Manitowoc Ice K00117 User Manual

K00117 ADAPTER KIT

Installation Instructions

1. Use the K00117 to install a 22" B, J, Q, S, and Flaker/Chip ice machines on a Manitowoc C-730 bin.

2. Installation (bin to be level before starting):
A. Remove the hinge on the right and left side of the bin.
B. Remove the foam tape on the right and left rail. Trim back the foam tape on the front and rear bin rails, as

shown.

C. Position the adapter panels and hinges on bin and fasten with the four existing hinge screws.
D. Using the adapters as templates, drill four 5/32” (4 mm.) holes, .500” (12.7 mm.) deep maximum, in the rear of

the bin (adapters must be level with bin). Warning: Do not drill through interior liner. Attach with the
screws provided.

E. Apply foam tape to the edge of the adapters, as shown. Note: We recommend using RTV at intersections and

along front inside edge of foam tape to prevent water tracking. Use double thickness with S-series ice
machines.

3. Refer to ice machine installation manual for ice machine installation procedures.

22.00"

Ice
Machine
Back

Trim back existing
foam tape 11 3/16”
from outer edge of bin
(four places)

Existing two
screws

Hinge

Bin

Manitowoc Ice, Inc.

2110 South 26th Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA
Telephone [phone], Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 8009133
Web Site - www.manitowocice.com Rev. 05/06/04

Existing two screws

Hinge

Foam tape from kit - (trim to
fit) two places - double tape
thickness, when used with
S-series ice machines

Screws from kit

Drill two 5/32” dia.
holes each side (use
adapter as a template to
locate holes on bin)

Important

Do not drill through
the inside of the bin
liner - only through
outer metal.