Manitowoc Ice K00372 User Manual

Filler
Filler

.75” Wide Foam Tape

INSTALLER: It is

#10-24 x .50”L

Stainless Steel

.75” x 2.00”L Foam Tape

.75” Wide Foam Tape

Installation Instructions

The K00372 kit is used for installing Q-1400 or Q-Dual ice machines on a B-970 bin.
(Refer to Sheet 2 of 3 for pre-installation instructions.)

1. Note: Bin must be level before installation of ice machine.
A. Remove the foam tape from the front and sides of the bin where the stainless support/deflector will be located.

Use the support to reference the areas where the tape should be removed.

B. Place the support on the front edge of the bin and position as far forward as possible.
C. Locate the four pieces of the 2” long, 3/4” wide foam tape in the front corners, as shown.
D. Place the fillers on the bin, as shown. Make su re the two holes from the stainless support/deflector and fillers are

aligned on the side.

E. Using the fillers as templates, drill three 5/32” (4 mm.) holes, .500” (12.7 mm.) deep maximum, in the bin.

Warning: Do not drill through the interior liner. Attach each filler with three 10-24 x .500” screws provided.

F. Apply foam tape to the front and back of the bin between the fillers. Note: All other required foam tape comes

preassembled with the stainless support/deflector and fillers.

G. Note: It is recommended to RTV intersections and along the inside edge of the foam tape to prevent water

tracking.

2. Refer to ice machine installation manual for ice machine installation procedures.

Filler

K00372 ADAPTER KI T

Screws Typ

Support/Deflector

Typ both front corners

recommended to RTV
intersections and along inside
edge of foam tape to prevent
water tracking

Plastic Deflector

Plastic Deflector
Screws

See Detail B

Detail B

Manitowoc Ice, Inc.

2110 South 26th Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA 8016283
Telephone [phone], Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 Shee t 1 of 3
Web Site - www.manitowocice.com 11/22/04

Pre-installation Instructions for Removal of Existing Plastic Deflector

1. Remove the left and right side cover screws (see View A).

2. Remove the cover to expose the four screws that secure the plastic deflector (see Detail B).

3. Take out the four screws. Remove the plastic deflector, rep lace with a polymer spacer on each side and secure with

the four screws.

4. Reinstall the cover and proceed with the installation instructions.

Cover

Cover Screw

View A