Martin Pro VDO Sceptron 10 Datasheet



G A L L E R Y

VDO Sceptron 10

The VDO Sceptron 10 is a linear outdoor-rated LED video fixture for
the rental market with 10 mm pixel pitch and an extensive range of
optical accessories for a wide variety of looks. The VDO Sceptron 10
is driven by the Martin P3 System Controller family for easy
configuration, mapping and setup, and is also backwards compatible
with DMX for smaller setups. The integrated power and data cabling
allows for long daisy-

chains with many fixtures per cable

-run, while
the power supply can be located backstage (up to 50 m away) for a
clean setup avoiding messy cabling and several driver boxes.

Extensive range of field-exchangeable optical accessories for a wide variety of
looks

Easy setup, mapping and configuration

Bright and fully calibrated for optimal consistency

F E A T U R E S

T E CHNI CA L S P E CI F I CA T I O NS

Physical

Control and Programming

•

10 mm pixel pitch

•

250 cd per meter calibrated

•

750 lumen per meter calibrated

•

High

-quality 16-bit per color image processing technology

•

Pixel

-level brightness and color calibration for optimal image quality

•

P3/DMX controllable (automatic protocol detection)

•

Intuitive mapping and addressing via P3 System Controller

•

Combined power/data input (single cable for power and data input)

•

Supported by integrated power and data processor (P3 PowerPort 1500
or P3 PowerPort 1000 IP) and simple cabling system

•

Available in lengths of 1000 mm and 320 mm

Length: Available in 320 mm (12.6 in.) and 1000 mm (39.4 in.) versions
Width: 27 mm (1.07 in.)
Height: 28 mm (1.10 in.)
Weight: 1.2 kg / m (0.81 lbs. per foot)

Control options: Martin P3™ System Controller via Martin P3™ PowerPort 1500 /
Martin P3™ PowerPort 1000 IP, and/or DMX
Protocol detection: Automatic
Control modes: RGB, basic, segment and pixel-level
Setting and addressing: P3 System Controller or RDM-compliant controller
Control resolution: 16-bit (P3) or 8-bit (DMX) control of each color
Color and intensity calibration: Pixel-level



©

2015 Martin Professional

Olof Palmes Allé 18 • 8200 Aarhus N • Denmark • Phone: [phone] • Fax: [phone] • www.martin.com

Images contained in this brochure have been converted to CMYK and

are not necessarily representative of actual colors. Specifications are subject to change without notice

Control/User Interface

Optics

Photometric Data

Video Processing

Signal Protocol

Construction

Installation

Connections

Electrical

Thermal

Approvals

Accessories

DMX channels: 3/10/13/22/103/307

DMX compliance: USITT DMX512-A

RDM compliance: ANSI/ESTA E1.20

Firmware update: Via Martin P3™ System Controller

Device status: Multi-color visual indication

Device test and reset: Magnetic pushbutton to call up local test patterns and reset
device

Options

Open Front

Flat Diffuser

Flat Smoked Diffuser

Round Diffuser

Round Smoked Diffuser

Square Diffuser

Square Smoked Diffuser

Tube Diffuser

Tube Smoked Diffuser
Minimum LED lifetime: 50 000 hours (to >70% luminous output)*

*Figure obtained under manufacturer’s test conditions.
All options can be interchanged at any time.

Color resolution: 16 bits per color (48 bits per pixel)
Viewing angle: 120° x 120°
Pixels per meter: 100
Pitch (pixel center-to-center): 10.00 mm
Luminous intensity, calibrated mode: 250 cd per meter*
Total output, calibrated mode: 8 333 nits (modules spaced 30 mm center-to-center)*
Total output, calibrated mode: 750 lumens per meter*

*Preliminary data, figures are approximate.

Brightness control
Gamma correction and control
Color temperature control
Color space control
Calibration processing
Synchronization

Martin P3 (via Martin P3™ PowerPort) or DMX

Base: Extruded aluminum profile
Color: Matt black
Protection rating: IP65
RoHS compliant

Orientation: Any
Mounting: Slot for locking nuts on back of profile (M6) and optional sliding bracket for
M12 bolt
Mounting options: Flat surface at any angle, pedestal or other suitable support

Power and data input: 6-pin custom (BBD) IP66-rated
Power and data thru: 6-pin custom (BBD) IP66-rated

Nominal input voltage: 48 VDC +/- 4%
Power supply options: Martin P3™ PowerPort 1500, P3™ PowerPort 1000 IP, Tripix™
Power or generic 48 VDC PSU
Total power consumption (at max. intensity, full white): 33 W per meter

Cooling: Convection
Maximum ambient temperature (Ta

max.):

55° C (113° F)

Minimum ambient temperature (Ta

min.): -

20° C (-4° F)

Total heat dissipation (calculated, +/- 10%): 115 BTU/hr per meter

EU safety: EN 60950-1, EN 60950-22, EN 62471
EU EMC: EN 55032, EN 55024
US safety (pending): UL 60950-1, UL 60950-22
US EMC: FCC Part 15 Class A
Canadian safety (pending): CSA C22.2 No. 60950-1, No. 60950-22
Canadian EMC: ICES-003 Class A
Australia/NZ: C-Tick N4241

VDO Sceptron/Pixline Acc. and Test Tools, set of 10: P/N 91610139

Hardware

VDO Sceptron™ Sliding Brackets, set of 10: P/N 91610123
VDO Sceptron™ Parallel Couplers, 30/40/50 mm, set of 10: P/N 91610125
VDO Sceptron™ Parallel Couplers, 60/70/80 mm, set of 10: P/N 91610138
VDO Sceptron™ Linear (End-to-End) Couplers, set of 10: P/N 91610124
Super Lightweight Half Coupler Rigging Clamp, black: P/N 91602018

Optical
320 mm modules:

VDO Sceptron™ Flat Diffuser, 320 mm: P/N 91610111



©

2015 Martin Professional

Olof Palmes Allé 18 • 8200 Aarhus N • Denmark • Phone: [phone] • Fax: [phone] • www.martin.com

Images contained in this brochure have been converted to CMYK and

are not necessarily representative of actual colors. Specifications are subject to change without notice