METRON PC01, PC02, PC03, PC04, PC05 User Manual

www.eauto.si [e-mail] [phone]

USER MANUAL

PC01 AND PC02

METRON EV portable chargers PC01 and PC02 are
designed to charge electric vehicles equipped with
Type 1 charging sockets (USA/Japan/S.Korea
standard) from any standard household outlet (e.g.
Schuko) or industrial socket (e.g. 1 or 3-phase CEE
sockets). Where’s the in-cable “bulky box”? Metron

portable chargers are truly unique because all the
charging station electronics is placed inside Type 1
charging plug itself!

EV PORTABLE CHARGERS

advantage of this design is the fact, that METRON
portable chargers don’t have that heavy in-line “bulky
box” as others do, what makes them lighter, easier to
install/connect and also easier to store in a carrier
case. METRON portable chargers also offer the
possibility to set desired charging current/power by
simply pressing a button.

GET STARTED

First plug the portable charger in the wall outlet.
Immediately signal LED starts blinking: number of
blinks tells you what is the saved power setting (see
the next page). Afterwards LED glows constantly till
AC power is present indicating standby/ready status.

When you plug it into the vehicle Type 1 socket it starts
blinking slowly, which means the vehicle is charging.
When your electric vehicle is fully charged, the LED
glows constantly again.

1

SETTING THE DESIRED CHARGING CURRENT/POWER

METRON portable chargers allow user to set desired charging current/power, before being plugged in the
electric vehicle Type 1 socket, or even while the vehicle is charging! Procedure is simple:

• press and hold the push button: LED switches off immediately

• after 5 seconds LED starts blinking slowly

• Releasing the push button after a certain number of blinks determines charging

current/power as follows:

Push Button

LED light

PC02PC01

Number of LED blinks Charging current/power

1 6 A / 1,4 kW

2 8 A / 1,8 kW

3 10 A / 2,3 kW

4 13A / 3,0 kW

5 16A / 3,7 kW

Number of LED blinks Charging current/power

1 6 A / 1,4 kW

2 8 A / 1,8 kW

3 10 A / 2,3 kW

4 13A / 3,0 kW

5 16A / 3,7 kW

6 20A / 4,6 kW

7 25A / 5,8 kW

8 32A / 7,4 kW

New charging current/power setting is stored in the memory and it stays the same (even
after the power supply is not present anymore) until the next setting change is
performed.

STATUS NOTIFICATION BY LED BLINKS

LED STATUS NOTIFICATION

Slow blinking when power supply is applied

Constantly on when not plugged in

Slow blinking when plugged in

Indicating previous saved current setting

Stand-by / Ready to charge

Charging

2