Metro GCB16S User Manual
Grounding Bracket
and Cable Kit
ASSEMBLY
INSTRUCTIONS
For Grounding Bracket
and Cable Kit
This kit is designed to be used on
units which have a one-inch square
tubular frame as the bottom
component. To make the unit staticdissipative proceed as follows:
1. Unpack container to confirm
amount and identify of components.
NOTE: If a unit has been previously
purchased as a standard product
and is assembled with aluminum split
sleeves and retaining rings and the
components have not been aqualac
coated the unit can be made staticdissipative by mounting the
grounding bracket and cable kit.
Otherwise this kit is not to be
assembled on any units which have
not been ordered from the factory as
a static-dissipative unit.
Ty-Rap Cable Tie
ASSEMBLY
INSTRUCTIONS
Bracket
Offset
2. Attach the bracket approximately
in the middle of one of the end
members. Tie the ty-rap cable around
the end member and between the
bracket wires. Cut off the excess
cable tie (Fig. 1).
3. Attach cable to offset in bracket as
shown. Be certain cable is secure.
4. Observe all other precautions
for handling electrostatic sensitive
devices.
InterMetro Industries Corporation
®
North Washington Street, Wilkes-Barre, PA 18705
For Product Information Call: 1-800-433-2232
Visit Our Web Site: www.metro.com
Fig. 1
GCB16S
Cable
L01-040
Rev. B
Information and specifications are subject to change
without notice. Please confirm at time of order.
4/01
Loading...