MBM Corporation DocuVac Installation

Page 1
INSTALLATION INSTRUCTION
AIR FEED COLLATOR MODEL 100
SET STACKER MODEL 101
AND BASE 150001
T09145
Sep 2001
Part no. 14444
(6)
1
Page 2
INSTALLATION INSTRUCTION BASE MODEL100/101
T09145
(6)
2
Page 3
INSTALLATION INSTRUCTION MODEL 101 HCS
T09145
Mounting the battery cable
The battery cables are disconnected in order to avoid running down the battery during transport. Remove the six screws holding the cover and lift off the cover (1). Plug the connector (2) to the PCB. Mount the cover on the lift. Dock the Lift into the Model 101 HCS to charge the battery.
1
2
(6)
3
Page 4
INSTALLATION INSTRUCTION MODEL 101 HCS
Top cover
MODEL 101 HCS
T09145
LIFT
1(x4)
4
97139
3 (x4)
2
A locking device securing the Lift to the Model 101 HCS is controlled by the Model 101 HCS top cover. When pushing the Lift into the Model 101 HCS be careful not to damage the connector (2). The top cover must be opened before the Lift is pulled out. It is not necessary to open the cover when docking the Lift. See also the sign on top of the Lift.
1. The castors on the lift (3) are fixed mounted. Adjust the height of the Model 101 HCS (1) so the connector on the lift (2) fit to the connector on the Model 101 HCS. Thereafter adjust the height of Model 100. Then adjust other machines in-line. See next page.
2. It could however be necessary to adjust the height of the lift if the floor is uneven. Remove the wheels and place washer (4) (P/N 97139, 12.5 x 35 x 3 mm) in between the wheels and the lift to reach optimum height.
(6)4
Page 5
INSTALLATION INSTRUCTION MODEL 101 HCS
Alignment of the Model 101 HCS
T09145
NOTE: Check that the machines are parallel. Then
run a test set to see how the sheets are stacked on the Model 101 HCS. If necessary, make a fine adjustment of the machine heights.
(6)
5
Page 6
System Configuration
Connect terminator plugs according to sche­matic below . Connect interface cables be­tween each unit to establish communication.
Caution: Make sure all main power switches are
switched off before connecting/dis­connecting cables and termination plugs.
T09145
Terminator plug confuguration, viewed from rear.
F
M
(6)6
Loading...