Marshall MG15GR Gold, MG15G Gold OWNER’S MANUAL

MG15

MG15R

OWNER’S MANUAL

INTRODUCTION

Congratulations on your purchase of this MG Gold amplifier from Marshall Amplification.

The MG provides modern Marshall tones for the playerwho is on the go.

With your MG you can easily dial in storable sounds and effects including sparkling clean, rich driven blues, rock tone and heavy distorted metal settings. Every element from voicing through to the speaker has been carefully designed to give you flexibility at your fingertips.

From the punchy 10 watt to the powerful 100 watt each MG Gold amplifier is quick to set-up and delivers time and time again. Whetheryou are practicing at home or gigging on the road, the MG Gold not only looks good, it won’t let you down.

We hope you enjoyyour MG Gold amplifier.

- The Marshall Team

WARNING! IMPORTANT SAFETY INSTRUCTIONS

WARNING:

Before going any further, make sure that your amplifier is compatible with your mains electricity supply. Ifyou have any doubt, please seek help from a qualified technician – your Marshall dealer can help you in this respect.

MAINS INPUT & FUSE:

The specific mains input voltage rating that your amplifier has been manufactured for is indicated on the rear panel of the amplifier. The correct value and type of mains fuse is specified on the rear panel of each amplifier.

NEVER attempt to bypass the fuse or fit one of the incorrect value or type.

TRANSPORTING YOUR EQUIPMENT:

Please ensure that your amplifier is switched off, unplugged from the mains electricity supply and that all removable cables have been disconnected from your equipment before attempting to move it.

IMPORTANT SET UP INFORMATION:

WARNING:

Failure to select the correct impedance may damage your amplifier.

If connecting a speaker cabinet make sure that you use a proper speaker cable. Never use a screened (shielded) guitar cable for this purpose.

1.Ensure that the MAINS (power) switch is set to the OFF position.

2.Connect the supplied mains (power) lead into the MAINS INPUT first and then into the mains electricity supply.

3.Ensure that the VOLUME controls on the front panel are set to zero.

4.Plug your guitar into an INPUT jack socket.

5.Turn the front panel MAINS switch to the ON position.

6.Turn the VOLUME up to your preferred level and your amplifier is ready to play.

ENGLISH		ENGLISH