Manitowoc Ice K00105 User Manual

K00105 ADAPTER KIT

Installation Instructions

1. Use the K00105 to install 22” B, J, Q, or S-series ice machines on a Manitowoc C-170, C-400, C-470, or C-570 bin.

2. Installation (bin to be level before starting):
A. Remove the hinge on the left side of the bin.
B. Remove the foam tape on the left rail. Trim back the foam tape on the front and rear bin rails, as shown.
C. Position the adapter panel and hinge on bin and fasten with the two existing screws.
D. Using the adapter as a template, drill three 5/32” (4 mm.) holes, .500” (12.7 mm.) deep maximum, in the rear of

the bin (adapter must be level with bin). Warning: Do not drill through interior liner. Attach with the screws
provided.

E. Apply foam tape to the edge of the adapter, as shown. Note: We recommend using RTV at intersections and

along front inside edge of foam tape to prevent water tracking. Use double thickness with S-series ice machines.

3. Refer to ice machine installation manual for ice machine installation procedures.

Trim Back Existing Foam Tape

8 11/16”

Double Thickness of Tape

with S-series

Manitowoc Ice, Inc.

2110 South 26th Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA
Telephone [phone], Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 8008913
Web Site - www.manitowocice.com Rev. 05/12/04

Ice

Machine

Back

Existing two

Screws

Hinge

Foam Tape from Kit (trim to

fit) - Double Thickness of

Tape with S-series

Screws from Kit

Drill three 5/32” dia.

Holes (use Adapter as a

Template to Locate Holes

on Bin)

IMPORTANT

DO NOT DRILL THROUGH

THE INSIDE OF THE BIN

LINER - ONLY THROUGH

OUTER METAL