Page 1
8W Single Output Switching Power Supply
■ Features ■ Applications
Constant voltage design
Universal AC input / Full range
Class power unit, no FGⅡ
Fully isolated plastic case
IP30 design
Indoor LED lighting
LED decorative lighting
LED office lighting
LED signage
APV-8 series
Small and compact size
Cooling by free air convection
Protections: Short circuit / Overload / Over voltage
No load power consumption <0.5W
100% full load burn-in test
Low cost, high reliability
2 years warranty
■ Description
APV-8 series is one 8W AC/DC constant voltage mode single output LED power supply. It accepts
the full range input 90~264VAC and provides three models with different output voltage, 5V, 12V,
24V, respectively, that the small wattage LED applications employ the most frequently. Exploiting
Class II design (without FG pin) and adopting the 94V-0 flame retardant plastic enclosure, APV-8
ideally fits the entry-level LED applications.
■ Model Encoding
-12
APV -
8
Output voltage
Output wattage
Series name
File Name:APV-8-SPEC 2015-08-17
Page 2
SPECIFICATION
MODEL
DC VO LTAGE
RATED CURRENT
CURRENT RANGE
OUTPUT
RATED POWER
RIPPLE & NOISE
VOLTAGE TOLERANCE
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME
HOLD UP TIME (Typ.)
VO LTAGE RANG E
FREQUENCY RANGE
INPUT
EFFICIENCY (Typ.)
AC CURRENT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
SHORT CIRCUIT
PROTECTION
OVER LOAD
OVER VOLTAGE
WORKING TEMP.
WORKING HUMIDITY
ENVIRONMENT
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
SAFETY STANDARDS
WITHSTAND VOLTAGE
SAFETY &
EMC
ISOLATION RESISTANCE
EMC EMISSION
EMC IMMUNITY
MTBF
OTHERS
DIMENSION
PACKING
NOTE
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.℃
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltage. Please check the static characteristics for more details.
5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be
6. When applying DC voltage for input, please connect the brown input wire to the positive side whereas blue input wire to the negative side.
7. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.
8W Single Output Switching Power Supply
APV-8-12
12V
0.67A
0 ~ 0.67A
8W
250mVp-p
(max.) Note.2
Note.3
APV-8-5
5V
1.4A
0 ~ 1.4A
7W
250mVp-p
±5.0%
APV-8 series
APV-8-24
24V
0.34A
0 ~ 0.34A
8W
300mVp-p
±1.0%
±2.0%
500ms, 30ms / 230VAC 1500ms,30ms / 115VAC at full load
20ms/230VAC at full load
Note.4
90 ~ 264VAC 127 ~ 370VDC ( )
Note.6
47 ~ 63Hz
74%
80%
81%
0.15A/230VAC 0.3A/115VAC
COLD START 70A(twidth=120 s measured at 50% Ipeak) at 230VACμ
0.25mA / 240VAC
Hiccup mode, recovers automatically after fault condition is removed
Above 105% rated output power
Protection type : Hiccup mode, recovers automatically after fault condition is removed
5.75 ~ 6.75V
13.8 ~ 16V
27.6 ~ 32.4V
Protection type : Shut off o/p voltage, clamping by zener diode
-30 ~ +70 (Refer to "Derating Curve")℃
20 ~ 90% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH℃
±℃ ℃0.03%/ (0 ~ 45 )
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
Design refer to UL8750,CSAC22.2 No.250.0-08; EN60950-1,EN61347-1,EN61347-2-13
I/P-O/P:3.75KVAC
I/P-O/P:>100M Ohms / 500VDC / 25 / 70% RH℃
Compliance to EN55015,EN61000-3-2 ClassA,EN61000-3-3
Compliance to EN61547,EN61000-4-2,3,4,5,6,8,11; light industry level(surge 2KV), criteria A
1631.5K hrs min. MIL-HDBK-217F (25 )℃
60*30*23.5(L*W*H)
0.09Kg; 144pcs/14Kg/0.75CUFT
affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
File Name:APV-8-SPEC 2015-08-17
Page 3
8W Single Output Switching Power Supply
APV-8 series
Mechanical Specification
AC/N(Blue)
AC/L(Brown)
UL1569 18AWG
150 10±
Unit:mm
73.1
65.5
23.5
150 10±
UL1569 20AWG
+V(Red)
-V(Black)
60
30
8.5
Block Diagram
I/P
EMI FILTER
RECTIFIERS
POWER
SWITCHING
PWM
CONTROL
RECTIFIERS
&
FILTER
Derating Curve Static Characteristics
100
LOAD (%)
90
80
70
60
50
40
90
100
200
210
LOAD (%)
100
80
60
50
40
20
-30 0
10 20
30 40
60
50
45
(HORIZONTAL)
70
DETECTION
CIRCUIT
230
220
fosc : 67 KHz
250
240 264
+V
-V
AMBIENT TEMPERATURE ( )℃
INPUT VOLTAGE (VAC) 60Hz
File Name:APV-8-SPEC 2015-08-17
Loading...