Marshall MG15GR Gold, MG15G Gold OWNER’S MANUAL

M
G
15
M
G
15R
OWNER’S MANUAL
INTRODUCTION
WARNING! IMPORTANT SAFETY INSTRUCTIONS
Congratulaons on your purchase of this MG Gold amplier from Marshall Amplicaon.
The MG provides modern Marshall tones for the player who is on the go.
With your MG you can easily dial in storable sounds and eects including sparkling clean, rich driven blues, rock tone and heavy distorted metal sengs. Every element from voicing through to the speaker has been carefully designed to give you exibility at your ngerps.
From the punchy 10 wa to the powerful 100 wa each MG Gold amplier is quick to set-up and delivers me and me again. Whether you are praccing at home or gigging on the road, the MG Gold not only looks good, it won’t let you down.
We hope you enjoy your MG Gold amplier.
- The Marshall Team
WARNING:
Before going any further, make sure that your amplier is compable with your mains electricity supply. If you have any doubt, please seek help from a qualied technician – your Marshall dealer can help you in this respect.
MAINS INPUT & FUSE:
The specic mains input voltage rang that your amplier has been manufactured for is indicated on the rear panel of the amplier. The correct value and type of mains fuse is specied on the rear panel of each amplier.
NEVER aempt to bypass the fuse or t one of the incorrect value or type.
TRANSPORTING YOUR EQUIPMENT:
Please ensure that your amplier is switched o, unplugged from the mains electricity supply and that all removable cables have been disconnected from your equipment before aempng to move it.
IMPORTANT SET UP INFORMATION:
WARNING:
Failure to select the correct impedance may damage your amplier.
If connecng a speaker cabinet make sure that you use a proper speaker cable. Never use a screened (shielded) guitar cable for this purpose.
1. Ensure that the MAINS (power) switch is set to the OFF posion.
2. Connect the supplied mains (power) lead into the MAINS INPUT rst and then into the mains electricity supply.
3. Ensure that the VOLUME controls on the front panel are set to zero.
4. Plug your guitar into an INPUT jack socket.
5. Turn the front panel MAINS switch to the ON posion.
6. Turn the VOLUME up to your preferred level and your amplier is ready to play.
ENGLISHENGLISH
Loading...
+ 2 hidden pages