2
2
Page 3
How to Use
Setting Language
Press and hold the button for 3 seconds to open the language list,
then press the button to scroll through the language to select the
desired one. Press and hold the button for 2 seconds to use the
selected language.
Note: The display screen will go off if there is no operation for more than 10
seconds.
Switching Suction Levels
Press the button to switch suction levels of eco, standard/auto, and
high power. The corresponding suction level will be highlighted on the
display screen.
Only when using the smart high torque brush bar, the auto mode will
be activated and the notification of "Auto" will appear on the display
screen. The vacuum cleaner will then automatically switch the suction
level between the floor/tile and the carpet.
Note: Stop the vacuum cleaner at any time while cleaning, and it will continue to
use the last selected suction level when started again.
Working Modes
1. Non-continuous Mode
Hold down the power button to start the vacuum cleaner, then release
to stop it.
2. Continuous Mode
Press the button to enable Continuous Mode, then press the power
button to turn the vacuum cleaner on. To exit Continuous Mode, press
the button .
Notes:
In Continuous Mode, the vacuum cleaner will enter into standby mode when
pressing the power button, and resume running if pressing the button again.
When the vacuum cleaner keeps in standby mode for more than 10 seconds, its
display screen will go off and the vacuum cleaner will then exit the Continuous
Mode.
2
Page 4
Cleaning
Washable Parts
These parts must be separated from the vacuum cleaner or assembly prior to cleaning. Make sure the washed parts are thoroughly dry for at least
24 hours.
Crevice Nozzle
Dust Compartment
Warning: Only the above parts are washable, the rests and the vacuum cleaner itself are non-washable.
3
2-in-1 Brush Nozzle
Cyclone Assembly
Mini Roller Brush
HEPA Filter
Roller Brush
Pre-filter
Importeur:
Beryko s.r.o.
Na Roudné 1162/76, 301 00 Plzen
www.beryko.cz
Loading...