Page 1
Relay
Bottom Ice Machine
Bottom Ice Machine
Drill 1/2 inch
Wire Harness
Q MODEL ICE MACHINES
STACKING RELAY KIT 7628973
Installation Instructions
This relay kit is used to stop the operation of both stacked ice machines, when the bottom ice machine is turned off or in an
auto-shutdown mode (full bin of ice). It can only be utilized with 230 volt, 50/60 Hz., 1 phase ice machines.
STEP 1. Disconnect power.
STEP 2. Drill 1/2 inch (.50) hole in the back corner
posts of both ice machines in area indicated.
Install two plastic black bushings into drilled
holes.
STEP 3. Route wire harnes s through bushings from top
electrical box to bottom electrical box.
STEP 4. Using double-face tape, mount relay in bottom
ice machine electrical box.
STEP 5. Wire the stacking kit relay according to wire diagram on reverse side.
A. Relay coil
B. Relay Co ntact
1) Disconnect the wire of the bin switch, connected to ground,
2) Using new connector supplied, connect the wire disconnected from the ground to the new wire harness
3) Connect the other lead of wire harness to cabinet ground in the top ice machine (same ground that the bin switch
Manitowoc Ice, Inc.
2110 South 26 Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA 8011463
Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 Sheet 1 of 2
Web Site - www.manitowocice.com Rev. 11/27/06
connects to the terminal board in the bottom ice machine.
is wired in series with the bin switch in the top ice machine.
in the top ice machine.
connected to the relay contacts.
wire used to be connected to).
Top Ice Machine
holes and insert
bushings
Page 2
8011463
Control
Board
TOP ICE MACHINE
Run
BOTTOM
ICE MACHINE
Harness - New Wire 6
Toggle
Harness - New Wire 4
47
Fan Cycle
Control
Fan
Motor
PTCR
45
R S
L2
48
52 85 86
51
Stacking
Kit Relay
0 1
49
STACKING RELAY KIT
New Connector
Bin Switch
Ground
Switch
Contactor
L1
Compressor
C
4 6
Capacitor
50
46
Sheet 2 of 2
Rev. 11/27/06
Loading...