Freestanding
Gas Range
STM01824 Rev. A.
This guide contains useful information, read it carefully.
No. Parte W10127974 Rev. A
Cover
the following
model:
MW39079
Parts and Features
Installation
Gas Supply Connection
How to Use Your Range
Cleaning and Maintenance
Warranty
Form
at Filed for Distribuitor
Authorized Service Centers
2
3
4
5
9
11
11
12
Parts and Features
¡ Congratulations !
2
This range was carefully manufactured with
the latest technical expertise. By purchasing
it, you have received quality.
Before you use your range, read the
instructions in this manual. The information
is important for best results in the use of
your range.
Index
Install your range in an area that is protected against weather exposure, on a level floor
strong enough to sustain its weight.
Do not allow range to be used by children or unqualified adults.
Provide for adequate maintenance.
Use the range only in home applications. It is not designed for commercial use.
Electric Characteristics:
127 V ± 10% 50/60 Hz 1,0 A Max.
MANUFACTURED BY:
INDUSTRIAS ACROS WHIRLPOOL, S,A, DE C.V. Unidad Celaya
km 280
CARRETERA PANAMERICANA C.P. 38020, CELAYA, GTO.
Tel. 01(461)6185500
PARTS AND FEATURES
Glass Lid
Aluminum Griddle
Upper Grates
Aluminum Standard Burners
Burner Caps
Aluminum Super Burner
Triple Crown Burner
Knob Integrated
Electronic Ignition
Oven light button
Self-slide Oven Rack
Oven Thermostat
Broiler
Oven Door
Cutt off valve
MW39079
Cercha
4
Cast Iron
1
1
with Thermocople
Drop down
Panoramic
Installation
EXHAUST DEVICE
!
WARNING
Fire or Explosion Hazard
Do not allow children to use or play with the range;
keep children away while range is in use.
Keep the range surroundings free of flammable material,
gasoline and other vapors or flammable liquids.
Do not get too close to the flame produced by the
burners or wear loose clothing; your clothes may ignite
if contact by open flames.
Do not use your range to warm rooms, because this is
dangerous.
Failure to do so can result in death, fire or explosion.
Proper installation is your responsibility. A qualified
technician or Service technician must install this
range.
Remove all packing material and put the range
accessories in their places.
Select the best location in your kitchen for your
range, protected from wind and with enough space
to open the oven door.
61 cm
min.
Do not install cabinetry directly above the range.
If you will install an exhaust device, put it at 61 cm
minimum from the range cooktop.
Do not use extension cords or multiple outlets.
3
Gas Supply Connection
GAS SUPPLY CONNECTION
To connect the range, use the material shown in the bottom figure.
1
Shut off gas valve
integrated to the range
3/8" copper pipe
with 5/8" flared
type nut or
metallic flexible
special hose for
gas
3/8" shut off
valve
3/8" copper pipe with
5/8" flared type nut.
Necessary
length to reach the
gas
Gas
regulator
3/8" NPT to 3/8" brass pipe
fitting hex. adapter
NOTE: The material shown for installation is not provided with the range.
Check with soap solution for leaks.
2
If the installation is not
new, you should clean
it in order to avoid the
obstruction of orifices
and/or pilots.
IMPORTANT
This range is adjusted at the factory
for use with L.P. gas.
To use this range with natural gas,
you must replace the surface and
oven burner orifices, call Servicio
Acros-Whirlpool, the phone number
is shown in the page 11. The
technician must make sure that the
connections have no leaks and the
gas pressure in the range is the
same as shown in the charts.
3/8" brass pipe
fitting
Hex. adapter
To make it easier to move the
appliance, the installer should
loop the 3/8" copper tubing as
shown in the illustration.
LP GAS OPERATING PRESSURE
11 in WATER COLUMN
(6,36 oz/squared inch)
BURNER
UPPER STD ALUM.
UPPER SUPER ALUM.
TRIPLE CROWN
OVEN
NATURAL GAS OPERATING
PRESSURE 7 in WATER COLUMN
(4,04 oz/squared inch)
BURNER
UPPER STD ALUM.
UPPER SUPER ALUM.
TRIPLE CROWN
OVEN
ORIFICE
NUMBER
74
78
92
57
ORIFICE
NUMBER
105
115
132
52
ORIFICE
DIAMETER
INCHES
0,0291
0,0307
0,036
0,0224
ORIFICE
DIAMETER
INCHES
0,0413
0,0452
0,0519
0,0204
THERMAL
CAPACITY
BTU/h
6 700
7 100
10 500
13 000
THERMAL
CAPACITY
BTU/h
6 700
7 100
10 500
13 000
NOTE: To operate this range with natural gas,
is required a kit according to the chart:
Model LP to Gas Natural Natural to LP
MW39079 W10127972 W10127973
This kit is available at your nearest Authorized Service
Center.
4
5
How to Use Your Range
NOTE:
Do not obstruct the gas
exhaust of the oven or broiler
If the oven burner has yellow flames, it may
require adjustment to the air shutters:
HOW TO ADJUST THE FLAMES
NOTE: Because of different altitudes above
sea level and variations in the supply of gas,
you may need to adjust the main air intake
to the burners. This will result in a better
air-gas mixture and thus a better operation.
How to adjust the oven burner air shutter:
Remove the
oven rack.
(See page 6).
Remove the oven
tray. (See page 7).
1
2
3
A - Locate the screw on
the air shutter and
loosen it.
B - Turn around the air
shutter.
C - Turn on the oven.
D - Verify that the flames
are blue.
E - If the flames are not
blue, repeat since
step
B. W
hen the
flames are adjusted,
tighten the screw
again.
F - Replace the oven tray
and the oven rack.
Knob in ignition position.
SURFACE BURNERS WITH ELECTRONIC IGNITION
To turn on the surface burners with electronic
ignition in the knob:
1.- Your range has electronic ignition integrated in knobs,
to operate, push and turn the desired knob to the
ignition position. (See illustration).
2.- To stop the sparks turn the knob to the maximum
flame position.
NOTE:
In the case on power cut, your range can be ignited manually.
6
HOW TO TURN ON THE BURNERS MANUALLY
To turn on the surface burners manually:
1.- Light a match and place it close the burner while you
push and turn the knob 1/4 of the way,the burner will
light immediatly. .
M
INIM
UM
FLAM
E
M
AXIM
UM
FLAM
E
Knob on the m
ark of ignition.
ANTIADHERENT ALUMINIUM GRIDDLE
Your range has an aluminium griddle with antiadherent finish, to use it remove a top grate
and put the griddle.
NOTE:
Use the griddle with MINIMUM FLAME.
Apply some butter before use the griddle to protect the finish.
Use plastic utensils to protect the griddle against scratches.
Do not use abrasive materials like steel or plastic fibres to clean it.
Use only cloth or sponge, soap or detergent and rinse with water.
How to light the oven burner manually:
1.- Open the oven door, light
a match and place the flame
at the igniter hole in the front of the oven tray while you
push in and turn the oven knob, the burner will light
immediately.
2.- Verify that the oven burner has been ignited.
MINIM
UM
FLAM
E
M
AXIM
UM
FLAM
E
How to use the oven with electronic ignition:
OVEN WITH ELECTRONIC IGNITION
If your range have a oven with electronic ignition
1.- Push and turn the oven knob counter clockwise, push
the independent electronic ignition button, it´s located on
the left side of the manifold panel, with some oven
temperature, push the knob 3 or 4 seconds and the oven
burner will ignite automatically. Remain pressed the knob
until the burner is on when you release the knob (10
seconds approximately).
2.- Select the desired temperature.
To operate the oven.
7
RETRACTABLE OVEN RACK
The oven rack can be placed in 5 different positions. For your convenience this rack is
retractable
4.- Take out the rod wire of the
supports.
How to remove the oven rack
1.- Lift the oven rack
A from the rear
an then from the front in order to
remove it.
2.- The supports of
the oven rack can
be removed also, to remove them
take off the edge of the wire
B that is
hooked in the oven door.
3.- Slide the support out with the
metal rollers through the aperture of
the side rail
C.
A
B
C
How to Install the oven rack:
1.- Insert the rod wire in the supports.
2.- Install the supports passing the
metal rollers through the aperture of
the central rail and then push to the
rear.
3.- Insert the extreme of the wire in
the base
D that is located in the oven
door.
4.- Put the oven rack in the desired
level, placing first the rear supports
and the front supports after. Make
sure it is fixed firmly.
D
8
TRIPLE CROWN BURNER
Your range has a new burner, which for its
new size, power divided in 3 flames is ideal
to use in cooking that requires uniform heat
like hot cakes and crepes using low flame and
its high flame due its power and size is ideal
for huge pots.
Before set it on, make sure that its two caps
are properly placed.
Interior Cap
Exterior Cap
Burner
Burner Base
Caps properly placed
To assembly the burner with the burner
base, make sure the registers
A and
B which are in upper side of burner
base and lower side of burner match
for a properly assembly.
AB AB