Medeli DD400 Setup Manual
Setup Guide
WARNING:
Drum key can be pinched when adjusting clamps with drum key. Operate carefully.
Be careful around pipe ends, inside the pipe and screw ends. Metal shavings, etc. May injure your fingers.
Check the include items
1
CYMBAL PADS BOX
Cymbal Pad for Hi-Hat Cymbal Pad for Crash
Cymbal Pad for Ride
DRUM PADS BOX
Tom Pad x3
ACCESSORIES BOX
Cymbal Holder x3
Drum Key
Snare L - Metal Rod X 1
(Length:165mm)
Drumsticks
HI-HAT PEDAL BOX
BASS DRUM BOX
Bass Drum Pedal
DRUM MODULE BOX
Tom&Module L - Metal Rod X4
(Length:110mm)
Connection Cable X 9
Owner’s Manual
Hexagon Key
Setup Guide
STAND AND CYMBAL HOLDER BOX
AC Adaptor
Handscrew X 2
100
95
75
25
5
0
Attach the Parts
2
Attach the Pads
3
1. Loosen wing nut on the holder clamp, which is on the center pipe、
Side arm(L) and Side arm (R).
2. Insert the Snare L-Metal Rod into the holder clamp on the Side
arm(L),then insert the Tom&Module L-Metal Rod into the holder
clamp on the Center Pipe and Side Arm(R), tighten wing nuts on
the holder clamp.
3. Attach drum pads to the Snare L-Metal Rod and the Tom&Module
L-Metal Rods then tighten wing nuts , Repeat for each pad.
Attach the Cymbal Pads
1. Loosen wing nut on the holder clamp on pillar(L)、 、 pillar(R)
and side arm(L).
1
1
2
2
2
3
3
2
1
2
1
2. Insert each cymbal holder into pillar(L)、 pillar(R)、side arm(L),
and tighten wing nut.
3. Remove wing nut and felt washer from cymbal lilter.
4. Place cymbal pad on tilter assembly.
Re-attach the felt washer and wing nut. Tighten wing nut.
3
4
100
95
75
25
5
0
Loading...