Mazda 99-7509 User Manual
INSTALLATION INSTRUCTIONS FOR PART 99-7509
APPLICATIONS
Mazda 5 2006-2010
99-7509
KIT FEATURES
• Painted To Match Factory Dash
• DIN Radio Provision with Pocket
• ISO Mount Radio Provision with Pocket
• Double DIN Radio Provision
• Stacked ISO Mount Units Provision
KIT COMPONENTS
A) Radio Housing • B) ISO Brackets • C) ISO Trim Plate • D) Double DIN Brackets
• E) Double DIN Trim Plate • F) Snap In Pocket
B
A
E
Small Flat Blade Screwdriver/ Panel Removal Tool
1-800-221-0932
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
C
Wiring & Antenna Connections (sold separately)
F
TOOLS REQUIRED:
• Phillips Screwdriver
70-7903 - Mazda Harness 01-up
www.metraonline.com
D
99-7509
TABLE OF CONTENTS
Dash Disassembly
-
Mazda 5 2006-2010
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1,2
Kit Assembly
- DIN Radio Provision with Pocket . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
- ISO Mount Radio Provision with Pocket . . . . . . . . . . . . . . . . . . . . . . . 4
- Double DIN/Stacked ISO Units Provision . . . . . . . . . . . . . . . . . . . . . . . 5
Final
Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
*Note:
Refer also to the instructions included with the aftermarket radio.
99-7509 DASH DISASSEMBLY
P
R
N
M
-D
A/C
A
/C
MAZDA 5 2006-2010
For Models With Manual Climate Controls
Disconnect the negative battery ter-
1
minal to prevent an accidental short
circuit.
Unclip and remove the panel sur-
2
rounding the shift lever. (
Remove (2) Phillips screws exposed
3
below shift lever trim panel.
4
Unclip and remove the center console
side trim panels then remove (1)
Phillips screw per side behind panels.
(Figure C,D)
Continued on page 2.
Figure A)
(Figure B)
A
B
D
C
1
99-7509 DASH DISASSEMBLY
A/C
A/C
MAZDA 5 2006-2010
For Models With Manual Climate Controls
Unclip and pull the center console
5
towards the rear of the vehicle.
Note:
You do not have to remove
the center console completely.
(Figure E)
6
Remove (2) Phillips screws at the bottom of the radio trim panel then unclip
the panel including the factory radio.
Unplug and remove the panel.
The climate controls do not
Note:
come out with the panel.
(Figure F,G)
E
Continue to kit assembly.
F
G
2
Loading...