MATCR515D Digital DAB & FM Radio
1
Safety Warnings
Please note: Because DAB digital radio is a developing technology, station
availability can change without notice. As new multiplexes and transmitters
are turned on, new stations will begin transmitting and new postcodes will be
able to receive DAB digital radio. Conversely, some DAB radio stations may
disappear without notice.
Covers - Do not remove any fixed covers as this may expose dangerous
voltages.
Weather - It is advisable to unplug an external aerial during a thunderstorm.
Ventilation - The ventilation holes on the casing prevent your product from
over heating. Do not block or cover these holes, especially with cloth or paper.
It is recommended you leave a 10cm gap all around the unit.
Damage - Never use the product if it is damaged in any way. Always place the
unit on a flat level surface avoiding anywhere which may be subject to strong
vibration.
Temperature - Avoid extremes of temperature, either hot or cold, place your
product well away from heat sources such as radiators or gas/electric fires.
Don’t use this unit in tropical climates.
Moisture - Do not allow your product to be exposed to rain, moisture or dust.
If any liquid is spilt into this product it can cause serious damage. If you spill
any liquid switch the unit off at the mains immediately. Contact your store
immediately.
Naked Flames - Naked flames such as candles and night lights should not be
placed on or near the unit.
Accessibility - ensure that any mains plug is easily accessible.
Protect Fine Furniture - Use protective material under the unit when placing
it on a surface with a natural or lacquer finish.
2
Table of Contents
Location of Controls ................................................. 3
Getting Started ........................................................ 4
Restoring the Factory Settings .................................. 4
Listening to DAB Radio ............................................ 5
Secondary services .............................................. 5
Listening to FM Radio .............................................. 6
Storing and Recalling Preset Stations ....................... 6
Storing Preset Stations ......................................... 6
Selecting Preset Stations ...................................... 6
Setting the Clock ..................................................... 7
Using the Alarm Function ......................................... 8
Setting an Alarm .................................................. 8
When the Alarm Turns On .................................... 9
Deactivating and Reactivating an Alarm ................. 9
Changing the Snooze Time ................................. 10
Using the Sleep Function .................................... 10
Specifications ........................................................ 11
3
Location of Controls
4
Getting Started
1. Connect the AC adapter to the mains supply and then connect
the adapter plug to the DC connector.
2. Carefully extend the antenna wire.
3. Press the STANDBY button to switch on your radio.
The radio will perform a quick scan of UK Band III DAB
channels. The display will show "AUTOSCAN".
The radio then starts scanning for stations and the display
shows “DAB *”.
When autoscan finishes, the unit switches to standby.
If no stations are found it may be necessary to relocate your
radio to a position giving better reception.
4. Press the STANDBY button to switch on your radio.
5. Press the VOLUME+ or VOLUME- buttons to adjust the volume
level.
Restoring the Factory Settings
If you move the radio to another part of the country, your pre-tuned
DAB stations may not be available. To make the radio autoscan for
new DAB stations, please do the following:
1. Press and hold the STANDBY button until the display shows
"RESET ***", then release the STANDBY button.
2. When the display shows "RESET OK", press the STANDBY
button again. The radio will start scanning for DAB stations as
described in "Getting Started".
5
Listening to DAB Radio
1. Press the TUNE+ or TUNE- buttons to scroll through the list of
available stations. The display shows the name of the selected
station.
2. Position the antenna wire to give the best reception, using the
signal strength display as a guide.
If the selected station is unavailable, the display will flash “NO
SIGNL”.
Secondary services
1. Some DAB radio stations have one or more secondary services
associated with them. If a station has a secondary service, the
display will flash "Secondary" for 4 seconds each minute.
2. To listen the secondary service, press the TUNE+ button. The
display shows “Secondary”.
Loading...