Metrologic Instruments 46-00885, 46-00709 User Manual

Optional Wall/Tabletop Stand (PN 46-00885)

To fix mount the stand to the wall:

1. Drill two #39 pilot holes in the wall spaced 39 mm (1.54") apart on a
horizontal centerline.

2. Install one #8 wood screw in each of the pilot holes, leaving a space
between the head of the screw and the wall surface.

3. Locate the two slots marked as "A" on the stand base in Figure 5.

4. Match the "A" slots on the stand to the heads of the installed wood
screws.

5. Slide the stand over the screw heads and down to lock the stand in place.

Figure 5. Figure 6.

Cradle Angle Warning

Copyright 2007, Metrologic Instruments, Inc.

- 4 - - 1 -

MS9590 S

Flex Stand Components (PN 46-00709)

Item Item Description Qty.

A Cradle Coupler 1

B Cradle 1

C Flexible Shaft 1

D Screw Cap 2

E Stand Base 1

F ¼" - 20 x ⅜" Flat Head Phillips Screw, 100° Undercut 2

G #8 Round Head Wood Screw (for fixed mount applications) 2

H M3 -.5 x 20 mm, Pan Head Phillips Screw 1

J M3 Flat Washer 1

K M3 Split Lock Washer 1

L Flexible Shaft Cover 1

TAND INSTALLATION GUIDE

Figure 1. Stand Components

November 2007

Printed in the USA

00 - 05249B

Flex Stand Assembly (PN 46-00709)

Optional Flex Stand Fixed Mount (PN 46-00709)

1. In the kit, two #8 wood screws have been
provided for fixed mount applications.

2. When choosing the stand location, make
sure to consider the front orientation of the
stand (indicated in Figure 3).

3. On a centerline, drill two #39 pilot holes in
the countertop spaced 125 mm (4.92") apart.
The stand base can be used as a guide for
the spacing of the pilot holes.

4. Secure the stand base to the countertop with
the two #8 wood screws provided.

Figure 3.

Figure 2. Stand Assembly

Figure 4. Stand Base Hole Pattern (Not to Scale)

- 2 - - 3 -