Maytronics Dolphin COMM. 12 User Manual
COMM. 12 Robotic Pool Cleaner
User Manual
EN
8151682
COMM. 12 Robotic Pool Cleaner | User Manual
EN
COMM. 12 Robotic Pool Cleaner
User Manual
Table of Contents
1. IMPORTANT SAFETY INSTRUCTIONS ...............................................................2
2. FCC STATEMENT .......................................................................................................3
3. SPECIFICATIONS AND WATER CONDITIONS...................................................3
4. Package CONTENTS ...............................................................................................3
5. ASSEMBLY INSTRUCTIONS...................................................................................4
6. DAILY OPERATION ...................................................................................................5
7. REMOTE CONTROL UNIT........................................................................................6
8. CLEANING THE FILTER ........................................................................................... 7
1
COMM. 12 Robotic Pool Cleaner | User Manual
1. IMPORTANT SAFETY INSTRUCTIONS
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
READ AND FOLLOW ALL INSTRUCTIONS.
Please adhere strictly to the following WARNINGS:
Take the Robotic Pool Cleaner out of the pool before allowing people to enter the pool.
When examining the Robotic Pool Cleaner, disconnect the main power supply.
Ensure that children do not attempt to access Robotic Pool Cleaner while it is operating.
Keep the Robotic Pool Cleaner out of the reach of children or persons with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction.
Only an original power cable must be used, at all times. Replaced by a Robotic Pool Cleaner
certified technician, in case of need to avoid hazard.
CAUTION
CAUTION
The unit must be connected only to a supply circuit that is protected by a ground-fault
circuit interrupter (GFCI). This GFCI should be tested on a routine basis.
To test the GFCI, push the test button. The GFCI should interrupt power.
Push the reset button. Power should be restored. If the GFCI fails to operate in this manner,
the GFCI is defective. If the GFCI interrupts power to the power unit without the test button
being pushed, a ground current may be flowing, indicating the possibility of an electric
shock. Do not use the power unit. Disconnect the power unit and contact the manufacturer
for assistance.
To reduce the risk of electric shock replace damaged cord immedietely. Do not use
extension cord to connect unit to electric supply; provide a properly located outlet.
Please ensure that the following PRECAUTIONS are implemented:
Only a trained operator should operate the Robotic Pool Cleaner.
Operator should keep hands away from driving belt mechanism.
CAUTION
2
Position the Caddy and power supply at least 3.5m/12ft from pool’s edge – during
operation.
For continued protection against possible electric shock, the power supply unit should be
placed at least 11cm / 4’’ above ground.
CAUTION
Loading...