Market Forge 1600 Service Manual

OWNER’S MANUAL

ELECTRIC COUNTER TILTING ROUND SKILLET

R-1600E

An Employee Owned Company

35 Garvey Street ● Everett ● MA ● 02149-4403 Form No. S-6000 ● 03/07
Tel: [phone] ● Fax: [phone] (MA)
Toll Free: [phone] ● Outside MA Fax: [phone]
Customer Service: custserv@mi.com ● Visit Us At: www.mi.com

TABLE OF CONTENTS

INSTALLATION

INSTALLATION ........................................................

SERVICE CONNECTIONS ......................................

DIMENSIONS & SERVICE CONNECTIONS ..........2

OPERATION

OPERATING INSTRUCTIONS ................................

THERMOSTAT SETTINGS ......................................

MAINTENANCE

PERIODIC CLEANING ............................................3

ADJUSTMENTS ......................................................

ILLUSTRATED PARTS LIST

ELECTRIC SKILLET EXPLODED VIEW .................4

ELECTRIC SKILLET PARTS LIST ..........................5

1
2

3
3

3

INSTALLATION

INSTALLATION:

Position unit on counter allowing sufcient rear clear-

1.
ance from wall to tilt freely and completely without
obstruction.

Mark four corner locations of unit base, as shown in

2.

gure 1.

Remove unit from counter and locate position of four

3.

holes as per gure 1.

Apply a continuous bead of silastic or other equiva-

4.
lent sealant along the complete perimeter edge of the
unit base.

Use 5/16-18 hex cap screws with suitable at wash-

5.
ers to bolt down. Screw length must be 1 1/4” long
plus counter top thickness.

Wipe off excess sealant.

6.

A control box with power supply equivalent to electri-

7.
cal rating of appliance should be located conveniently

nearby.

A waterproof electrical connection for power supply to

8.
console housing must be provided.

Ground unit to terminal provided inside console hous-

9.
ing.

Turn power on and check for proper operation.

10.

Figure 1

1