Meyer Sound LINA-RMS-RIG-WP-5, LINA-RMS-RIG-WP-3, LINA-RMS-RIG-ULT-WP, LINA-RIG-WP-3 Installation Guide

INSTALLATION INSTRUCTIONS

Do not cross cables

LINE ARRAY

LINA UW Rain Hood and Shield Attachment

PART S L I S T

The Ultra Weather Protection LINA Rain Hood includes the following parts:

• LINA Rain Hood with attached gasket (PN 45.268.035.03)

• LINA UW Rain Hood Shield (PN 64.268.129.01)

• 4 pan head Phillips 6-32 x 0.5-inch stainless-steel screws (PN 101.031)

ULTRA WEATHER PROTECT RAIN HOOD AND UW SHIELD INSTALLATION

The LINA rigid removable rain hood plus UW rain hood shield are easily attached and removed with the included four screws
(Figure 1).

Figure 1: LINA with Rain Hood and UW Shield (left) and Cable Routing over Inner Wall (right)

1. Attach any required cables to the LINA loudspeaker.

2. Carefully route the cables, so that they wrap over and down the inner rain hood wall (see Figure 1, right), and exit through
the slot.

3. Attach the rain hood to the user panel and loosely secure it to the center of the panel with its four 6-32 x 0.5-inch screws.

4. Engage 2-3 threads on the upper- and lower-left screws. The cables should exit to the left when viewing from the rear of
the loudspeaker. Do not cross the cables at the rain hood opening (see Figure 1, right).

5. Route the cables up and over the top of the rain hood between the shield and the rain hood. Do not cross the cables (see
Figure 2, left).

6. Angle the shield and hook the slots in the L-shaped UW shield over both upper- and lower-left screws (when facing the
rear of the loudspeaker, see Figure 2, right).

LINA UW RAIN HOOD AND SHIELD ATTACHMENT

Push here

Rain hood lip

Do not cross cables

Figure 2: Routing Cables over Rain Hood (left) and Hooking Shield over Securing Screws (right)

7. Tighten the upper and lower screws on the left side of the rain hood (Figure 3). The recommended torque value for all four
screws is 10–12 in-lbs (1.1-1.4 N·m).

Figure 3: Tightening Screws on Left Side of Rain Hood

8. Push the shield toward the rain hood until its edge clicks into place over the rain hood lip (Figure 4).

Figure 4: Pushing Shield Toward Rain Hood

2