Maytag MEW5530BAB, MEW5530BAW Dimension Guide

Maytag MEW5530BAB, MEW5530BAW Dimension Guide

www.dexpress.com DIMENSION EXPRESS Fax on Demand (775) 833-3600

This Data Sheet Includes Information On

Maytag

• Product Model Number (s): •

30" Undercounter or Wall Ovens: MEW5530BAB and MEW5530BAW

 

Dimensions (Actual Size)

 

 

 

Cutout width:

28

3/16"

 

 

Cutout height:

27

7/16"

 

 

Minimum cabinet width: 30"

 

 

Minimum cabinet depth: 24"

Recommended

cutout location from floor : 4" - 33"

 

Distance from face of cabinet to

 

 

 

outer edge of open door (Door swing):

20

1/2"

Distance from face of cabinet to

front of closed door handle: 15/16" Overall unit width: 29 3/4" Overall unit height: 27 3/4"

Penetration into cabinet: 23 1/2"

Oven overlap distances when using cutout dimensions listed above:

Top overlap: see below

Bottom overlap: 0"

Right side overlap: 23/32"

Left side overlap: 23/32"

Additional Information

Approved for undercounter installation.

The unit does NOT overlap the top of the opening. There is a trim piece that covers the top edge of the cutout a very small amount (less than 1/16").

Do Not block air intake slots along bottom of oven.

IMPORTANT: nylon grip nuts that hold crate bottom must be removed before installation.

A three-wire, single phase, A.C. 120/208-240 volt, 60Hz cycle electrical system protected by a 30 amp fuse or comparable circuit breaker must be provided . 7/8" O.D. flexible cable 4 feet long is furnished by manufacturer. Mount junction box in area under plywood floor if adequate lower cabinet space is available. Locate 1 1/4" conduit access hole in the back right hand side of the plywood floor.

SEE PAGE 2 FOR UNDERCOUNTER INSTALLATION

Subject to change without notice. This system is designed to

 

be updated daily if necessary. Dimension Express is not

 

responsible for use of superseded, voided, or outdated data

 

sheets. Because of the difficulty or impracticability of deter-

 

mining actual damages, liability of Dimension Express shall

 

not exceed $50.00.

 

Copyright © Dimension Express, 2002.

214

30"

28 3/16"

 

 

 

 

 

24"

 

 

 

 

 

Cabinet Opening

(not to scale)

27 7/16"

Electrical box

4" - 33"

Overall Dimensions

(not to scale)

27 3/4"

23 1/2"

29 3/4"

15/16"

• NEVER reuse Data Sheets. Data Sheets are subject to change without

• Call Dimension Express if you have any questions at (775) 833-3633 •

notice. Dimension Express is a FREE service bureau and is updated daily,

• Always refer to a current Code at a Glance or manufacturer directory •

it makes far more sense to spend the time necessary to request new Data

• Data Sheet codes change on the first of odd numbered months at 12:01am •

Sheets for each project, as opposed to the problems, time, costs, and risks

BN372 • A214B149 • • 032603 • 95655 • 41793

associated with reusing old Data Sheets.

www.dexpress.com

 

 

 

 

This Data Sheet Includes Information On

 

 

 

 

DIMENSION EXPRESS

 

 

 

 

Maytag

 

 

 

 

Page 2

 

 

Product Model Number (s):

 

 

 

 

 

 

 

 

Fax on Demand (775) 833-3600

 

 

 

30" Undercounter or Wall Ovens:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

MEW5530BAB and MEW5530BAW

 

 

 

 

Additional Information:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

•A complete floor is recommended to prevent unusual drafts and capable of supporting 142 lbs.

Minimum distance from bottom of opening to any object protruding from cabinet face (i.e. cabinet door) directly below: 1" (because it is an air flow area)

If you are stacking two units: Maximum distance from floor to bottom of lower oven opening is 7 1/2". Minimum distance from top of lower oven opening to bottom of upper oven opening is 3/4".

House wire to enter junction box at left side. Range wires to enter right side of junction box.

IMPORTANT : CANADA INSTALLATIONS ONLY - Breaker box provided with oven must be located in an adjacent accessible location on either side of oven (undercounter) or below (wall mount).

See below for undercounter installation.

• When installing 2 units side-by-side, the openings must be separated a minimum of 6". Each unit must have its own electrical box located on the wall of the opening.

 

Gas connection for cooktop must be

 

 

 

Cabinet (under counter) Opening

 

located in adjacent left accessible location

 

 

 

 

 

 

 

(not to scale)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

25" normal counter top depth

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1 1/4" Conduit access hole

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Minimum distance from the

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

top of the counter top when

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

installing a Maytag Gas

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

cooktop above: 32". Gas

 

 

 

 

 

 

 

 

 

 

23 1/2"

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

and electrical connections for

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1 1/2" countertop

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

the cooktop must be located

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

27 7/16"

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

in left adjacent accessible

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

location. For cooktop

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

dimensions please request

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

the proper data sheet.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Bottom should support 142 lbs.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

28 3/16"

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Minimum distance from the top of

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

the counter top when installing a

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Maytag electric cooktop above:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

24"

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

29 11/16". For cooktop

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

dimensions please request the

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

proper data sheet.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

36" countertop height reccomended

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Subject to change without notice. This system is designed to be updated daily if necessary. Dimension Express is not responsible for use of superseded, voided, or outdated data sheets. Because of the difficulty or impracticability of determining actual damages, liability of Dimension Express shall not exceed $50.00.

Copyright © Dimension Express, 2002.

149

• NEVER reuse Data Sheets. Data Sheets are subject to change without

• Call Dimension Express if you have any questions at (775) 833-3633 •

notice. Dimension Express is a FREE service bureau and is updated daily,

• Always refer to a current Code at a Glance or manufacturer directory •

it makes far more sense to spend the time necessary to request new Data

• Data Sheet codes change on the first of odd numbered months at 12:01am •

Sheets for each project, as opposed to the problems, time, costs, and risks

BN372 • A214B149 • • 032603 • 95655 • 41793

associated with reusing old Data Sheets.

Loading...