Page 1
Setup Guide
WARNING:
Drum key can be pinched when adjusting clamps with drum key. Operate carefully.
Be careful around pipe ends, inside the pipe and screw ends. Metal shavings, etc. May injure your fingers.
Check the include items
1
CYMBAL PADS BOX
Cymbal Pad x 1
for Hi-Hat
DRUM PADS BOX DRUM MODULE BOX
ACCESSORIES BOX
Cymbal Holder x3
Drum Key
Cymbal Pad with choke x 2
for Crash & Ride
Snare Pad x 1
Drumsticks Handscrews x 2
HI-HAT PEDAL BOX
BASS DRUM PEDAL BOX
Hexagon Key
Setup Guide
Connection Cable X 9
AC Adaptor
Owner’s Manual
Page 2
Attach the Parts
2
Attach the Pads
1.Loosen wing nut on the holder
clamp, which is on the center
pipe(1),side arm(L2)and side
arm（R）.
2.Attach drum pads to the holder
clamp on center pipe(1),side
arm(L2),side arm(R) and tighten
wing nuts. Repeat for each pad.
Attach the Cymbal Pads
Wing Nut
2 2
Side Arm(L1)
1
2
1
Side Arm(L2)
1
Center Pipe(1)
2
Center Pipe(2)
Side Arm(R)
1
1
2
1. Remove the wing nut and felt
washer from the cymbal tilter.
2. Place the cymbal pad, felt
washer, wing nut 3 assembly as
shown, and tighten the wing nut
3 to obtain an appropriate
amount of sway.
3. Adjust the cymbal pad position
with the wing nut 4.
Assemble the Kick
1
Wing Nut 3
Felt Washer
Wing Nut 4
Cymbal Tilter
3
2
Crash
Ride
Hi-Ha t
Pillar(L) Pillar(R)
1. Insert the beater to the beater holder on
the foot pedal.
2. Adjust the beater position and tighten
the beater with the drum key.
3. Attach the foot pedal to the kick pad.
4. Adjust the beat position and tighten the
wing nut.
Note:
Position the one beater in the center
of the kick pad kick .
1
2
4
Wing Nut
3
Page 3
Connect the Pads to the Drum Module
3
Attach the Drum Module
1. Connect the cable to the drum module as shown with
hands crews.
2. Attach the drum module to the mount holders on Side
Arm (L1), and firmly tighten the relevant wing nut.
Note:
Adjust the drum module position by moving the mount
holders as needed, and firmly tighten the relevant wing
nut.
Connection Procedure
1. Place the kick on the floor in the center of the rack as
shown.
2. Place the hi-hat pedal on the floor on your left side.
3. Connect the pads to the drum module with the marked
cables.
Are you ready? Let's enjoy playing it.
Hi-Ha tTo
Drum Module
To Cra sh
2
1
Cymbal Pad
Drum Pad
RideTo
Tom 1To
Tom 2To
Make connections as shown in the illustration.
Ride
Tom2Tom1
Tom3
Drum
Module
Hi-Hat
Hi-Hat
Pedal
Crash
Snare
Kick
SnareTo
To
Hi-Ha t
contr ol
Tom 3
PedalHi-Hat
Kick Pad
To Kic k
Tom 3To
3
3
Loading...