Martin Pro VDO Sceptron 20 Datasheet
G A L L E R Y
VDO Sceptron 20
The VDO Sceptron 20 is a linear outdoor-rated LED video fixture for
the rental market with 20 mm pixel pitch and an extensive range of
optical accessories for a wide variety of looks. The VDO Sceptron 20
is driven by the Martin P3 System Controller family for easy
configuration, mapping and setup, and is also backwards compatible
with DMX for smaller setups. The integrated power and data cabling
allows for long daisy-
chains with many fixtures per cable
-run, while
the power supply can be located backstage (up to 50 m away) for a
clean setup avoiding messy cabling and several driver boxes.
Extensive range of field-exchangeable optical accessories for a wide variety of
looks
Easy setup, mapping and configuration
Bright and fully calibrated for optimal consistency
F E A T U R E S
T E CHNI CA L S P E CI F I CA T I O NS
Physical
Control and Programming
Control/User Interface
•
20 mm pixel pitch
•
125 cd per meter calibrated
•
375 lumen per meter calibrated
•
High
-quality 16-bit per color image processing technology
•
Pixel
-level brightness and color calibration for optimal image quality
•
P3/DMX controllable (automatic protocol detection)
•
Intuitive mapping and addressing via P3 System Controller
•
Combined power/data input (single cable for power and data input)
•
Supported by integrated power and data processor (P3 PowerPort 1500
or P3 PowerPort 1000 IP) and simple cabling system
•
Available in lengths of 1000 mm and 320 mm
Length: Available in 320 mm (12.6 in.) and 1000 mm (39.4 in.) versions
Width: 27 mm (1.07 in.)
Height: 28 mm (1.10 in.)
Weight: 1.2 kg / m (0.81 lbs. per foot)
Control options: Martin P3™ System Controller via Martin P3™ PowerPort 1500 /
Martin P3™ PowerPort 1000 IP and/or DMX
Protocol detection: Automatic
Control modes: RGB, basic, segment and pixel-level
Setting and addressing: Martin P3™ System Controller or RDM-compliant controller
Control resolution: 16-bit (P3) or 8-bit (DMX) control of each color
Color and intensity calibration: Pixel-level
DMX compliance: USITT DMX512-A
RDM compliance: ANSI/ESTA E1.20
Firmware update: Via Martin P3™ System Controller
DMX channels: 3/10/13/22/55/157
Device status: Multi-color visual indication
Device test and reset: Magnetic pushbutton to call up local test patterns and reset
device
©
2015 Martin Professional
Olof Palmes Allé 18 • 8200 Aarhus N • Denmark • Phone: +45 87 40 00 00 • Fax: +45 87 40 00 10 • www.martin.com
Images contained in this brochure have been converted to CMYK and are not necessarily representative of actual colors. Specifications are subject to change without notice
Optics
Photometric Data
Video Processing
Signal Protocol
Construction
Installation
Connections
Electrical
Thermal
Approvals
Accessories
Options:
Open Front
Flat Diffuser
Flat Smoked Diffuser
Round Diffuser
Round Smoked Diffuser
Square Diffuser
Square Smoked Diffuser
Tube Diffuser
Tube Smoked Diffuser
Minimum LED lifetime: 50 000 hours (to >70% luminous output)*
*Figure obtained under manufacturer’s test conditions:
All options can be interchanged at any time:
Color resolution: 16 bits per color (48 bits per pixel)
Viewing angle: 120° x 120°
Pixels per meter: 50
Pitch (pixel center-to-center): 20.0 mm
Luminous intensity, calibrated mode: 125 cd per meter*
Total output, calibrated mode: 4 166 nits (modules spaced 30 mm center-to-center)*
Total output, calibrated mode: 375 lumens per meter*
*Preliminary data, figures are approximate
Brightness control
Gamma correction and control
Color temperature control
Color space control
Calibration processing
Synchronization
Martin P3 (via Martin P3™ PowerPort) or DMX
Base: Extruded aluminum profile
Color: Matt black
Protection rating: IP65
RoHS compliant
Orientation: Any
Mounting: Slot for locking nuts on back of profile (M6) and optional sliding bracket for
M12 bolt
Mounting options: Flat surface at any angle, pedestal or other suitable support
Power and data input: 6-pin custom (BBD) IP66-rated
Power and data thru: 6-pin custom (BBD) IP66-rated
Nominal input voltage: 48 VDC +/- 4%
Power supply options: Martin P3™ PowerPort 1500, P3™ PowerPort 1000 IP, Tripix™
Power or generic 48 VDC PSU
Total power consumption (at max. intensity, full white): 17 W per meter
Cooling: Convection
Maximum ambient temperature (Ta max.): 55° C (113° F)
Minimum ambient temperature (Ta min.): -20° C (-4° F)
Total heat dissipation (calculated, +/- 10%): 60 BTU/hr per meter
EU safety: EN 60950-1, 60950-22, EN 62471
EU EMC: EN 55032, EN 55024
US safety (pending): UL 60950-1, UL 60950-22
US EMC: FCC Part 15 Class A
Canadian safety (pending): CSA C22.2 No. 60950-1, No. 60950-22
Canadian EMC: ICES-003 Class A
Australia/NZ: C-Tick N4241
VDO Sceptron/Pixline Acc. and Test Tools, set of 10: P/N 91610139
Hardware
VDO Sceptron™ Sliding Brackets, set of 10: P/N 91610123
VDO Sceptron™ Parallel Couplers, 30/40/50 mm, set of 10: P/N 91610125
VDO Sceptron™ Parallel Couplers, 60/70/80 mm, set of 10: P/N 91610138
VDO Sceptron™ Linear (End-to-End) Couplers, set of 10: P/N 91610124
Super Lightweight Half Coupler Rigging Clamp, black: P/N 91602018
Optical
320 mm modules
VDO Sceptron™ Flat Diffuser, 320 mm: P/N 91610111
VDO Sceptron™ Flat Smoked Diffuser, 320 mm: P/N 91610113
VDO Sceptron™ Round Diffuser, 320 mm: P/N 91610115
VDO Sceptron™ Round Smoked Diffuser, 320 mm: P/N 91610117
VDO Sceptron™ Square Diffuser, 320 mm: P/N 91610119
VDO Sceptron™ Square Smoked Diffuser, 320 mm: P/N 91610121
VDO Sceptron™ Tube Diffuser, 320 mm: P/N 91611630
VDO Sceptron™ Tube Smoked Diffuser, 320 mm: P/N 91611650
1000 mm modules:
VDO Sceptron™ Flat Diffuser, 1000 mm: P/N 91610112
VDO Sceptron™ Flat Smoked Diffuser, 1000 mm: P/N 91610114
©
2015 Martin Professional
Olof Palmes Allé 18 • 8200 Aarhus N • Denmark • Phone: +45 87 40 00 00 • Fax: +45 87 40 00 10 • www.martin.com
Images contained in this brochure have been converted to CMYK and are not necessarily representative of actual colors. Specifications are subject to change without notice
Loading...