Manitowoc Ice K00365 User Manual

ICE

MACHINE

BIN

Adapter

Wide Foam Tape

17” of

5” of

20” of

5” of 17” of

30” of

K00365 ADAPTER KIT

Installation Instructions

1. The K00365 kit is used for installing a Q-0320, Q-0370, Q-0420, S-0322, S-0422 ice machine or a QC/QF flaker on a

B or S-Series 30” (76cm) wide bin or a Q-Series 30” (76cm) wide dispenser.

2. Installation (bin or dispenser must be level before starting): A. Remove existing foam tape from top of bin or dispenser. When installing a K00365 on a Manitowoc dispenser,

remove the gray side trim pieces on the top sides of the dispenser.

B. Place support angle on bin or dispenser, as shown, prior to adapter installation. Locate foam tape from kit in the

positions on top of bin, as shown. Note locations of narrow and wide tape.

C. Place adap ters on bin or dispenser, as shown. Make sure th e two holes from the support angle and adapters are

aligned on the side.

D. Using the adapters as templates, drill three 5/32” (4mm) holes, .500” (12.7mm) deep maximum, in bin or

dispenser. Warning: Do not drill through interior liner. Attach with 10-24 x .500” screws provided.

E. Apply foam tape to the edge of the adapters. Note: It is recommended to RTV intersections and along front

inside edge of foam tape (see drawing) to prev ent water tracking.

3. Refer to ice machine installation manual for ice machine installation procedures.

Wide Tape

Narrow Tape

(from Kit)

2” of

Wide Tape

Support

Angle

Wide Tape

Narrow Tape

2” of

Wide Tape

Manitowoc Ice, Inc.

2110 South 26th Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 801609 Web Site - www.manitowocice.com 07/20/04